NEC FE700 - MultiSync - 17" CRT Display Support and Manuals
Popular NEC FE700 Manual Pages
MultiSync FE700 User's Manual - Page 3
...monitor so as not to interfere with the limits for a Class B digital device, pursuant to part...Problems."
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Use of the Canadian InterferenceCausing Equipment Regulations. This equipment generates, uses, and can be read carefully in accordance with the instructions...if not installed and used in order to avoid any problems.
Canadian ...
MultiSync FE700 User's Manual - Page 4
... your product online at w w w.nectech.com/productregistration
Your new NEC Technologies MultiSync® FE700™ monitor box* should contain the following:
• MultiSync FE700 (JC-17W01) Monitor with tilt/swivel base • Power Cord • Captive Signal Cable • User's Manual
Captive Signal Cable
User's Manual
Power Cord
* Remember to save your original box and packing...
MultiSync FE700 User's Manual - Page 5
...: If you have any problems, please refer to the MultiSync FE700 Macintosh cable adapter on the monitor (Figure D.1) and the computer. If necessary, install the display card into your system, follow these instructions:
1.
NOTE: To obtain the MultiSync FE700 Macintosh cable adapter, call NEC Technologies at (800) 820-1230.
4. Connect one end of this User's Manual.
5. Turn off the power...
MultiSync FE700 User's Manual - Page 7
... the factory setting. Contrast: Adjusts the image brightness in the main and sub-menu, a warning window will jump ...and waver a bit as follows:
EXIT
CONTROL /
Main Menu Exits the OSM menu.
Narrow/Wide: Decreases or increases the horizontal size of the screen colors, focus and convergence. Controls
OSM™ (On-Screen Manager) control buttons on the front of the monitor...
MultiSync FE700 User's Manual - Page 8
... moiré, adjust the level by the bars. Red, Green, Blue: NEC's AccuColor Control System decreases or increases the monitor's red, green or blue color guns depending upon which can sometimes appear on...
6
8
8/16/99, 3:38 PM Tools 1
Moiré Canceler: Moiré is replaced by the color setting choice from Kelvin to adjust the spacing between the lines near the center and top of the ...
MultiSync FE700 User's Manual - Page 9
... reset ALL settings. Factory Preset: Selecting Factory Preset allows you do want to disappear. In the OSM Turn Off sub-menu, you if the refresh rate of your display card or system manual. To activate the OSM Lock Out function, press PROCEED, then press and hold down simultaneously. Monitor Info: Indicates the model name...
MultiSync FE700 User's Manual - Page 10
... Precautions and Maintenance
FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE MULTISYNC® FE700™ COLOR MONITOR:
• DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may fall, causing serious damage to qualified service personnel.
• Do not spill any kind into the cabinet...
MultiSync FE700 User's Manual - Page 11
...WHEN YOU POSITION THE MONITOR:
• Adjust the monitor height so that ceiling lights do not reflect on setting up a healthy work environment, call NEC at (800) 820-1230, NEC FastFacts™ information ... AND ADJUSTMENT OF THE MONITOR CAN REDUCE EYE, SHOULDER AND NECK FATIGUE. ANSI-HFS Standard No. 100-1988 -
The optimal distance is at a 90° angle to windows and other light sources ...
MultiSync FE700 User's Manual - Page 12
...
Depends on horizontal and vertical frequencies only
Active Display Area (Factory Setting) Active Display Area (Full Scan) Power Supply Current Rating Dimensions
Horizontal: Vertical:
Weight
Environmental Considerations Operating Temperature: Humidity: Feet: Storage Temperature: Humidity: Feet:
MultiSync® FE700™ Monitor
Notes
17 inch 16 inch 50,000 mm
90° deflection, 0.25...
MultiSync FE700 User's Manual - Page 13
.... Plug and Play: The Microsoft® solution with the Windows®95/98 operating system facilitates setup and installation by NEC Technologies, Inc.
78135061.wpc
11
13
8/16/99, 3:39...monitor to change between two color settings on your personal preference. OSM Display Screen Copyright 1999 by allowing the monitor to send its capabilities (such as screen size and resolutions supported...
MultiSync FE700 User's Manual - Page 14
... pins. Thin lines appear on monitor is not lit (no green,...monitor facing east.
Image is scrolling or unstable • Signal cable should be completely attached to the computer. • Check pin assignments and signal timings of User's Manual for proper connection or make sure the display card is fuzzy, adjust the Moiré Canceler control. Activate the Degauss Control. Troubleshooting...
MultiSync FE700 User's Manual - Page 15
...:
http://www.nectech.com/productregistration
Windows® 95/98 INF File: http://cssweb.nectech.com/common/drivers.htm
then download the file NECMSINF.ZIP.
• FastFacts™ Information (630) 467-4363
INFORMATION
DESCRIPTION
DOCUMENT #
Glossary
Definition of terms related to functions, features and installation of the MultiSync monitor
900203
More Information
Names and...
MultiSync FE700 User's Manual - Page 16
... affording an equal degree of protection. Spare parts are warranted for long periods of time resulting in image persistence (afterimage effects), accident, misuse or abuse or operated contrary to the instructions contained in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace (at 1-800-632-4662.
14
78135061...
MultiSync FE700 User's Manual - Page 17
...it has not been possible for example, in respect of the reduction of goods and services to be recycled in a satisfactory way, most of these are also other things....Your purchase has also contributed to the further development of personal computers. The main problem, as far as energy consumption levels, that are present in fisheating birds and mammals...78135061.wpc
17
8/16/99, 3:39 PM
MultiSync FE700 User's Manual - Page 56
... of each such product is a registered trademark of NEC Technologies, Inc. in the U.S. registered trademark.
U.S. Arlington Heights Road
Itasca, Illinois 60143
Tel.
Windows is not warranted by customers of specific product configurations and applications must accept any product or service.
78135061.wpc
56
Part No. 78135061 Printed in this document are expressly granted...
NEC FE700 Reviews
Do you have an experience with the NEC FE700 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for NEC yet.
Earn 750 points for your review!