Pyle PLMRL50WB Support and Manuals
Get Help and Manuals for this Pyle item
This item is in your list!
View All Support Options Below
Free Pyle PLMRL50WB manuals!
Problems with Pyle PLMRL50WB?
Ask a Question
Free Pyle PLMRL50WB manuals!
Problems with Pyle PLMRL50WB?
Ask a Question
Popular Pyle PLMRL50WB Manual Pages
Instruction Manual - Page 2
... sure everything is not large enough, carefully cut it until the problem is available at electronics stores and car audio specialists, check the installation kit before using it ts the board. 4. If the unit... as not to
remove it slips easily on again and play around with the stereo and its settings to a 12 Volt power source with adequate ground. 6. Completely insert it to the opening in...
Instruction Manual - Page 3
... icon. You are ready to use your contact list. • Now you to access SIRI or GOOGLE voice via Wireless BT. • Your phone must support SIRI or GOOGLE voice. WIRING CONNECTIONS
PRECAUTION +12V DC NEGATIVE EARTH
SWC
EXternal MIC
Antenna Jack SUBWOOFER SUBWOOFER
Front RCA Output(Left)
FUSE 15A
Rear...
Instruction Manual - Page 5
...; Press the Volume knob and Rotate to select SW Level/Manual EQ/Q factor/ Preset EQ/Bass boost/Loudness/Subwoofer set/Fader/Balance/X'Over/DTA Setting/Car type. • Press and hold Volume knob to switch...the VOL+ /VOL- Q FACTOR Press the Volume knob and Rotate to select Bass boost level. MANUAL EQ Press the Volume knob and Rotate to select Audio/Display/Tuner/Clock/Beep/ Animation/Demo mode ...
Instruction Manual - Page 6
SUBWOOFER LPF Press the Volume knob and Rotate to setting ON Time/OFF Time. DIMMER • Press the Volume knob and Rotate to select ON/OFF/... to select Frequency/Gain. FRONT HPF Press the Volume knob and Rotate to select Frequency/Gain left/Gain right. DTA SETTING Press the Volume knob and Rotate to select Color Select/Spectrum/ID3 tag/ Version/Dimmer.
DISPLAY Press the Volume knob...
Instruction Manual - Page 7
...ON/OFF. www.PyleUSA.com 7
VERSION Press the Volume button to rotate switch ON/OFF. MONO SET Press the Volume button to check software version.
LOCAL SEEK Press the Volume button to switch ON/... REGIONAL Press the Volume button to rotate to select Clock Format/Clock adjust/Date Format/Date Set. CLOCK Press the Volume knob and Rotate to select country regions.
ID3 TAG Press the Volume...
Instruction Manual - Page 8
...minutes. 6.
Loudness: LOUD ON/OFF Press the LOUD button on the remote control to set
the time. 4. Short Press to Increase Bass Level
Change the source mode (SRC)... the or button on the front panel or on the remote control to set the time, press and hold the CLK button and the time will start ashing. 3. Set the clock (CLK) 1. DSP SMART ANDROID/IOS APP CONTROL
Subwoofer Control
...
Instruction Manual - Page 9
... subwoofer, entry sw level, turn the knob to move to the next/previous available station automatically. Manual Tuning ( / ) Press and hold the or button on the front panel or on the remote..., entry sw frequency, turn the knob to reset all factory settings parameters, this function can be used to select level 0-8. In manual tuning mode, press the or button to select 80Hz/120Hz/160Hz...
Instruction Manual - Page 10
... In urban areas, most stations are strong enough and "LOCAL ON" mode should be selected. To Store/Recall Preset Stations The radio can store 6 pre-set stations for each band.
Instruction Manual - Page 14
Track down ; SEL (selection) button 6. CLK (clock setting) button,
(end call ) 4. INT (intro) button,
preset station 2 button, keypad 2 11. AMS (automatic music search) button,
keypad 9 18. MODE button, keypad 19. button: Tune down, ...
Instruction Manual - Page 15
...com 15 Re-insert the cell holder into the remote control. Replace the old cell with an insulating sheet attached to the underside of the remote control ...in the direction indicated by arrow 2.
3.
Replace Lithium Battery Cell 1. When the lithium cell battery becomes weak, replace it as illustrated on the
right.
2. Remove Insulating Sheet The remote...
Instruction Manual - Page 16
...not operating properly due to noise. Never try to repair the unit by yourself because it . Fuse is not...Vehicle's key to ACC or ON. 2. Cable is burnt.
• Replace fuse. 4. Remote Control Operation Position the emitting window of the remote control... the installation angle less than 30°.
Do not use the unit in micro-computer is wrong, immediately switch power o . TROUBLESHOOTING
If ...
Instruction Manual - Page 17
... stations of this receiver. 3. Connect the battery cable to download the PYLE App. USB Support: 64GB • Power: DC 12V • Current Consumption: 10A • Product Dimension: 4.5'' x 7.1'' x ...1.97'' - inches
www.PyleUSA.com 17 Scan the QR code to the terminal that is not connected.
• Insert the antenna cable firmly into the antenna ...
Pyle PLMRL50WB Reviews
Do you have an experience with the Pyle PLMRL50WB that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Pyle yet.
Earn 750 points for your review!