Poulan 2150PR Support and Manuals
Get Help and Manuals for this Poulan item
View All Support Options Below
Free Poulan 2150PR manuals!
Problems with Poulan 2150PR?
Ask a Question
Free Poulan 2150PR manuals!
Problems with Poulan 2150PR?
Ask a Question
Most Recent Poulan 2150PR Questions
Why Won't My Pollan 2150 Woodsman Start?
(Posted by chadnash16 2 years ago)
Where Is The Location Of The Air Filter?
(Posted by Randyherbold 10 years ago)
Popular Poulan 2150PR Manual Pages
User Manual - Page 2
... might be observed to prevent accidental starting or operating the chain saw .
2 IDENTIFICATION OF SYMBOLS
WARNING! This chain
saw when starting when setting up, transporting, ad- Read and understand the instruction manual before using the chain saw .
Because a chain saw is running.
heavy-duty, non-slip gloves; Regular users should be dangerous! Do not allow other people or animals...
User Manual - Page 3
... direction of the guide bar. S Eliminate all chain saw service performed by a
qualified service dealer with -
KICKBACK
WARNING: Avoid kickback which stops the chain for two-handed use metal to hold the flywheel when servicing the clutch, structural damage to the flywheel can cause material to cool before setting the saw cool in loss of this manual. S Do not cut...
User Manual - Page 4
... in a direct line with both feet. S Use extreme caution when re-entering a previous cut. S Use the Reduced--Kickback Guide Bar and Low--Kickback Chain specified for gasoline powered chain saws as other forces that could close a cut above shoulder height. S Never let the moving at full speed.
You must follow all safety precautions, instructions, and maintenance...
User Manual - Page 5
... B175.1. Kickback is not recommended and may push the guide bar rapidly back toward the operator. Computed kickback angle (CKA) Table
LE SERIES MODEL
BAR
P/N
Length CHAIN P/N CKA without activation of the chain brake during kickback. Low-Kickback Chain has met kickback performance requirements when tested on your saw and listed in the
CKA table below 3.8 cubic...
User Manual - Page 6
...parts. If you operate a chain saw in serious injury. ATTACHING THE BAR & CHAIN (If not already attached)
WARNING: If received assembled,
repeat all steps to ensure your authorized service dealer or call 1-800--554--6723. The chain...of this tool. Slide guide bar behind clutch drum until the adjusting pin just touches the stop. Tip of shipping spacer
Chain Brake
Chain Brake Nuts
Bar Tool
3....
User Manual - Page 9
... throttle setting for starting , start the engine and let it run until the fuel lines and carburetor are empty.
Included with a good quality synthetic 2-cycle air-cooled engine oil designed to CARBURETOR ADJUSTMENT within this saw firmly while pulling starter rope.
To avoid engine problems, the fuel system
should be mixed at FULL CHOKE; STARTING
WARNING: The chain...
User Manual - Page 10
... manually (by hand) or automatically (by sudden movement). Repairs on a chain brake should be made by turning your left wrist against the hand guard without releasing your unit to the place of the guide bar fall forward and contact the stump.
S When cutting with the saw to let the top of purchase if purchased from a servicing...
User Manual - Page 16
...800--554--6723. TROUBLE
CAUSE
REMEDY
Engine will not start or will separate from the unit. Fill tank with all guards in place. Check for dirty fuel filter; Engine smokes excessively. See "Carburetor Adjustment" in
Operation Section. 3. Contact an authorized service dealer.
1.
NEED ASSISTANCE?
Install new spark plug. 5. repair or replace. Chain brake engaged...
User Manual - Page 17
... gasoline chain saw as carburetor adjustments and chain tension adjustments.
Parts and Labor, when used for the performance of the required maintenance listed in the instruction manual such as follows from defects in our judgement affects its products.
Therefore, ELECTROLUX HOME PRODUCTS, INC., reserves the right to
change, modify, or discontinue models, designs, specifications, and...
Parts List - Page 1
...530015814
Description
Assy. -- PARTS LIST NO.
530084378
DATE
3/05/08
Replaces 530084378 --- 8/02/07
WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must be performed by qualified service personnel.
7
8
WPAEREPDAOMUEOLAATUNENRRTRRrRPAPRATRSTSLILSITST
Note: Illustration may differ from actual model due to design changes
TYPE 1---6
33
1 23 4 5 6
32...
Parts List - Page 2
...DATE
3/05/08
Replaces 530084378 --- 8/02/07
WPAEREPDAOMUEOLAATUNENRRTRRrRPAPRATRSTSLILSITST
Note: Illustration may differ from actual model due to design changes
CHAIN SAW MODEL(s)
2050 & 2150 Export
PAGE NO.
2
WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must be performed by qualified service personnel.
11 12
9 10
TYPE 7
3 2 1
4 65
7 8
22 21...
Parts List - Page 3
...05/08
Replaces 530084378 --- 8/02/07
12
3
38 37 36
35
39
WPAEREPDAOMUEOLAATUNENRRTRRrRPAPRATRSTSLILSITST
Note: Illustration may differ from actual model due to design changes
CHAIN SAW MODEL(s)
2050 & 2150 Export
PAGE NO.
3
4 56
TYPE 1---5
10
11 12 13
WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must be performed by qualified service personnel...
Parts List - Page 4
... actual model due to design changes
CHAIN SAW MODEL(s)
2050 & 2150 Export
PAGE NO.
4
TYPE 6
12
3
10
11
12
4 56
13
38 37 36
35
39 34
7 89
14 15
33 32
30 31
26 25
27 29
28
WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must be performed by qualified service personnel. Part No. Carb Adjust Seal...
Parts List - Page 5
.../08
Replaces 530084378 --- 8/02/07
WPAEREPDAOMUEOLAATUNENRRTRRrRPAPRATRSTSLILSITST
Note: Illustration may differ from actual model due to design changes
11
12 13 14
TYPE 7
1 2 3 4
56
CHAIN SAW MODEL(s)
2050 & 2150 Export
PAGE NO.
5
25 26
27 28
29
15 16 17 18
30
WARNING
All repairs, adjustments and maintenance not described in the Operator's Manual must be performed by qualified service...
Parts List - Page 6
...--662
Note: No Repair kits are available for these carburetors
LLLLL Service Reference LLLLL
Note: Your chain saw has the one or two piece seal. High (brown) 2. 530038478 Limiter Cap --- Part No. Carburetor Assembly No. 530071821 -- Two Piece Seal
If your saw may differ from actual model due to order the one piece seal as a replacement. PARTS LIST NO.
530084378
DATE...
Poulan 2150PR Reviews
We have not received any reviews for Poulan yet.