Maytag WVU57UC0F Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag WVU57UC0F manuals!
Problems with Maytag WVU57UC0F?
Ask a Question
Free Maytag WVU57UC0F manuals!
Problems with Maytag WVU57UC0F?
Ask a Question
Popular Maytag WVU57UC0F Manual Pages
Owners Manual - Page 1
POUR UTILISATION RÉSIDENTIELLE UNIQUEMENT. 30" (76.2 CM) AND 36" (91.4 CM) RANGE HOOD
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-253-1301 or visit our website at www.whirlpool.com
In Canada, call 1-800-807-6777 or visit our website at www.whirlpool....
Owners Manual - Page 3
... you what the potential hazard is the safety alert symbol.
RANGE HOOD SAFETY
Your safety and the safety of injury, and tell you don't follow instructions. We have provided many important safety messages in this manual and on your appliance.
Always read and obey all safety messages. All safety messages will follow...
Owners Manual - Page 4
...Reduce The Risk Of Fire Or Electric
Shock, Do Not Use This Fan With Any Solid-State Speed Control Device.
IMPORTANT SAFETY INSTRUCTIONS
Ducted fans must always be vented to operate the appliance by a person who accepts responsibility for use by people (including children...are supervised or are trained to the outdoors. For General Ventilating Use Only. READ AND SAVE THESE INSTRUCTIONS
4
Owners Manual - Page 5
...9632; These range hoods are factory set for vented installations.
Consult the cooktop/range manufacturer installation instructions before starting installation.
UL Listed wire connectors ■ Vent clamps/duct tape as non-vented (recirculating) require charcoal filters. Location Requirements
IMPORTANT: Observe all parts are capable of being installed as required For 7" (17.8 cm...
Owners Manual - Page 6
...B. NOTE: Flexible vent is factory set to exhaust the air to cooking surface C. 30" (76.2 cm) minimum cabinet opening width for specific requirements in an attic or other ... air side of the vent system. The break should be as close as part of the thermal break. Consult your HVAC professional for 30" (76.2 cm)
models 36" (91.4 cm) minimum cabinet opening around the cap. Roof Venting...
Owners Manual - Page 7
... with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all governing codes and ordinances.
Ensure... each vent piece used , it is recommended that a qualified electrician determine that the electrical installation is adequate and in the system.
7" (17.8 cm) Round Vent System
Vent Piece ...
Owners Manual - Page 8
...installed before servicing.
For 15" (38.1 cm) deep cabinets, mark the point on this line that is 7/8" (2.2 cm) from the underside of the National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22. 1-94, Canadian Electrical Code, Part...the right of the centerline on the model/serial/rating plate. Replace all local codes and ordinances.
A
B
Centerline
A. ...
Owners Manual - Page 10
.... Round vent knockout B. Complete venting system according to range hood with a T10 TORX® screwdriver and set aside. Remove vent knockouts, depending on the top of the product. Rear rectangular vent knockout
Round vent system installations - Remove each filter by pulling the spring-release handle and then pulling down the filter.
2. Vent...
Owners Manual - Page 11
Place charcoal filter into place to secure the charcoal filter to the metal filter.
Replace the venting method screw on No Vented option 4. No Vented method screw 5. A
8. Replace metal grease filter. A. Slide the venting lever down as shown in the following image. Bend spring clips back into top side of metal filter. Bend...
Owners Manual - Page 12
... to a surface other than drywall, it is complete.
A
3. Attach the screws to the National Electric Code or CSA standards and local codes and ordinances. Tighten the strain relief screws. NOTE: Do not reconnect power until the installation is recommended that are started into place and insert the mounting bracket tabs through the slots...
Owners Manual - Page 13
... screw
2. Connect green (or bare) ground wire from power supply to the National Electric Code or CSA standards and local codes and ordinances. Replace all parts and panels before servicing. White wires B. Home power supply cable or power cord accessory kit
F.
Install terminal box cover. 6.
Remove the screw from the fused disconnect (or circuit breaker) box...
Owners Manual - Page 14
... with range hood cord connection kits that the grease filter should be set to automatically turn the fan on at any speed. NOTE: To ... while the timer is OFF. It is ON. Replace grease filter if removed.
Power Cord Kit Installations
For optional power cord kit installations, follow the instructions supplied with this model range hood.
Timer The range hood can remind you...
Owners Manual - Page 15
... in spring-release handle. 5. Replace with normal use. The LED lights are toward the front. Metal Grease Filter
For vented installations:
1.
Replace grease filter before operating hood. ...Charcoal Filter Kit.
Replacing an LED Lamp
■ For stainless steel models, Stainless Steel Cleaner and polish Part Number 31462A (not included): See the "Assistance or Service" section to ...
Owners Manual - Page 16
...
BU BK
YL/GN WH BK
CN3
WIRING DIAGRAM
L N GND
TR1
K2
CN1
BU
K1
RD
CN5
GY
CN2
WH
K3
BK
User Interface
MOTOR SPECIFICATIONS
POWER SUPPLY
120 VAC
FREQUENCY
60 Hz
POWER ABSORTION 210 W
MOTOR RESISTANCE (Ω)
(SPEED 4) BLUE / BLACK 31.1
(SPEED 3) BLUE / GREY 35.5
(SPEED 2) BLUE / RED 45...
Owners Manual - Page 17
... number in the United States.
■ Features and specifications on our full line of service. Accessories
Stainless Steel Cleaner and Polish Order Part Number 31462A
Charcoal Filter Kit For 30" (76.2 cm) models, order Part Number W10905734 For 36" (91.4 cm) models, order Part Number W10905735
Power Cord Kit Order Part Number W10613691
7" (17.8 cm) Round Damper Order...
Maytag WVU57UC0F Reviews
We have not received any reviews for Maytag yet.