Samsung DVE50R5400W/A3 Support and Manuals
Get Help and Manuals for this Samsung item
View All Support Options Below
Free Samsung DVE50R5400W/A3 manuals!
Problems with Samsung DVE50R5400W/A3?
Ask a Question
Free Samsung DVE50R5400W/A3 manuals!
Problems with Samsung DVE50R5400W/A3?
Ask a Question
Popular Samsung DVE50R5400W/A3 Manual Pages
User Manual - Page 4
... your nearest service center or find help and information online at www.samsung.com.
These warning signs are here to prevent injury to safely and efficiently operate the extensive features and functions of your dryer. After reading this manual and not all warning signs may occur. Warnings and Important Safety Instructions in this manual, store it...
User Manual - Page 8
... appliance. These objects could damage your dryer. • Gas leaks may not be detected by smell alone. • Gas suppliers recommend you purchase and install a UL-approved gas detector. • Install and use in accordance with controls. • Do not repair, replace, or attempt to service any part of the appliance unless
specifically instructed to in a dangerous situation. Cautions...
User Manual - Page 10
... through the following parts while the appliance is energized: Control board and inlet valve.
WARNING • Make sure to exhaust the dryer outdoors to prevent a child from water and weather. Key installation requirements
• A grounded electrical outlet. • A power cord for electric dryers (except in . (460 mm) above the floor for future reference. Service Personnel - Location...
User Manual - Page 18
Do not use an extension cord. Gas models - electric model dryers. if it doesn't fit the outlet, have a proper outlet installed by a qualified electrician.
• If a power cord is not used , the cord
should be found on the dryer. and Canada A 120 volt, 60 Hz AC approved electrical service with a 15-ampere fuse or circuit breaker is to be permanently wired...
User Manual - Page 19
Installation requirements
WARNING
Risk of the line is U.L. Canada Only A 120 / 240 volt, 60 Hz AC approved electrical service fused through the neutral conductor. (Use a 4-prong plug for use with tinned leads. • Do not reuse a power supply cord from
an old dryer. The power cord should be supported at a minimum of 120 / 240 volts, 30-amperes with three...
User Manual - Page 25
... homes, or if local codes do not permit grounding through the hole provided in the cabinet near the terminal block.
• A strain relief must be damaged. STEP 4 Connect the water hose
The dryer must be used. Installation
Untitled-16 25
English 25
2020-07-14 3:36:16 Insert the power cord with a UL-listed strain...
User Manual - Page 29
... floor. • The dryer starts, runs, heats, and shuts off and wait 5 minutes. To confirm gas ignition, check the exhaust for gas models)
Make sure all gas connections, the exhaust line, and all wiring is sitting firmly on a heat setting will purge the line. STEP 6 Power on .
Then, plug the power cord into an electrical outlet...
User Manual - Page 30
... any blockage or problems. Proper ducting can turn off . The Vent Blockage Test starts immediately. If the dryer warms up after the test, the internal drum is cool. For description about 2 minutes. The results remain on the display for about the code, see the "Installation check codes" section on page 31. Press the Power button to...
User Manual - Page 32
...
Tape all old ducts before installing the dryer, and make sure the vent ...dryer connection. Put a soft rug on the floor to clean the exhaust system annually or on after you contact a qualified technician. 1. Unplug the power cord... of any kind. • Do not use plastic, thin-foil, or non-metal flexible ducts of the dryer... the dryer's performance. • Do not ...
User Manual - Page 49
... spills or overspray immediately. Be careful not to ensure proper air flow.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of the dryer. • The dryer has a high-gloss finish on the entire surface. Dryer exterior • Clean with a mild, non-abrasive cleaner suitable for best performance and to the...
User Manual - Page 50
...power cord is on , the dryer performs an air dry process in the table below and try the suggested actions. Check the selected
cycle again. • For a gas dryer, make sure the gas supply is plugged into the cool-down phase of problems...or fuses. • Some cycles do not require heating. Troubleshooting
Checkpoints
If the dryer operates abnormally, first check the list of
the cycle. &#...
User Manual - Page 55
Specification
Untitled-16 55
English 55
2020-07-14 3:36:26
Remove the door so that the appliance cannot be connected to dispose of this appliance, please observe local waste disposal regulations. Cut off the power cord so that animals and small children cannot get trapped inside the appliance. If you decide to a power source...
User Manual - Page 56
Specification
Specification sheet
Type
Capacity (Cu.ft)
Water pressure (psi (kPa))
Weight
lb (kg)
Heater rating
Electric (W) Gas (BTU/hr)
Power consumption (W)
Front loading dryer 7.4
20-116 (137-800) 119.0 (54.0) 5300 20000 5400
Specification
56 English
Untitled-16 56
2020-07-14 3:36:26
User Manual - Page 57
... the original consumer purchaser, is warranted by a SAMSUNG authorized service center. To receive in-home service, product must return them to SAMSUNG.
Replacement parts and products are the property of SAMSUNG and you may use new or reconditioned parts in repairing a product, or replace the product with the product. All replaced parts and products are warranted for the remaining portion...
User Manual - Page 58
... use of this product and shall not cover the following: damage that occurs in -home instruction on how to use of equipment, utilities, services, parts, supplies, accessories, applications, installations, repairs, external wiring or connectors not supplied or authorized by SAMSUNG; cosmetic damage including scratches, dents, chips, and other acts of these excluded circumstances shall be...
Samsung DVE50R5400W/A3 Reviews
We have not received any reviews for Samsung yet.