Lowrance HDS-9 Carbon Support and Manuals
Get Help and Manuals for this Lowrance item
View All Support Options Below
Free Lowrance HDS-9 Carbon manuals!
Problems with Lowrance HDS-9 Carbon?
Ask a Question
Free Lowrance HDS-9 Carbon manuals!
Problems with Lowrance HDS-9 Carbon?
Ask a Question
Popular Lowrance HDS-9 Carbon Manual Pages
Operators Manual EN - Page 4
...: Copyright© 2012 NSI, Inc.: Copyright© 2012 by Richardson's Maptech. Navico product references This manual can refer to the brand website of any queries, refer to the following Navico products: • Broadband....
In case of your display or system: www.lowrance.com.
4
Preface | HDS Carbon Operator Manual Mercury® is a registered trademark of JL Marine Systems, Inc.
Operators Manual EN - Page 22
... Power-Poles, you are paired with dual Power-Poles" on page 127.
22
Introduction | HDS Carbon Operator Manual Refer to this documentation and to the HDS Carbon Installation manual for controlling and monitoring a distributed power system on the network.
BEP CZone integration The HDS Carbon integrates with BEP's CZone system used for how to display the Power-Pole controller.
Operators Manual EN - Page 35
... mapping providers in the AT5 format. Charts | HDS Carbon Operator Manual
35
Showing dual chart types
If you can select a dual chart panel by pressing and holding the Chart application button on the Ethernet network - The system also supports charts from Navionics and C-MAP as well as Lowrance in the card slot, or on the...
Operators Manual EN - Page 70
...supports several transducer frequencies.
You can view two frequencies at the same time by panning the image. When the cursor is connected.
Available frequencies depend on the transducer model...Sonar panels from the Home page.
70
Sonar | HDS Carbon Operator Manual The range The range setting determines the water depth that you position the cursor ...replaced with cursor mode features.
Operators Manual EN - Page 79
... Structure options menu to the separate HDS Carbon Installation manual. For more information about how to setup Sonar, refer to adjust the level of sonar settings designed for any unit on the Ethernet network.
Network Sonar You can share the Sonar images from this option on a unit which does not have a transducer connected. When activated, the Sonar...
Operators Manual EN - Page 82
... have a StructureScan HD, TotalScan or StructureScan 3D transducer installed to use StructureScan features. For more information about StructureScan 3D, refer to the separate StructureScan 3D documentation. The StructureScan image
The view The StructureScan panel can also be set up as an overlay to the traditional Sonar image.
82
StructureScan | HDS Carbon Operator Manual
StructureScan...
Operators Manual EN - Page 180
...devices installed on page 182. Exporting the log file The log file can advise software updates are displayed: Create report
180
Maintenance | HDS Carbon Operator Manual Before initiating an update to the unit itself, be exported from the settings file to the chosen location. Network analyzer and service assistant The system has a built-in technical support enquiries. Software upgrades
The...
Installation Manual EN - Page 10
... updates and data backup
73 Dimensional drawings 73 HDS 7 Carbon 73 HDS 9 Carbon 74 HDS 12 Carbon
75 Accessories 75 NMEA 2000 75 Display accessories 76 Ethernet cables 76 Other accessories 76 Sonar accessories
78 Supported data 78 NMEA 2000 compliant PGN List 81 NMEA 0183 supported sentences
83 Technical specifications 83 HDS Carbon technical specifications
10
Contents | HDS Carbon Installation...
Installation Manual EN - Page 43
... when a TotalScan or StructureScan HD transducer is used for the structure transducer. Check transducer type selection if this option should be inaccurate or not available at a selected interval of two impedances - 5k or 10k. This setting is possible to determine impedance.
It is in before the unit has been
Software Setup | HDS Carbon Installation Manual
43 Calibration...
Installation Manual EN - Page 45
... installation. The Radar uses this problem.
Ú Note: This procedure must be recorded for MARPA calculations. Software Setup | HDS Carbon Installation Manual
...Set the radar scanner height relative to calculate the correct STC settings. Scanner type Identifies the model of a breakwater or peninsula. Adjust bearing alignment This is receiving heading information essential for support...
Installation Manual EN - Page 50
...: Missing or invalid position data. Troubleshooting The following are possible symptoms or * messages displayed by the MFD. If the problem persists after trying the recommended action, contact support. Recommended action: • Check ... NAC-1 Computer. Follow the onscreen instructions.
Ú Note: When the autopilot attempts to CAN network.
50
Software Setup | HDS Carbon Installation Manual
Installation Manual EN - Page 55
...fuel remaining in Vessel Setup dialog, initiated from the Fuel setting options page, to save settings. Select Device list ... only available when Set to full option selected.
3. Set the actual amount used , the tank should be set the Tank location,...time. Software Setup | HDS Carbon Installation Manual
55 Select OK to allow discrete tank assignment of 8 engines is connected and set up as...
Installation Manual EN - Page 56
... is determined by a compatible engine gateway can also be assigned a unique CZone Display Dipswitch setting.
The HDS Carbon system provides a means to load the Config file, as well as apply updates to module firmware, removing the need to manually enable CZone.
56
Software Setup | HDS Carbon Installation Manual For setting up the Instrument bar or a gauge on all CZone modules and the...
Installation Manual EN - Page 69
... is on the same NMEA 2000 network as a Mercury VesselView® 4, 7, 403, 502, 702, 703, or Link, a host of Mercury® specific features are displayed: Create report
Software Setup | HDS Carbon Installation Manual
69 Updates can be sure to the internet, a pop-up any regular NMEA 2000 sources. When the features are created for any potentially valuable...
Installation Manual EN - Page 77
... transducer 000-0106-77 Skimmer Low/High CHIRP transducer 000-0106-74 Trolling motor transducer, Medium/High CHIRP 000-0106-73 In-hull shoot-thru transducer, depth only 000-0106-89 In-hull, shoot-thru transducer, depth and remote
temperature 000-12572-001 7-pin transducer to 9-pin adapter cable
For additional transducer options, visit www.lowrance.com
Accessories | HDS Carbon Installation Manual...
Lowrance HDS-9 Carbon Reviews
We have not received any reviews for Lowrance yet.