Ryobi RY80533 Support and Manuals
Get Help and Manuals for this Ryobi item
This item is in your list!
View All Support Options Below
Free Ryobi RY80533 manuals!
Problems with Ryobi RY80533?
Ask a Question
Free Ryobi RY80533 manuals!
Problems with Ryobi RY80533?
Ask a Question
Popular Ryobi RY80533 Manual Pages
User Manual - Page 8
... instructions. SPECIFIC SAFETY RULES
Use caution when positioning the pressure washer for use cold water.
Make sure minimum clearance of 3 feet is running (except where specifically ... industrial grade solutions in serious personal injury.
For outdoor use only identical replacement parts. Failure to the machine.
Always operate the machine on an incline, ...
User Manual - Page 11
...
The trigger handle has a gripping surface that provides added control of the pressure washer. Maximum Pounds Per Square Inch Pressure*...2,800 psi Maximum Gallons Per Minute*...2.3 gpm Maximum Inlet Water Temperature...104˚F Spark Plug...Torch/LG F6TC *Max.
FEATURES
PRODUCT SPECIFICATIONS
Fuel Tank Capacity...0.66 gal. FUEL TANK
This fuel tank has a maximum...
User Manual - Page 12
...Disposable Funnel Handle Operator's Manual
WARNING:
If any parts on the high pressure hose into the trigger
handle inlet coupler by the manufacturer and require customer installation.
n Push and hold...the trigger handle. PACKING LIST
Pressure Washer 25 ft. NOTE: Before use . ASSEMBLY
UNPACKING
This product requires assembly. CONNECTING THE HIGH PRESSURE HOSE TO THE PUMP
See Figure...
User Manual - Page 13
... If the screen is dirty, clean it is usually permitted.
NOTICE:
Do not run the pressure washer without water supply connected and turned on the hose to prevent kinks. English
NOTICE:
Always observe...the screen has been replaced.
NOTE: Be careful to avoid cross-threading, which can cause the hose to prevent the feedback of the garden hose to the pressure washer. Some areas have ...
User Manual - Page 14
...pressure washer on a flat, level surface.
n Replace the oil cap/dipstick and securely tighten. Do not tilt. n Remove dipstick again and check lubricant level. n Replace... n Place pressure washer on a flat, level surface.
The use this tool. Contact customer service to the ... dipstick. Fuel system damage or performance problems resulting from testing. APPLICATIONS
You may cause...
User Manual - Page 15
...instructions could be hot enough to the pressure washer. Remove the fuel cap. n Replace fuel cap and tighten until a steady stream of cleaning is not being restricted by muffler and exhaust gases could result in serious personal injury. from the muffler. Failure to the pressure washer... control and safety, keep at all body parts, clothing, combustible materials, and hoses away ...
User Manual - Page 16
...on the lock out until it from the trigger handle once the cleaning job is complete: n Turn off the pressure washer and shut off the water
supply. NEVER point the nozzle at your face or at others. To connect a... n Push the nozzle into the slot. Refer to the Nozzle Selection Guide for more information about which nozzle to follow these instructions could eject the nozzle with some force.
User Manual - Page 17
... or other brands, follow the instructions provided by calling customer service. n Remove the cap from hot surfaces and sharp edges. NOTE: The machine setting of this unit is designed for...of the machine.
Check your pressure washer, or by the manufacturer. n Shut off the water supply. n Remove the nozzle by high pressure hose.
The instructions below are for more information....
User Manual - Page 18
... to stop the unit
immediately. OPERATION
MOVING THE PRESSURE WASHER
See Figure 18. WARNING:
Before inspecting, cleaning or servicing the machine, shut off engine, wait for equipment operating in serious personal injury or property damage.
n Inspect the work area for important information regarding these instructions can damage, weaken or destroy plastic which could...
User Manual - Page 19
... contact with lubricant following the instructions in Adding/ Checking Engine Lubricant earlier in this manual or the accompanying engine manual, if applicable. For amount of engine lubricant to an authorized service center for proper washer compression.
CHECKING SPARK PLUG
See Figure 22. Remove spark plug. For replacement spark plug, see Product Specifications earlier in serious burns...
User Manual - Page 20
... regulations will give you more detailed instruction on proper disposal.
2 If water inlet filter is missing or damaged, it to clean lubricant from cylinder head3
X
Check & adjust valve clearance3
X
1 Initial lubricant change should remove most of this pressure washer, please follow the maintenance schedule provided in the operator's
manual. Do not allow the hose...
User Manual - Page 21
... pressure nozzle installed
Replace with high pressure nozzle
Inadequate water supply
Provide adequate water flow
Trigger handle or spray wand leaks
Check connections and / or replace trigger handle or spray wand
Nozzle is clogged
Clean nozzle
Air in line
Squeeze trigger on trigger handle to remove air from spark plug
Ignition inoperative
Contact authorized service center...
User Manual - Page 22
... Industries North America, Inc., warrants to the original retail purchaser that this RYOBI® brand pressure washer is free from defect in material and workmanship and agrees to repair or replace, at www.ryobitools.com.
Any part of any ) supplied with the RYOBI® brand pressure washer or adversely affect its intended use ;
90 days, if any...
User Manual - Page 23
..., valves, valve guides, carburetor, or other warranty or to assume any warranty claim and that the engine or the part or parts claimed to be ...replacement of a component or an engine. Any engine that has been installed, repaired, or altered by it will be promptly delivered, transportation prepaid, to such Distributor or Service Center for a period listed below from the date of engine parts...
User Manual 2 - Page 1
... page 8).
3 Connect the high pressure hose to relieve air pressure. Completely uncoil garden hose or remove completely from pressure washer, reattach it here.
Make sure there are no nozzle installed, squeeze the trigger to the trigger handle (see page 11). Completely uncoil and straighten high pressure hose to the operator's manual. DO NOT OVERTILT THE UNIT...
Ryobi RY80533 Reviews
Do you have an experience with the Ryobi RY80533 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Ryobi yet.
Earn 750 points for your review!