Pyle PLML51DB Support and Manuals
Get Help and Manuals for this Pyle item
This item is in your list!
View All Support Options Below
Free Pyle PLML51DB manuals!
Problems with Pyle PLML51DB?
Ask a Question
Free Pyle PLML51DB manuals!
Problems with Pyle PLML51DB?
Ask a Question
Popular Pyle PLML51DB Manual Pages
Instruction Manual - Page 2
...of dubbing tabs above, below and all you 've connected them correctly. INSTALL THE DEVICE 1. If the unit does not work, check the calibration ...measurement is not large enough, carefully cut it until the problem is plug the wiring harness back into the stereo and ...be switched on again and play around with the stereo and its settings to a 12 Volt power source with adequate ground. 6. Double ...
Instruction Manual - Page 3
... NAME)", the system will ask for access to talk. You are ready to access SIRI or GOOGLE voice via Wireless BT. • Your phone must support SIRI or GOOGLE voice. WIRING CONNECTIONS
PRECAUTION +12V DC NEGATIVE EARTH
SWC EXternal MIC
FUSE 15A
15A
Front RCA Output(Left)
Rear RCA Output(Left...
Instruction Manual - Page 5
... to select 2 way/3 way X'Over mode. AUDIO MODE • Press the Volume knob and Rotate to select SW Level/Manual EQ/Q factor/ Preset EQ/Bass boost/Loudness/Subwoofer set/Fader/Balance/X'Over/DTA Setting/Car type. • Press and hold Volume knob to select Balance position.
FADER Press the Volume knob and Rotate...
Instruction Manual - Page 6
....
CAR TYPE Press the Volume knob and Rotate to select custom R/G/B/ Variable Scan/Red/ Pink/Purple/Blue/Cyan/Green/Yellow/Orange.
6 www.PyleUSA.com
DTA SETTING Press the Volume knob and Rotate to select Frequency/Gain. FRONT HPF Press the Volume knob and Rotate to select Position/Distance/Gain/Data Reset...
Instruction Manual - Page 7
... knob and Rotate to rotate switch ON/OFF.
RDS SET Press the Volume button to select Clock Format/Clock adjust/Date Format/Date Set.
DEMO MODE Press the Volume button to select country ...button to check software version. VERSION Press the Volume button to select Local Seek/Mono Set/Regional/RDS Set.
ANIMATION Press the Volume knob and Rotate to rotate switch ON/OFF. BEEP Press the...
Instruction Manual - Page 8
...Press the or button on the front panel or on the remote control to set
the minutes. 6. Loudness: LOUD ON/OFF Press the LOUD button on the remote control to set
the time. 4. Press the CLK button and the minutes will start ashing....Level
Change the source mode (SRC) Press the SRC button to turn it o . To set the time, press and hold the CLK button and the time will start ashing. 3.
Instruction Manual - Page 9
... properly or if the sound is designed for devices with a small tip to six preset stations.
Manual Tuning ( / ) Press and hold the or button on the front panel or on the remote...function to select audio, entry subwoofer, entry sw level, turn the knob to reset all factory settings parameters, this function can be used to select 80Hz/120Hz/160Hz.
RADIO OPERATION
Change Bands (BAND)...
Instruction Manual - Page 10
... the radio on the remote control to MONO mode usually improves the overall sound quality. To Store/Recall Preset Stations The radio can store 6 pre-set stations for each band. To recall a preset station • Select the desired band. • Briefly press a preset button (numbered 1-6) to play les from a USB device...
Instruction Manual - Page 14
...,
keypad 4 13. -10 (previous 10 tracks),
preset station 5 button, keypad 5 14. +10 (next 10 tracks),
preset station 6 button, keypad 6 15. SEL (selection) button 6. CLK (clock setting) button,
(end call ) 4. INT (intro) button,
preset station 2 button, keypad 2 11. ST (stereo) button, keypad 7 16. LOC (local)/DX button, keypad #
14 www.PyleUSA.com...
Instruction Manual - Page 15
... as illustrated on the
right.
2. The remote control will not work until the insulating sheet is facing upward.
4. www.PyleUSA.com 15
Replace the old cell with an insulating sheet attached to the underside of the remote control in the direction indicated by arrow 2.
3. Press and hold the ...
Instruction Manual - Page 16
...the RESET button to restore the program to a desired level. 5. Adjust the installation angle less than 30°. Vehicle's engine switch is in mute or minimum....damage to ACC or ON. 2. Cable is burnt.
• Replace fuse. 4.
Never try to repair the unit by yourself because it . Fuse is not correctly connected....TROUBLESHOOTING
If you purchased it is more than 30°. 6.
Instruction Manual - Page 17
Select other stations of this receiver. 3. USB Support: 64GB • Power: DC 12V • Current Consumption: 10A • Product Dimension: 4.5'' x 7.1'' x 1.97'' - Preset ...; Single DIN Universal Size Standard • Night illumination: RGB • MAX. Scan the QR code to the terminal that is too weak.
Radio 1. Much noise in broadcasts.
• Station or signal is always live.
Pyle PLML51DB Reviews
Do you have an experience with the Pyle PLML51DB that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Pyle yet.
Earn 750 points for your review!