KitchenAid KBSD708MPS Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KBSD708MPS manuals!
Problems with KitchenAid KBSD708MPS?
Ask a Question
Free KitchenAid KBSD708MPS manuals!
Problems with KitchenAid KBSD708MPS?
Ask a Question
Popular KitchenAid KBSD708MPS Manual Pages
Quick Start Guide - Page 1
...Replace Overdue" mode. SAVE THESE INSTRUCTIONS
See the "Water Filtration System" section in Owner's Manual... full cycle guide, warranty, detailed product dimensions, or for complete instructions for that zone...set point temperature of high refrigerator use and installation, please visit https://www.kitchenaid.com/service-and-support, or in Canada https://www.kitchenaid.ca/service-and-support...
Owners Manual - Page 2
... in this manual and on ... Do not use replacement parts that they do ...install the water line and ice maker. IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to some models. See serial tag inside the food compartment of appliance for ice maker kit model information.
� A qualified service technician must be replaced by the manufacturer, its service...
Owners Manual - Page 3
... prevent accidents. Junked or abandoned refrigerators are not problems of your old refrigerator, please follow these instructions to do so can result in accordance with established... so that children may not easily
climb inside. WARNING
Tip Over Hazard Refrigerator is completely installed. Failure to know about disposal of refrigerants:
Dispose of child entrapment. Keep doors taped ...
Owners Manual - Page 4
KBSD706MPS KBSD702MPS KBSD708MPS KBSD708MBS
4 This series requires the installation of custom panels, handles, and standoffs. KBSN702MPS KBSN708MPS
Side by Side Non-Dispensing Refrigerators
Stainless Series This series provides a warm commercial-looking built-in refrigerator. MODEL Models
Side by Side Dispensing Refrigerators
Overlay Series
Features factory-installed, overlay style trim ...
Owners Manual - Page 6
... will slide past the bracket edge and set it above the support rails. Rewrap if necessary. Remove the marinating pan by sliding it in the door.
Tilt the shelf at an angle and remove the shelf from its bracket. Install remaining door bins.
Replace the marinating pan by guiding the rear shelf hooks in the...
Owners Manual - Page 7
...OFF. Set Vacation Mode. Leftovers - Slide the crisper drawer straight out to make sure it down until securely in . Install remaining door...instructions on the dispensing or internal controls.
2. If your model, turn off the water supply to the ice maker at least one hand while supporting the bottom with tight lids. Slide the drawer out the rest of the door.
4. To replace...
Owners Manual - Page 10
...service agent or a similarly qualified person. Before you have questions about your local plumbing codes. NOTE: Before performing any type of the refrigerator or some other easily accessible area. If the supply cord is damaged, it is required to the desired setting. Install... or panel. On the floor, the hole should be replaced by a switch. The right-hand side is required. Do...
Owners Manual - Page 16
... and placement instructions to 19.05 mm)
1/4" 1/8" (6.35
(3.18 mm)
mm)
Backer Panel
1" minimum (2.54 cm)
Door/Grille Trim Offset Dimension
Model 42
48... strips, it is most common to use custom handles for added support. Decorative Overlay Panel
C
7¼" (18.4 cm)
Grille Panel...
Overlay Panel
Backer Panel
5/8" to 3/4 " (15.88 to be set in at least 1" (2.54 cm) from the top, bottom and ...
Owners Manual - Page 17
...thick to
install a support board on decorative overlays. In Canada, call 1-800-807-6777.
HandleSide Offset
1/4 " (6.4mm )
70½" (179.1 cm)
70½" (179.1 cm)
D
Model 42
48...KitchenAid
dealer or KitchenAid Parts and Accessories at the end of a cabinet run. W10782873
Stainless Series Custom Side Panels
Custom side panels may choose an Inset, Flush, or Recessed Inset panel installation...
Owners Manual - Page 18
... bottom.
Side Trim
11/16" (18.0 mm)
1/2" (12.2 mm)
INSTALLATION INSTRUCTIONS Unpack the Refrigerator
WARNING
9/16" (13.9 mm)
5/8" (15.7 mm)
Inset Installation Dimensions
1. If the panel is top heavy and tips easily when not completely installed. A
Recessed Inset Installation Dimensions
1. Route the front edge of the support board or attach a
3/8" (9.5 mm) board to fit into House...
Owners Manual - Page 22
.... Use a 5/16" socket driver to turn the leveling bolts clockwise...installed. Move the refrigerator straight back and evenly into the
opening . A.
Failure to follow these instructions...replaced by the manufacturer or its final location: 1. Failure to its service agent or a similar qualified person. Do not use an adapter. Do not use a cord that the refrigerator is completely installed...
Owners Manual - Page 25
... of molding or decorative panels that would not allow for service.
1.
Support board (mounted to the refrigerator. The skirt can be installed inside side trim piece, slide the front edge of the...distance between the bottom of the instructions, and install the base grille only.
2. The gap must be added to the floor.
1. Base grille B. IMPORTANT: KitchenAid is needed, place the base...
Owners Manual - Page 26
.... Remove the odor absorber from white to the midpoint setting. See the "Cleaning" section in the previous sections. Keep Installation Instructions and Use & Care Guide near the top of the refrigerator. Installing the Odor Absorber (on some models, your model. Replacing the Odor Absorber
The disposable odor absorber should be installed behind the vented door, which must be...
Owners Manual - Page 28
...ice. Remove the glass to a water source or replacing
the water filter, flush the water system. Dispense enough...model has a base grille filter system, make sure the base grille filter is properly installed and the cap is open . � Depending on your model...and LOCK at the same time. To change the setting, press the ICE button before being dispensed. Noise...instructions on your ice maker.
Owners Manual - Page 34
...amount of water that is microbiologically unsafe or of unknown quality without adequate disinfection before installing the water filtration system.
*Class I particle size: >0.5 to replace
Guide) for cyst reduction may vary.
� For installation, operation and maintenance instructions please refer Owner's Manual. Water Pressure
30 psi - 120 psi (207 kPa - 827 kPa)
� These...
KitchenAid KBSD708MPS Reviews
We have not received any reviews for KitchenAid yet.