Maytag MIM1554WRS - Ice Maker Support and Manuals
Get Help and Manuals for this Maytag item
View All Support Options Below
Free Maytag MIM1554WRS manuals!
Problems with Maytag MIM1554WRS?
Ask a Question
Free Maytag MIM1554WRS manuals!
Problems with Maytag MIM1554WRS?
Ask a Question
Most Recent Maytag MIM1554WRS Questions
We Have A Mim1554wrs And There Is No Floor Drain. What Part Do We Need To Pump?
(Posted by billbrooks 13 years ago)
Popular Maytag MIM1554WRS Manual Pages
User Instructions - Page 1
...WARNING."
You will need assistance, call us at www.maytag.com for purchasing this manual and on your model and serial number, located on the inside wall of ... / Table des mati_res
ICE MAKER SAFETY 1 INSTALLATION INSTRUCTIONS 2 ICE MAKER USE 7 ICE MAKER CARE 8 TROUBLESHOOTING 11 WAR RANTY 13
SI_CURITI_ DE LA MACHINE A GLA(_,ONS 14 INSTRUCTIONS D'INSTALLATION 15
UTILISATION DE LA ...
User Instructions - Page 2
... a location where the floor is important for the ice maker to be installed in back or other injury. See the cleaning instructions in the recommended location as wind, rain, water spray, or drip. The ice maker must be easily removed by changing the height of your ice maker before servicing. • Replace all of the packaging materials, clean the inside...
User Instructions - Page 3
...instructions can be used only
with the National Electrical Code and local codes and ordinances. .......
Electrical Shock Hazard
Plug into a mating, 3 prong, grounding-type wall receptacle, grounded in installation, move your water pressure, call a licensed, qualified plumber. Do not remove ground prong.
Failure to refill
after heavy usage. Before you have a drain pump installed...
User Instructions - Page 4
... the cabinet's side wall or other parts inside the cabinet. Install the water supply tube clamp around the water supply line to clear line of tubing into a container or sink, and turn shutoff valve or the equivalent, connect the ice maker as shown. Turn shutoff valve ON.
10. Drain hose (drain pump models only)
A
I/ II
B
6, Remove and discard...
User Instructions - Page 5
... install ice maker. Drain hose
B. 1" (2.54 cm) air gap C. The drain should be sure that it is level. See "Drain Pump System."
3. Hinge pin
5_6" Hex-head hinge screw
Handle screw
End Cap screw Do not remove ground prong. Plug into a grounded 3 prong outlet. See "Gravity Drain System." Recheck the ice maker to follow these instructions can settle.
• The floor drains...
User Instructions - Page 6
Remove the handle screws and handle (on the opposite side of the ice maker. Keep the parts together and set aside.
2. Remove the hinge pin from the top corner.
Hinge pin sleeve C. Beginning top corner end cap C. Bottom corner open (no end cap)
6. Replace the screws in the empty hinge holes.
5. Turn the hinge upside down...
User Instructions - Page 7
.... Do not use an extension cord. Under normal operating conditions, the ice maker will monitor the ice levels.
The ice bin is drained after each freezing cycle.
4. The following describes the kinds of sounds that might be sure to
set the ice maker control to make clear ice from the evaporator onto the cutter grid.
• When you first...
User Instructions - Page 8
... clean and rinse itself.
8. Replace the drain cap securely on enamel surfaces as they may require repeated cleaning with warm water and mild soap or detergent. Look for Part Number 4396808. Press the ON button to clean your ice maker, see "Ice Maker System" in the water pan. To clean your ice maker. See the "Ice Maker System" and the "Condenser...
User Instructions - Page 9
... to remove the lower access panel. Failure to do so can result in ice maker or reconnect power.
-|\\
_o ..., - A. Plug in death or electrical shock.
1.
Waterpan B. Electrical Shock Hazard
Disconnect power before operating. Replace all parts and panels before cleaning. A. Pull the ice level sensor down to component failure. Lift the cutter grid up and...
User Instructions - Page 10
A ' Remove, clean and replace the ice scoop and ice scoop holder.
• After removing the ice scoop, remove the holder by removing the two thumb screws.
• Wash the ice scoop holder along with the other interior components using the following instructions.
• Replace the ice scoop holder by replacing the thumb screws.
9.
User Instructions - Page 11
... problem persists, run a cleaning cycle. TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to ON?
In the U.S.A., www.maytag.com In Canada, www.maytag.ca
Your ice maker will empty from the water during the ice making cycle.
• Is the water in the line.
• Is the service...
User Instructions - Page 12
... water supply? NOTE: Service technicians cannot repair plumbing problems outside of ice
• Is there unusually high mineral content in death or electrical
shock.
• Is the condenser dirty? Electrical Shock Hazard
Disconnect power before operating. If the drain cap is not cutting ice sheets
Is the cutter grid securely in the ice maker's water or freezing system...
User Instructions - Page 13
...attached to or furnished with published installation instructions.
11. Service calls to refrigerator or freezer product failures. 7. Consumable parts are excluded from unauthorized modifications made to be provided by an authorized Maytag servicer is void if the factory applied serial number has been altered or removed from your complete model number ready. Cosmetic damage, including...
Maytag MIM1554WRS Reviews
We have not received any reviews for Maytag yet.