Seiko 7K32 Support and Manuals
Get Help and Manuals for this Seiko item
Popular Seiko 7K32 Manual Pages
Manual - Page 1
2ஸ15 ൪1߸ɹ˟104-8331
7K32
A27-0011
7K32
INSTRUCTION
Manual - Page 27
... WATCH OPERATION
50
˙DISPLAY AND CROWN OPERATION
51
˙TIME SETTING
52
˙HOW TO SET THE ALARM HANDS
57
˙BAROMETER HAND POSITION ADJUSTMENT
59
˙HOW TO SET...YOUR WATCH
86
˙LUMIBRITE
90
˙TROUBLE SHOOTING
91
˙HOW TO USE THE DIVER ADJUSTER
92
˙REMARKS ON AFTER-SALES SERVICING
93
˙REMARKS ON REPLACEMENT PARTS
93
˙SPECIFICATIONS
93...
Manual - Page 28
...FEATURES
ɾSEIKO Cal.7K32 is a multi-function analogue watch equipped with other hands. When you
travel abroad, the times of places you can know the maximum altitude using the altimeter ...ɾThe watch operation.
It can also be
set to the normal position. For details, refer to the corresponding sections of
the instruction manual.
[Time setting, alarm hand setting and adjustment of...
Manual - Page 34
... between
the two cities. ɾAs the hour hand indicates the time on the watch by turning the hour hand only.
ɾThe alarm hour hand can be adjusted ...step (3) in 30-day month or February.
(1) Pull out crown "1" to the first click.
(2) Turn crown "1" counterclockwise to set the date and moon phase between
N
" -5 *
I1
B
9:00 PM and 1:00 AM. Ex...
Manual - Page 36
... of 5*5"/*6. If you set the time you have set.
(3) At the designated time, the
alarm will ring for reminding you visit. day. (It is set on
the
watch,ʷI1B
and, therefore...the current time.
(2) Press button A to set to indicate
the current time.
Set crown "2" at the normal position. ˙ HOW TO USE THE ALARM (The alarm can be set on a 12-hour basis in one minute ...
Manual - Page 38
...it at 10-minute intervals. ɾTo know the current atmospheric pressure, the watch can also be obtained on the basis of the atmospheric pressure measured.
ʪ...watch can be set to measure it will ring when the alarm hands indicate "7:00". Newly set the alarm if reguired.
˙HOW TO USE THE BAROMETER
ɾThe watch is equipped with an atmospheric pressure sensor. ɾThe watch...
Manual - Page 39
... "How to recall the minimum atmospheric pressure".)
ʪHow to recall the minimum atmospheric pressure/maximum approximate altitudeʫ ɾThe watch measures the atmospheric pressure immediately. As button C is useful in a short time. ɾThe 5-second interval measurement mode can be started only by pressing button C.
After the measurement is shown...
Manual - Page 40
... altitude".)
˞When the watch is the result of time,...button B pressed. It is first used after purchased, a value of approximately 700hPa may be erased before
use. (Refer to "How to ...Set crown "1" at the normal
position.
N
" -5 * I1
ʷI1B
LAND MASTER 5*5"/*6.
"-"3.
Button C
Set...
Manual - Page 42
... and hold buttons B and C at two-second intervals to signal that case, replace the battery with a new one, it , the barometer cannot make this will cancel...watch is used under water where some water pressure is removed.
(4) When the small second hand moves at the same time for more than 1,050hPaʫ
(3) If the watch was purchased or an authorized SEIKO dealer.
(6) When the time is set...
Manual - Page 44
... 5 minutes a day and/or if you have the battery replaced by a SEIKO DEALER.
/05&40/5)&#"55&3: (1)Battery life
A new normal battery will... , however, remain accurate while the second hand is moving in two second intervals instead of the watch will last approximately two years. ˞However, if the alarm is used...
Manual - Page 45
... return to the initial settings.
The barometer adjustment made will be canceled and the barometer will be erased. 2. (3)Notes on battery change
When the battery is replaced with the SEIKO watches.
˙1&340/"-%"5"
... from the memory and the watch was purchased or an authorized SEIKO dealer and request the battery for exclusive use with a new one, or when it is replaced. 1.
Manual - Page 46
...instruction manual. (Refer to "TIME SETTING".)
When button C is pressed to "Notes on the battery change: It takes 3 hours after the battery is changed or the IC is replaced with a new one, or the watch...reset the IC 1.
Press buttons B and C at the same time. Before using the watch will be reset and the watch , adjust the time, barometer hands and alarm hands by following the procedure. ...
Manual - Page 48
... during daytime) [Fine weather]: more than 1,000 lux (C) Lighting apparatus (40-watt daylight fluorescent light) [Distance to the watch: 1 m]: 1,000 lux [Distance to the watch: 3 m]: 500 lux (average room luminance) [Distance to the watch: 4 m]: 250 lux
90 Please note, however, that absorbs the light energy of the light decreases gradually over time. LumiBrite...
Manual - Page 50
...SFBEZSFGFSFODF
˙3&."3,40/3&1-"$&.&/51"354
ŋ SEIKO makes it was purchased when having them repair your watch is considered repairable may vary greatly depending on the conditions under which are not available.
94 We recommend, therefore, that a watch .
ŋ The case, dial, hands, glass and bracelet, or parts thereof may not be replaced with substitutes if the originals...
Manual - Page 51
... of atmospheric pressure ʷ 3.0%ʴ4hPa)
ɾMeasurement error under a temperature change indicator. Operational temperature range 10°Cʙʴ60°C for the watch operation
0°Cʙ40°C for product improvement.
95 Alarm display Alarm hour and minute hands Alarm can be set on a 12-hour basis in minutes.
6. Frequency of...
Seiko 7K32 Reviews
We have not received any reviews for Seiko yet.