User Manual
Page 5
... top cover and the base must always be kept under the PCB. Space should be kept around the drive to avoid any contact with 0.3N-m (3kgf-cm) torque. Placing Hard Drive inside the drive at a certain level Do not apply any force to the top cover, except the screw areas on ...into an unused PC/AT 16 bit slot (if required). • Install the I/F cable to the system's 44 pin connector port or adapter board. Installation Notes The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion. In order to prevent short-circuit...
... top cover and the base must always be kept under the PCB. Space should be kept around the drive to avoid any contact with 0.3N-m (3kgf-cm) torque. Placing Hard Drive inside the drive at a certain level Do not apply any force to the top cover, except the screw areas on ...into an unused PC/AT 16 bit slot (if required). • Install the I/F cable to the system's 44 pin connector port or adapter board. Installation Notes The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion. In order to prevent short-circuit...