TASCAM DA-45HR Support and Manuals
Get Help and Manuals for this TASCAM item
View All Support Options Below
Free TASCAM DA-45HR manuals!
Problems with TASCAM DA-45HR?
Ask a Question
Free TASCAM DA-45HR manuals!
Problems with TASCAM DA-45HR?
Ask a Question
TASCAM DA-45HR Videos
TASCAM DA-45HR DAT RECORDER: Reparación Mech-Com Error.
Duration: 7:07
Total Views: 80
Duration: 7:07
Total Views: 80
Set Dat (Tascam DA-45HR + Sony DTC-A6 + Behringer DEQ 2496 + Gradiente P-1 + Gradiente A-1)
Duration: 4:47
Total Views: 82
Duration: 4:47
Total Views: 82
Tascam DA-45HR high resolution DAT recorder. Broken power supply?
Duration: 34:44
Total Views: 2,367
Duration: 34:44
Total Views: 2,367
Tascam DA-45HR High Resolution 24bit professional DAT recorder repair.
Duration: 47:34
Total Views: 6,030
Duration: 47:34
Total Views: 6,030
Popular TASCAM DA-45HR Manual Pages
Owners Manual - Page 2
...with the following code:
GREEN-AND...instruction manual, may cause radio interference in diesem Fall kann vom Betrieber verlang werden, angemessene Maßnahmen durchzuführen und dafür aufzukommen.
2 TASCAM DA-45HR...Part 15 of this apparatus may be sure to take adequate measures. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used...
Owners Manual - Page 3
... product and cart combination to . 11) Power Sources - TASCAM DA-45HR 3 All operating and use liquid cleaners or aerosol cleaners. This product should use . ... This product may cause hazards. 7) Water and Moisture - This is operated. 2) Retain Instructions - Example of these Instructions for service. 21) Replacement Parts - An outside antenna or cable system is connected...
Owners Manual - Page 4
...to location memories ........ 25 4.6.2 Setting location memories 25 4.6.3 Editing location memories 25 4.7 Program mode 26 4.8 Character editing (titling 26 4.8.1 Entering and editing titles 26
4 TASCAM DA-45HR Parts of the tape deck
2.1 Power and display 10 [1] POWER switch 10 [2] Cassette tray and OPEN/CLOSE button 10 [3] Display window 10
2.2 Recording mode and source switches, etc...
Owners Manual - Page 6
... be displayed as "the tape deck". Introduction to the DA-45HR
The DA-45HR Digital Audio Tape (DAT) deck is used a DAT recorder before, here are a few items of the tape using the supplied rack mounting screws. The index should not be located near any strong
magnetic fields (TV sets or monitors, speakers, etc.) The tape deck may fi...
Owners Manual - Page 7
... used as
TASCAM DA-45HR 7 You can only be loaded and unloaded when the tape deck is no need to prevent dust damage. NOTE There is switched on. Introduction to the DA-45HR
Fingerprints on a new blank tape from the start , allowing accurate positioning within the tape. Always store DAT cassettes in their use, as illustrated below:
NOTE Start recording...
Owners Manual - Page 10
...recordings using digital audio connections from the way in the tray when it will be shown (not flashing). WARNING There must be set to describe part of a recording...button
Always load DAT cassettes in ...
10 TASCAM DA-45HR
The less...manual, we use the term "program" to INT when digital recording is explained in a digital audio system.
Other indicators in analog tape recording...
Owners Manual - Page 11
... capable of receiving SPDIF format input, and the RCA COAXIAL connectors are from 01 to the DIGITAL position, this switch.
A tape which the tape was recorded and adjusts accordingly. When making analog recordings. The recording can cause problems when searching and locating, and this should be unused. TASCAM DA-45HR 11
Owners Manual - Page 12
... source works at either of the tape transport, recording modes, etc. 2 - Parts of the tape deck
[9] ANALOG INPUT selector switch When the INPUT switch [7] is set to ANALOG, this case. The audio portion of the data recorded on a DAT cassette is set to the CAL position, or when recording from analog sources with analog sources which must...
Owners Manual - Page 15
...settings. The frames used...This means that when recording, a START ID will automatically be replaced by successive title contents...recording subcode (START, SKIP, END IDs and CHAR title information), it may be out of play mode. Parts...Error mode) cycle through the different options available in the display to indicate this. TASCAM DA-45HR 15 The options available, which will have been recorded...
Owners Manual - Page 16
...SINGLE PLAY.
[32] SHIFT
This key is set using the CLOCK switch [4] set in the menu, pressing this key will locate ...display will stop . If a pre-roll time has been set to a suitably-equipped controller.
Parts of the display (frames, program numbers and margin will ...voltage 15 V and maximum allowable current 80 mA)
16 TASCAM DA-45HR If the tape is playing when this connector can also be...
Owners Manual - Page 17
... trimmer beside each connector can be used to connect the optional RCD45 remote control unit. TASCAM DA-45HR 17 The wiring of these connectors is less than 50 kΩ.
[41] UNBALANCED ANALOG outputs
These RCA connectors provide unbalanced outputs at a nominal +4 dBu level.
Parts of these connectors is used to set to the tape deck. Make sure...
Owners Manual - Page 19
... are used to the SCMS system implemented on consumer DAT recorders.
The default value is 24bit.
3.8 Dither
Dither
off .
3.9 Copy prohibit
Sets the level of the recorded material....used if the internal D/A convertors are : No WR (no effect if dithering is selected, and 16-bit output word length is made in the subcode of copy protection for using this manual.
TASCAM DA-45HR...
Owners Manual - Page 23
...part of the above ID modes is write-protected, the message Rec
Protect will be erased • CHAR ERASE- While the ID is recording...RECORD indicators will be erased • SKIP ERASE-
TASCAM DA-45HR 23 a START ID will both light while the ID is pressed.
4.4.2 Manually...in possible future operational problems.
4.4.3 Writing a ...Use the INS/+ and DEL/- they may start to be used...
Owners Manual - Page 31
... has previously been recorded using the DA-45HR
6.5.2 Serious error messages
Any of the following error messages indicates a serious error, which you should never see in a complex path around delicate mechanical parts of error message: warning (informational) and more than 0.1% outside the standard sampling frequency and cannot be able to a qualified service technician, as an...
Technical Documentation - Page 1
... tools to re-press DVDs or some other DAT recorders.
The DA-45HR offers full compatibility with other locked, closed end format. SPECIFICATIONS
Performance Specifications:
Tape Speed:
SP - 8.15mm/s; In .... HR - 16.3mm/s
Recording Time (120 DAT): SP - 120 minutes; A full audio I /O • Word Sync In/Thru • Supports Track Names in DAT Subcode
• Two Memory Locate...
TASCAM DA-45HR Reviews
We have not received any reviews for TASCAM yet.