Kenwood WD250 - KSC Car Subwoofer Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood WD250 manuals!
Problems with Kenwood WD250?
Ask a Question
Free Kenwood WD250 manuals!
Problems with Kenwood WD250?
Ask a Question
Most Recent Kenwood WD250 Questions
Ksc Wd250 Wiring.
Why does it have 2 power and 2 ground wires? do I need to connect them all?
Why does it have 2 power and 2 ground wires? do I need to connect them all?
(Posted by brents952 7 years ago)
Popular Kenwood WD250 Manual Pages
Instruction Manual - Page 2
... frequency energy. Do not install the speakers in the instruction manual.
IMPORTANT SAFEGUARDS
Read this page carefully to keep your safety.
&WARNING
• Before mounting or wiring etc., be sure to remove the wire from the battery minus terminal. (Not doing so can cause fires.)
To replace the fuse, refer to the vehicle instruction manual. • To prevent a short...
Instruction Manual - Page 3
... amplifiers. Connection
To enhance the bass sound of your car stereo system, this speaker to center unit with non-fader (subwoofer control)
Front speaker CENTER UNIT
Rear speaker
Rear speaker
RCA cord
O
(Commercially available parts)
Installation
11
C) Tap screw (05 x 22mm) x 8 C) Bracket x 4
C) Tap screw (05 x 22mm) x 8
Installation board, etc. (thickness : 25 mm or more)
English 3
Instruction Manual - Page 4
...
• If buzzing noise is heard from the speakers when the engine is running , attach a line noise filter (sold separately) to the power lead.
0 0
Battery
GND
Caution • Connect the black lead wire ground terminal directly with a screw to an unpainted metal part of
the vehicle.Turning the power ON without connecting this...
Instruction Manual - Page 5
...panel
Caution: Install the remote control unit in a position that does not come in the way of the PHASE switch.
Set
this unit as shown below. Fuse holder
Replacement fuse 5A ... Operation
■ Name ofeachpart
Power indicator
1, -.40-2100
KENWOOD
Speaker output terminal Power Supply/Control Input/Terminal (for Speaker Cords) LINE IN terminal (RCA pin jack) REMOTE terminal
PHASE...
Instruction Manual - Page 6
... of the center unit is set to ON.
• Switch the attenuator OFF. Before calling for service,please consult the following table. Remedy
• Check the (+)/(-) polarity of the power cord and that the cords are subject to remote control terminal.
Specifications
The followingratings anddesign are not shorted, then replace with a fuse with incorrect...
Kenwood WD250 Reviews
We have not received any reviews for Kenwood yet.