Mackie HM54 Support and Manuals
Get Help and Manuals for this Mackie item
Popular Mackie HM54 Manual Pages
Owner's Manual - Page 2
...set out in the literature accompanying the appliance.
Do not block any exposure in excess of these permissible limits could result in order to extremely high noise levels may cause the Component and cart combination to qualified service...d'instructions importantes pour le fonctionnement et l'entretien (service) dans le livret d'instruction accompagnant l'appareil.
2
HM-54
...
Owner's Manual - Page 3
... PHONES INPUT...9
Appendix A: Service Information 10
Warranty Service ...10 Troubleshooting...10 Repair ...11
Appendix B: Connections ...12 Appendix C: Technical Info ...13
HM-54 Specifications...13 HM-54 Block Diagram...14
HM-54 Limited Warranty ...15
Don't forget to visit our website at www.mackie.com for more information about this and other Mackie products. PHONES Jack...8 3. LEVEL...
Owner's Manual - Page 4
... your new headphone amp hooked up, and you can start using it , and find that many of a rack. A PLUG FOR THE CONNECTOR SECTION
Appendix B is used on the HM-54. So the first section after that show typical setups for live sound and recording.
This icon marks information that is a Quick-Start Guide called...
Owner's Manual - Page 5
..." positions. 3. Set all of the HM-54.
2. This is that , you begin using the HM-54.
With music going .
2. If you are hard-wiring the installation, you may need it 's there if you don't want to the center detent position. Now the individual performers can take the time to pay for the corresponding headphone amp. Owner's Manual
5 Repeat for...
Owner's Manual - Page 6
... Sound Application
This illustrates using the DAW's stereo auxes, and connected to the DAW via the eight analog outputs on the HM-54 via the FireWire connection. Separate stereo headphone mixes are connected to the 400F and tracked to the Phones Inputs on the 400F.
�
�
�
�
�
�
�...
Owner's Manual - Page 7
... an Onyx 1640 mixer with Onyx 1640
Owner's Manual
7 Four aux sends from the DAW for overdubbing), or to their own aux send. HM-54 Recording Application with the optional FireWire card in the same room, each musician can adjust their own headphone mix on the HM-54, allowing the talent to listen to either the...
Owner's Manual - Page 8
...until you could damage your headphones into this jack.
Plug your hearing.
WARNING: The headphone amps are roughly equivalent in "Set the Levels" on the headphones. Even intermediate levels may need... before connecting headphones to the HM-54 and the power ON indicator lights up slowly. We're not kidding! PHONES Jack
This switch allows you have the headphone amp LEVEL control ...
Owner's Manual - Page 9
...output from your mixer to provide the main mix signal to the HM-54 (except for your particular model.
7. Note: Plugging headphones into the MAIN PHONES INPUT jack automatically disconnects the LEFT and RIGHT ...mixer to these when installing the HM-54 in a rack and hard-wiring the headphone outputs to a patch panel in the box with your analog audio connections to the HM-54. These 1/4" TRS...
Owner's Manual - Page 10
... at both sides of the headphone output. Refer to "Unbalancing a Line" for service. Doing so might save you are listening to a PHONES OUTPUT [8] on the HM-54 using a TS-to-TS 1/4" cable, it before calling for more info on the HM-54.
• Try the same source signal in another channel, set correctly. Make sure the input...
Owner's Manual - Page 11
... Mackie Dealer to qualify for all
1. Include a legible note stating your HM-54's serial number ready.
Review the preceding troubleshooting suggestions. Have your name, shipping address (no P.O.
Once it's repaired, we can reach a technical support representative Monday through
Request Number will tell you call for the Service
Request Number, please let Tech Support...
Owner's Manual - Page 12
... Sleeve = Shield Tip = Hot (+) Ring = Cold (-)
Stereo Headphones
RING SLEEVE
SLEEVE RING TIP
TIP
RING TIP
SLEEVE
1/4" TRS Stereo ... the high-impedance instrument inputs on the unbalanced end. HM-54
Appendix B: Connections
1/4" TRS Phone Plugs and Jacks Unbalancing...phone jack or plug. If there are ground-loop problems, try disconnecting the unbalanced ground (earth) connection from...
Owner's Manual - Page 13
...Width:
Depth: Weight:
1.75 in/44 mm 17.0 in/432 mm (main body of LOUD Technologies Inc. "Mackie." All Rights Reserved.
17.0 in/432 mm
WEIGHT 5.5 lb/ 2.5 kg
5.3 in/135 mm
1.75 in/ ...MAIN DIRECT
SOURCE
OO
3
PHONES
MAX LEVEL
MAIN DIRECT
SOURCE
OO
4 HM-54 HEADPHONE MIXER/AMPLIFIER
ON MAX LEVEL
Owner's Manual
13 is always striving to improve our products by incorporating new and improved materials...
Owner's Manual - Page 15
... authorized service center.
Owner's Manual
HM-54 Limited Warranty
Please keep your sales receipt from the original date of purchase. warrants all repairs performed for 90 days or for the quality or timeliness of repairs performed by Technical Support. If any product.
D. boxes or route numbers, please!). Products repaired under warranty will repair or replace the...
Owner's Manual - Page 16
16220 Wood-Red Road NE • Woodinville, WA 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: sales@mackie.com
Mackie HM54 Reviews
We have not received any reviews for Mackie yet.