KitchenAid KBSN702MBS Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KBSN702MBS manuals!
Problems with KitchenAid KBSN702MBS?
Ask a Question
Free KitchenAid KBSN702MBS manuals!
Problems with KitchenAid KBSN702MBS?
Ask a Question
KitchenAid KBSN702MBS Videos
KitchenAid KBSN702MBS Built In Refrigerator
Duration: :42
Total Views: 1
Duration: :42
Total Views: 1
KitchenAid KBSN702MBS Réfrigérateurs encastré (84" en hauteur)
Duration: :36
Total Views: 0
Duration: :36
Total Views: 0
Popular KitchenAid KBSN702MBS Manual Pages
Quick Start Guide - Page 1
... mode for normal household refrigerator use and installation, please visit https://www.kitchenaid.com/service-and-support, or in Canada https://www.kitchenaid.ca/service-and-support.
The filter should be used for defrosting frozen items that it has been properly installed according to remove and replace filter.
SAVE THESE INSTRUCTIONS
■ While Max Cool is ON, changing...
Owners Manual - Page 2
...installation instructions supplied with ice maker kit for ice maker kit model information.
� A qualified service technician must be used in this manual and on your appliance, follow instructions. All safety messages will follow instructions. SAVE THESE INSTRUCTIONS...areas in this appliance.
� Do not use replacement parts that can be killed or seriously injured if you ...
Owners Manual - Page 6
... the bracket edge and set it above the Marinating Pan...Replace the Top Drawer Cover
1. Place shelf gently on support rails on the lower door support. 1. Remove bin by sliding in above lowest door support adjustment slot and push
down to secure. Install bin above the desired support...replace the gallon door bin: 1. To remove and replace the small items bin:
1. Replace bin by guiding...
Owners Manual - Page 7
...above it has been replaced properly. Turn Ice Maker back ON. Use up any perishables and freeze other hand. Set Vacation Mode. Press again...Storage Bin" section for further instructions on the dispensing or internal controls and hold for 3 seconds.
2. If your model, turn the Thermostat Control (...supporting the bottom with tight lids. This stops odor and mold from the refrigerator. 2.
Owners Manual - Page 8
...Installation Instructions for your model...drivers
Parts Needed
� #8 x 3" (7.6 cm) wood screws (longer screws may be at same level as the room.
Gasket B. Save these Installation Instructions...of 1/2" (1.3 cm) must support the refrigerator weight, more ... and similar non-retail applications.
� Observe all governing codes and ordinances.
� It is recommended that you are...
Owners Manual - Page 9
... and approved accessories be replaced by a switch.
Use an outlet that cannot be within 1/2" (1.3 cm) of cooling.
When you have the proper electrical connection. Water Supply Requirements
IMPORTANT: � All installations must be turned off by the manufacturer or its service agent or a similarly qualified person. Electrical Requirements
WARNING
C
Model 36 42 48
Width...
Owners Manual - Page 15
...cabinet manufacturer may use custom handles for added support. Decorative Overlay Panel
C
7¼" (18...order to mount them to be set in place of the backer ... mm) backer panel. Follow these panel dimension and placement instructions to the refrigerator. To minimize panel weight, you to... Panel
1" minimum (2.54 cm)
Door/Grille Trim Offset Dimension
Model 42
48
A
171/4" (43.82 cm)
193/4" (50...
Owners Manual - Page 17
...-step instructions. Reduce Tipping Radius (If Required)
Before bringing the refrigerator into the trim. Measure the distance from point A (as shown) to hold the panel in its final location.
2. Model 36 42...refrigerator and the parts bag behind the grille. If you do so can be sure there is top heavy and tips easily when not completely installed.
Failure to support and stabilize ...
Owners Manual - Page 20
...on some models)
A. Connect the 7 ft (2.13 m) flexible codes-approved water supply line to move and install refrigerator. ...of cardboard carton or plywood under refrigerator. Set control switch at the front of the refrigerator...codes-approved water supply line to be installed in line with the door opening . NOTE: If the main water shutoff valve is damaged, it to follow these instructions...
Owners Manual - Page 21
...support. In Canada, visit www.KitchenAid.ca, or call 1-800-442-9991. Adjust the leveling legs to level and align the refrigerator from left to right and front to the specifications... service....driver to turn the leveling bolts clockwise to
extend the legs to floor
4. Front leveling bolt
2. Failure to support and stabilize the full weight of the top soffit. IMPORTANT: � Install...
Owners Manual - Page 23
.../2" (1.27 cm), skip steps 3 and 4 of the routed side panel into
position. On some models, your refrigerator's accessory packet includes an odor absorber, which must be installed inside side trim piece, slide the front edge of the instructions, and install the base grille only. 2.
Snap the skirt onto the base grille. Skirt 4. Nail the...
Owners Manual - Page 24
...model) along either the rear or left ) position. To order a replacement odor absorber, see "Accessories" in the User Instructions or User Guide. � Remove the old odor absorber by squeezing in some models)
The absorber should be installed...maximum ice feature to the midpoint setting. The On/Off switch is ...
Follow the directions specific to a water source or replacing the water filter,...
Owners Manual - Page 25
...replacing
the water filter, follow the steps below to turn ON or Off the icemaker. Do not use the switch to make sure that is in some households. NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed... setting as...specific to flow. Repeat until a total of ice. Open the freezer door and turn off ) until water begins to your model...
Owners Manual - Page 26
... ounces of ice may continue to dispense for easy emptying and cleaning. Dispenser Tray (on some models)
Some models have an off the ice maker, see "Ice Maker and Storage Bin." NOTE: There is ... designed to the dispenser opening so ice does not fall outside of ice. To change the setting, press the ICE button before being dispensed. Pressing hard will be dispensed along with the first...
Owners Manual - Page 32
...water supply.
The compounds certified under standard laboratory conditions, actual performance may vary. EPA Est. To learn how to 22°C).
Service Flow Rate
0.5 GPM (1.89 L/min.) @ 60 psi.
� For installation, operation and maintenance instructions please refer Owner's Manual.
Property damage can affect the public acceptance/perception of drinking water quality.
� For...
KitchenAid KBSN702MBS Reviews
We have not received any reviews for KitchenAid yet.