Pioneer GM-A5702 Support and Manuals
Get Help and Manuals for this Pioneer item
View All Support Options Below
Free Pioneer GM-A5702 manuals!
Problems with Pioneer GM-A5702?
Ask a Question
Free Pioneer GM-A5702 manuals!
Problems with Pioneer GM-A5702?
Ask a Question
Popular Pioneer GM-A5702 Manual Pages
Owners Manual - Page 2
..., México, D.F. 11000 TEL: 52-55-9178-4270 FAX: 52-55-5202-3714
407號8 886-(0)2-2657-3588
909號5 852-2848-6488
© 2016 PIONEER CORPORATION. Box 1540, Long Beach, California 90801-1540, U.S.A. LTD. 5 Arco Lane, Heatherton, Victoria, 3202 Australia TEL: (03) 9586-6300...
Owners Manual - Page 3
...installation. This equipment generates, uses and can be determined by one or more of the FCC Rules. If you purchased this unit for repair without appropriate authorization may cause harmful interference to Part 15 of the FCC Rules. Please keep the manual in this manual...or nearest authorized Pioneer Service Station. Before you start
Thank you read through this manual before using this ...
Owners Manual - Page 4
... or theft. ! The use
in Your Hands
Get the most importantly, without distortion. ! En Access owner's manuals, spare parts information, service information, and much more.
ESTABLISH A SAFE LEVEL: !
Before installing in the event of the car's body. Always install the amplifier on a surface with different screws. Doing so could result in Canada http://www.pioneerelectronics...
Owners Manual - Page 5
...off and the amplifier will shut down in the situations outlined below and remove the tag (GMA5702 only). If the temperature gets too high, the power indicator will turn off , and ...serial number is cut off and check the power supply and speaker connections.
Extended use the parts you have removed (screws etc.) when installing the unit in moderate and tro-
Doing so could result...
Owners Manual - Page 6
...GM-A5702
Front side
Rear side
GM-A3702
Front side
Rear side
To adjust the switch, use with an RCA equipped car stereo with output of 4 V, set...an RCA equipped Pioneer car stereo, ...speaker is connected:
Select ON. For use a flathead screwdriver if needed. 1 LPF (low-pass filter) switch
Switch the settings based on the connected speaker. ! If you hear too much noise when using the speaker input...
Owners Manual - Page 7
...function cuts off the output for the preout maximum output level of the unit and/or speakers due to high output, even if the amplifier gain is raised, the output power will... when the volume of the gain control. Setting the unit
Setting gain properly
! In such cases, please contact the nearest authorized Pioneer Service Station.
Protective function included to prevent malfunction of...
Owners Manual - Page 8
... of this wire to the power terminal via the ignition switch. 9 Speaker output terminals Please see the following section for speaker connection instructions.
a Fuse 30 A × 2 (GM-A5702) / 25 A × 1 (GMA3702) b Fuse (30 ... speaker input wire. 7 RCA input jack 8 System remote control wire (sold se- cluded) Please see the following section for speaker connection instructions.
Owners Manual - Page 9
...Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the speaker wires. Amplifier damage, smoke, and overheating could result. Secure the wiring with metal parts in adhesive tape. ! Current capacity of the amplifier is connected to the speaker instruction manual...local authorized Pioneer dealer or customer service. For ...
Owners Manual - Page 10
...
Nominal input: Min. 150 W (GM-A5702) Min. 60 W (GM-A3702)
Nominal input:
One-channel output Min. 480 W (GM-A5702)
Min. 190 W (GM-A3702)
1
Other than subwoofer
1 Speaker (Mono)
Speaker channel Two-channel output One-channel output
Power
MAX input: Min. 300 W (GM-A5702) Min. 170 W (GM-A3702)
MAX input: Min. 1000 W (GM-A5702) Min. 500 W (GM-A3702)
Connecting the speakers
The speaker output...
Owners Manual - Page 11
...
1 Route battery wire from a headunit are to the amplifier using the supplied speaker input wire. ! WARNING If the battery wire is not securely fixed to the terminal...connections, finally connect the battery wire terminal of the amplifier to the vehicle interior.
! Note If speaker input wires from engine compartment to the positive + battery terminal.
1 Positive + terminal 2 Engine compartment...
Owners Manual - Page 12
...knife to strip the end of wire and then twist the wire. Twist
1 Lug (sold separately) 2 Speaker wire 3 Connect the speaker wires to wire ends. En Connecting the units
2 Twist the battery wire, ground wire and system remote ...Battery wire 3 Ground wire
4 Connect the wires to expose about 10 mm (3/8 in.) of the speaker wires to the terminal.
Twist
3 Attach lugs to wire ends. Fix the...
Owners Manual - Page 13
...units
Installation
1 Terminal screws 2 Speaker wires 3 Speaker output terminals
Before installing the amplifier
WARNING ! To ensure proper installation, use under high-volume conditions, etc. Do not install ... could injure the driver or
passengers if the vehicle stops suddenly. - fier, ensure the following during installation: - Protection function may damage internal parts of the amplifier,...
Owners Manual - Page 14
...-to-hole distance: 343 mm (13-1/2 in.)
(GM-A5702) / 233 mm (9-1/8 in.) (GM-A3702) 5 Hole-to be easily removed. The optimal installation location differs depending on the chassis.
3 Install the amplifier with a screwdriver so they make an imprint where the installation holes are to -hole distance: 195 mm (7-5/8 in.)
(GM-A5702) / 160 mm (6-1/4 in .) diameter holes at a sufficiently...
Owners Manual - Page 15
Additional information
Specifications
GM-A5702
Power source 14.4 V DC (10.8 V to 15.1 V allowable)
Grounding system Negative type ... slope 12 dB/oct Bass boost: Frequency 50 Hz Level 0 dB/6 dB/12 dB Gain control: RCA 0.3 V to 6.5 V Speaker 3.0 V to 26 V Maximum input level / impedance: RCA 6.5 V / 22 kW Speaker 26 V / 16 kW
CEA2006 Specifications
Power output 150 W RMS × 2 Channels ...
Owners Manual - Page 16
... value when working out total current consumption by multiple power amplifiers. En Specifications and the design are subject to
modifications without notice. ! Additional information
Maximum input level / impedance: RCA 6.5 V / 22 kW Speaker 26 V / 16 kW
CEA2006 Specifications
Power output 60 W RMS × 2 Channels (at 14.4 V, 4 W and ≦ 1 % THD +N)
S/N ratio 78 dBA (reference: 1 W into...
Pioneer GM-A5702 Reviews
We have not received any reviews for Pioneer yet.