Poulan PR271 Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan PR271 manuals!
Problems with Poulan PR271?
Ask a Question
Free Poulan PR271 manuals!
Problems with Poulan PR271?
Ask a Question
Popular Poulan PR271 Manual Pages
Owner Manual - Page 1
... Not Throw Away
OWNER'S MANUAL
MODEL NUMBER:
PR271
SNOW THROWER
WARNING:
Read the Owner's Manual and follow all Warnings and Safety Instructions.
Always Wear Eye Protection During Operation
Gasoline containing up to do so can result in this machine. Failure to 10% ethanol (E10) is acceptable for ...
Owner Manual - Page 2
... the wire from the spark plug, disconnect the cord on electric motors, thoroughly inspect the snow thrower for this is not possible, then refuel such equipment on sidewalks, driveways and other foreign objects.
2. Never allow adults to a running (except when specifically recommended by the manufacturer for use a nozzle lock-open device.
(g) Replace gasoline cap securely and...
Owner Manual - Page 3
... 13
MAINTENANCE 13-14 SERVICE AND ADJUSTMENTS 15-17 STORAGE 18 TROUBLESHOOTING 19 REPAIR PARTS 20-41 ENGINE BREAKDOWN 42-43
3 exhaust fumes are present such as necessary.
5. Should you to operator's manual for and using your snow thrower properly. Always refer to assemble and maintain your snow thrower.
• Follow the instructions under "Maintenance" and "Storage...
Owner Manual - Page 7
... OPEN (RUN)
IGNITION KEY. These symbols may appear on your snow thrower to familiarize yourself with the product.
PULL OUT TO STOP
DANGER
DO NOT PLACE HANDS NEAR BLADES
DANGER, KEEP FEET AWAY
REMOVE SPARK PLUG WIRE BEFORE PERFORMING MAINTENANCE
DANGER READ OPERATORS MANUAL WATCH FOR THROWN OBJECTS OPERATE AT A SAFE DISTANCE FROM OTHER PEOPLE...
Owner Manual - Page 11
... the snow thrower.
• If snow thrower must be emptied before requiring replacement. FIG. 17
11
Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw tight, wait for additional information.
WARNING: Wipe off engine and wait for all moving skid plate to proper height for current surface conditions. See Storage Instructions for...
Owner Manual - Page 13
..., apply a small amount of this unit. Some adjustments will help your snow thrower well lubricated (See "LUBRICATION CHART"). Check for wear. Check controls to service this manual should be checked at least once each season.
• Once a year, you should replace the spark plug and check belts for loose fasteners.
3.
LUBRICATION CHART
➀ SAE 5w30 Motor Oil ➁...
Owner Manual - Page 14
... drain plug and placement of any maintenance. Check your snow thrower.
TIRES
• Maintain proper air pressure in the Service and Adjustments section of your engine oil level more freely when warm.
• Catch oil in contact with API service classification SG-SL. The belts are lifetime lubricated and require no lubrication. Replace belts if they begin to install...
Owner Manual - Page 15
... SHAFT
AUGER HUB
1/4-20 LOCKNUT
AUGER HUB AUGER SHAFT
FIG. 18
TO REMOVE BELT COVER (See Fig. 19) 1. Install 1/4-20 locknuts and tighten securely. IMPELLER SHEAR BOLTS
The impeller is in contact with your snow thrower.
4. Be sure the on/off switch is secured to the top of this manual. Remove safety ignition key.
3. Disconnect spark plug wire from spark plug. CHUTE...
Owner Manual - Page 18
... form and will cause problems.
• If possible, store your snow thrower indoors and cover it to rust. ENGINE OIL
Drain oil (with engine warm) and replace with new spark plug. IMPORTANT: Never cover snow thrower while engine/ exhaust area is to distribute oil.
4.
Rust and/or dirt in the Service and Adjustments section of this manual).
3.
Do not use...
Owner Manual - Page 19
...plug.
10. Reconnect spark plug wire.
2. Remove ice and snow on and around fuel tank cap. Engine idles or runs roughly
1. Move choke to spark plug.
9. Clean fuel line.
3. Loose parts or damaged augers or 1. Replace damaged parts. See "IF RECOIL STARTER HAS FROZEN" in the Operation section of this manual.
Clogged discharge chute.
1. Lights not On
1. TROUBLESHOOTING...
Owner Manual - Page 20
inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
20 REPAIR PARTS
SNOW THROWER - MODEL PR271 (96192009101)
AUGER HOUSING / IMPELLER ASSEMBLY
3 14
14 15 14
10
14
11 13
13 12 13
9 8 6
9
4 8
5
13 2
1
7
7
6 7
05.09.009-J
6
NOTE: All ...
Owner Manual - Page 21
... LOWER BRACKET INTERFACE BEARING BALL SCREW HEX HEAD 5/16-18 X 5/8 NUT FLANGE NYLOCK 5/16-18 LOWER AUGER BELT GUIDE
NOTE: All component dimensions given in U.S. MODEL PR271 (96192009101)
AUGER HOUSING / IMPELLER ASSEMBLY
KEY NO.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
PART NO.
501 14 96-01 586 60 72-02 587 40 24-01 585 05 69...
Owner Manual - Page 23
DESCRIPTION
3
1
532 42 04-78 AUGER BEARING
2
532 41 19-39 BEARING PLUG
3
584 29 94-01 SCREW HI-LO WASHD
5/16-14 X 1.00
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
23 REPAIR PARTS
SNOW THROWER - NO. MODEL PR271 (96192009101)
AUGER HOUSING / IMPELLER ASSEMBLY
1
05.09.039-A
2 3
KEY...
Owner Manual - Page 28
REPAIR PARTS
SNOW THROWER - PART NO. 586 18 10-01 581 12 81-03
532 19 41-89 581 92 87-01 532 18 37-84
DESCRIPTION
FLOOD HEADLIGHT CONSOLE COVER POULAN PRO...Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL PR271 (96192009101)
CONTROL PANEL / DISCHARGE CHUTE
2
1
3 4
KEY PART
NO.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
28 NO...
Owner Manual - Page 41
...OWNER'S MANUAL, FRENCH OWNER'S MANUAL, SPANISH
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
41 inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL PR271 (96192009101)
7
8
3
7
8
KEY NO.
3 4 7 8 - - - -
REPAIR PARTS DECALS
4
SNOW THROWER -
Poulan PR271 Reviews
We have not received any reviews for Poulan yet.