Optoma DE-GWII9xxxE Support and Manuals
Get Help and Manuals for this Optoma item
View All Support Options Below
Free Optoma DE-GWII9xxxE manuals!
Problems with Optoma DE-GWII9xxxE?
Ask a Question
Free Optoma DE-GWII9xxxE manuals!
Problems with Optoma DE-GWII9xxxE?
Ask a Question
Popular Optoma DE-GWII9xxxE Manual Pages
User Manual - Page 1
...not leave motorized screen unattended while in water or other liquids. IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions,including the following should always be followed. To reduce the... of electric shock,do not immerse this appliance,only a qualifid service technician may service or repair motorized screen.Incorrect reassemble can cause electric shock when the motorized screen ...
User Manual - Page 2
Important Attention: the installation of the screen, the electric wire connection, the setting of the limit switches must be made by a trained engineer only
SWITCH BOX PLUG
SWITCH JACK 12V TRIGGER
Motorized screen ... control: 1pc
All screens have passed the strict quality inspection before delivery. Thank you for choosing Panoview screens. Read this manual carefully to ensure proper usage.
User Manual - Page 3
... carefully, be sure screen is in good condition, and check that voltage and frequency marked on the bottom slat bar after the case has been installed.
Install screen brackets onto ceiling or wall with local power utility. MOUNT SCREEN TO WALL MOUNT SCREEN TO CEILING Remove two pulling locks on screen is...
User Manual - Page 4
ELECTRIC CONNECTION
Internal wiring has been completed at the factory.No additional wiring is necessary. Note:all wiring related to the screen,may only be serviced by a manufacturer approved trained electrical technician.Tampering with electrical wiring may void warranty and release Panoview of liability.
User Manual - Page 5
... buttons on screen housing. To be locked.
Press the Up/Stop/Down button on the hand set, screen goes Up/Stop/Down accordingly. Plug in again. Press button to prevent motor damage. ...in its protective case when not in Switch into case to stop position, screen stops. OPERATING INSTRUCTION: Remove two pulling locks on the bottom bar first before re-rolling into switch jack. Press...
User Manual - Page 7
... position.If the screen does not stop properly,adjust the limit switch again.Repeat until the desired position is set.When complete,fasten middle fasten screw (F) and small right fasten screw (FR). SETTING THE DOWN LIMIT POSITION To reduce screen drop:
Make sure middle fasten screw (F) is loosened,then loosen small right...
User Manual - Page 8
....Run the screen up to test the stop position.If more travel ie desired,adjust the limit switch again.Repeat until the desired position is set.When complete fasten middle fasten screw (F) and small left fasten screw (FR).
Optoma DE-GWII9xxxE Reviews
We have not received any reviews for Optoma yet.