Makita XLC07SY1 Support and Manuals
Get Help and Manuals for this Makita item
View All Support Options Below
Free Makita XLC07SY1 manuals!
Problems with Makita XLC07SY1?
Ask a Question
Free Makita XLC07SY1 manuals!
Problems with Makita XLC07SY1?
Ask a Question
Popular Makita XLC07SY1 Manual Pages
XLC07 Instruction Manual - Page 2
...servicing.
2. Use of any other battery cartridges and chargers may differ from appliance when not in this manual. WARNING
To reduce the risk of the appliance and battery cartridge(s) are subject to change without notice.
• Specifications... not leave appliance when battery fitted. ENGLISH (Original instructions)
SPECIFICATIONS
Model:
XLC07
Capacity
with a dust bag
500 mL
with...
XLC07 Instruction Manual - Page 3
... a qualified repair person using only identical replacement parts. Do not modify or attempt to fire or temperature above 130 °C may damage the battery and increase the risk of injury.
22. SAVE THESE INSTRUCTIONS. When battery pack is in the instructions for household use to fire or excessive temperature.
Read this instruction manual and
the charger instruction manual carefully...
XLC07 Instruction Manual - Page 4
... fire, injury and/or property damage. Symbols
The followings show the symbols used for battery cartridge
1. volts
direct current
Important safety instructions for tool. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
2. A battery short can cause a large current flow, overheating, possible burns...
XLC07 Instruction Manual - Page 5
...result in the packaging.
11. Installing the batteries to the Dangerous Goods... Use of it .
4.
Overcharging shortens the battery service life.
3. When not using the battery cartridge, remove...(50 °F - 104 °F). SAVE THESE INSTRUCTIONS. Tips for hazardous material is required. Charge the ...must be observed. Unless the tool supports the use the tool and battery cartridge...
XLC07 Instruction Manual - Page 6
...conditions, the indication lamp lights up for about 60 seconds. Red indicator 2. CAUTION: Do not install the battery cartridge forcibly.
Indicator lamps 2.
By further use, the tool stops and the indicator... Failure to hold the tool and the battery cartridge firmly may cause injury.
1
Installing or removing battery cartridge
CAUTION: Always switch off power to the motor to trap...
XLC07 Instruction Manual - Page 7
... and the battery cartridge is an important component for normal speed mode. Dust bag and paper filter
Install either dust bag or paper filter before carrying out any work on this button repeats the high/max.../normal speed cycle alternatively. NOTICE: Do not fold the cardboard at its opening when installing the paper filter. NOTICE: Never throw away the dust stopper because it needs to 25%...
XLC07 Instruction Manual - Page 8
Groove 3. Place the entire cloth part of the dust stopper.
4. Dust stopper 2. Dust case cover
NOTE: When the dust bag is not installed in the figure. Insert the protrusion of ...together into the slots in the same direction of the dust bag.
5. Installing the paper filter
Use the dust stopper also when installing paper filter. Upper side of the dust stopper
8 ENGLISH Lower side of...
XLC07 Instruction Manual - Page 9
... itself.
2
3 ► 1 . Insert them all the way into the cleaner cavity in the figure. Place the entire container part of the paper filter.
6. Groove 3. Dust case cover
NOTE: When the paper filter is not installed in the cleaner cavity.
2. Dust stopper 2. Paper filter 3. 1. Insert the protrusion of the dust stopper.
1
1
► 1 . You...
XLC07 Instruction Manual - Page 10
... You can also attach the shoulder strap to the cleaner, the suction power will be reduced. Installing or removing the cleaner attachment
To connect an attachment such as illustrated.
1
► 1 ....of the cleaner as shown in your surroundings. Soft bag
OPERATION
CAUTION: Always hold the attachment part to the hose. Holding the hose joint may come off from the cleaner and result in ...
XLC07 Instruction Manual - Page 12
... bag/paper filter is used. If not, the suction/blowing force weakens. Dust stopper 2. NOTICE: When disposing of dust
CAUTION: Empty the dust bag or replace the paper filter before it should be careful not to close the dust case cover. Do not force to pinch your fingers. Dust stopper 2.
Paper...
XLC07 Instruction Manual - Page 13
... using Makita replacement parts.
CAUTION: Never block suction inlet and/or blower outlet.
NOTICE: Never use nozzles other than the nozzles provided by Makita Authorized or Factory Service Centers, always...cleaner for blowing air into objects, like . Increased motor revolution may result. Installing or removing the blower attachment
To attach the blower attachment, align the protrusion ...
XLC07 Instruction Manual - Page 14
... area. Removing and installing the sponge filter
CAUTION: After cleaning sponge filter, be sure to install it out thoroughly before use the charger while storing it up before installing. To remove the ... battery cartridge deteriorated and result in a fire. It may cause poor suction and shorten the service life of the motor.
Sponge filter Press in water, dry it in the sun may
result...
XLC07 Instruction Manual - Page 15
... to this manual.
OPTIONAL ACCESSORIES
CAUTION: These accessories or attachments are recommended for your Makita tool specified in the list may differ from country to repair cleaner by yourself.
Charge the battery cartridge.
If annexed warranty sheet is not available, refer to the warranty details set ? Hook 2. Is paper filter clogged ? Replace paper filter...
XLC07 Parts Breakdown - Page 2
... 0 2 PC. 1 PC. 1 1 4 PC. 1 PC. 1 PC. 1 PC. 1 PC. 1 SET 1 PC. 1 PC. Model XLC07Z Parts List
A = Standard Equipment 〇= Circuit Diagram
Item#
Part#
Description
001
136100-1
001 D10
002
422433-3
003
459050-6
004
232485-4
005
140H92-6
005 C10 459042-5
005 C20 ...PLATE COMPRESSION SPRING 5 HOSE COMPLETE STRAIGHT PIPE STOPPER HOUSING SET DAMPER A DAMPER B RUBBER PIN 6 CAUTION LABEL ...
XLC07SY1 New Tool Flyers English - Page 1
...8226; L.E.D. Patent and Trademark Office. UPC Code (XLC07SY1 088381-725934 UPC Code (XLC07Z 088381-725903
STANDARD EQUIPMENT
XLC07SY1
•...pk (194566-1) • Dust Bag (166084-9)
1
2
3
4
5
All specifications subject to
recharge battery
CONTROL
3-speed and off push buttons for variety of applications ...models and accessories subject to stock on vacuum indicates when to change without ...
Makita XLC07SY1 Reviews
We have not received any reviews for Makita yet.