RCA RSWW1 Support and Manuals
Popular RCA RSWW1 Manual Pages
Warranty Card - Page 1
...interference to assume for parts and repair labor.
No person... pas installé et utilisé conformément aux instructions, peut...and does not cover product purchased, serviced or used in the opinion of...REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT.
This Warranty gives you specific...
Installation Manual - Page 2
Simply install the control unit, smart module, and shut-off servo motor
with connection wire attached
(2) Servo pipemounting... provide an additional electrical outlet if needed
Automatic shut-off servo motor included in the package? Welcome! This installation guide takes you 're set to get set up.
What's in this package, and you through the steps to stop a disaster before it happens! ...
Installation Manual - Page 3
...strength where you plan to mount the smart module-make sure your WiFi router closer (or installing a WiFi signal booster close to install. The location of this pipe varies, but it's usually near the top of your WiFi... network's signal where you plan to the installation).
3 If not, try moving your phone is on the cold water pipe going into the water...
Installation Manual - Page 4
...
tape YangZhiQiang
(included, 2018/03/27
not for masonry MODI-IOT 67630551460G A
applications)
1. MAC : 70F8E7262881
Smart Module MAC Address
36.0mm
Serial number GMA252V13F0001
GMA25:Model code(MOD1-IOT)Assigned by AEC 2 V: Manufactured year(V=2018,skip I,O,S,Z) 13: Manufactured week F:
GMA252V13F0001~GMA252V13F0100
SN: GMA252V13F0001
CAN ICES-3(B)/NMB-3(B)
MADE IN CHINA
D. Mount...
Installation Manual - Page 5
.... 4. Leave some space between the screw heads and the wall so that you can mount the control unit and/or smart module on the screws. 5. Install the dry-wall anchors at each x for the anchors.
3. Leave some
space between the
screw heads and the wall so that you can mount the...
Installation Manual - Page 6
... 2: Assemble the Servo ring & brackets
A. Insert a short carriage bolt through the bracket and servo slot. The brackets should be mounted on the servo, shown here.
Install the brackets on the shut-off servo
Find the following pieces in place. Place a flat washer, lock washer, and wing nut on the end of...
Installation Manual - Page 8
... motor
Shut-off valve
Carefully place the servo and brackets over the center of the the servo motor and shut-off valve aligned throughout the installation and make sure they're aligned when you 've finished opening it and closing the valve loosens this build-up (like mineral deposits) around the...
Installation Manual - Page 9
If it doesn't, replace it ! Centering ring
3. Then put the small washer and Allen-cap screw back in the ...
Nut
Allen-cap screw.
2.
Tighten
with the larger centering ring provided in place. Remove the pre-installed (small) centering ring. Install the larger centering ring.
If not, replace it with the Allen wrench. Close the brackets over the pipe
Insert (1) M5 x 30 x 0.8(...
Installation Manual - Page 13
...
it as shown here. Line up the sensor and control unit
A. Then skip to step D on the lead you're trying to connect to.
2. Step 5: Set up the round and square plugs on each lead to the corresponding round and square holes on page 15. How to the shut- Simply connect...
Installation Manual - Page 16
... Water Shut-Off App to use is 2.4GHz, not 5GHz! • Make sure your phone
Search for setup! B. Step 6: Set up and stays in Setup Mode for 6 minutes.
Look for the icon shown here and install this step so that uses different networks for the two bands, make sure the
WiFi signal you notifications...
Installation Manual - Page 17
...plug it while you 're connecting multiple Smart Modules, wait for setup! Then press OK. D.
C. Then start the App again. ...network you want to use, quit the App, go to the network settings for your phone, and connect to the network you 've entered the...WiFi network, the App starts searching for your network name and password-these must be correct to your Smart Module.
If the Link...
Installation Manual - Page 18
... you want to verify that it again.)
Configure accesses other setup options.
Step 6 (continued)
E.
Search looks for your phone's alert settings so that appears (check the MAC address shown against the ...address you choose a different name for Smart Modules in the next screen. The App finishes setting up the Smart Module with your WiFi network and displays a sample alert to use from ...
Installation Manual - Page 20
... Alarm Off button again. Note: The pressure-release output pipe sensor activates the alarm after detecting water leakage for 10 seconds only.
You can also set the audible alarm to sound for 1 minute continuously. The green light comes on the control unit.
To stop the audible alarm: Press the Alarm Off...
Installation Manual - Page 21
App Notifications Guide
If your phone says...
"Device has been triggered. "Device has re-connected to WiFi"
Your smart ...the valve when finished.
Your sensor has detected water and automatically shut the valve. Please call our toll-free customer service hotline at 1-800-645-7750
© 2018 Voxx Accessories Corp. 3502 Woodview Trace, Suite 220 Indianapolis, IN 46268
21
Questions? ...
RCA RSWW1 Reviews
Do you have an experience with the RCA RSWW1 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for RCA yet.
Earn 750 points for your review!