Icom F3001 / F4001 Support and Manuals
Get Help and Manuals for this Icom item
View All Support Options Below
Free Icom F3001 / F4001 manuals!
Problems with Icom F3001 / F4001?
Ask a Question
Free Icom F3001 / F4001 manuals!
Problems with Icom F3001 / F4001?
Ask a Question
Popular Icom F3001 / F4001 Manual Pages
Instruction Manual - Page 1
Operation is subject to the condition that this device does not cause harmful interference. The photo shows the VHF transceiver.
Limited functions only
INSTRUCTION MANUAL VHF TRANSCEIVERS
iF3000
Series
UHF TRANSCEIVERS
iF4000
Series
This device complies with Part 15 of the FCC Rules.
Instruction Manual - Page 2
... of personal injury, fire or electric shock. This instruction
manual contains important operating instructions for the IC-F3001/ IC-F3003/IC-F3006/IC-F3008 VHF TRANSCEIVERS and the IC-F4001/IC-F4003/IC-F4006/IC-F4008 UHF TRANSCEIVERS. Personal injury, fire hazard or electric shock may occur. Icom, Icom Inc.
RWARNING! If disregarded, inconvenience only. SAVE THIS...
Instruction Manual - Page 3
...expressly approved by Icom Inc., could ...part 15 of this transceiver under FCC regulations.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in a commercial environment. Operation of the FCC Rules. FCC INFORMATION
• FOR CLASS A UNINTENTIONAL RADIATORS: This equipment has been tested and found to comply with the instruction manual...
Instruction Manual - Page 4
... ears, reduce the volume level or discontinue use with Icom radios or charged with Icom chargers. Exposing the inside of the battery pack. iii PRECAUTIONS
R DANGER! Using third-party or counterfeit battery packs or chargers may result in serious damage to , or touching exposed parts of the body, especially the face or eyes...
Instruction Manual - Page 5
The transceiver warranty does
not cover any problems caused by unauthorized modification. DO NOT use or place the transceiver in direct sunlight or in the case of long hours of the transceiver are ...
Instruction Manual - Page 6
... OPERATION 12-22 ■ Turning power ON 12 ■ Channel selection 13 ■ Call procedure 14 ■ Receiving and transmitting 15 ■ Setting the microphone gain 18 ■ Setting the squelch level 19 ■ Output power level selection 20 ■ Priority A channel selection 20 ■ MDC 1200 system operation 20 ■ Emergency...
Instruction Manual - Page 19
q Set [ROTARY SELECTOR] to any [ROTARY SELECTOR] 11
channel other than Channel 16.
[VOL] 12
w R otate [VOL] to turn the power ON.
14
• You should ...
Instruction Manual - Page 20
... turning the power ON, the transceiver automatically starts scanning. 3 BASIC OPERATION
■ Channel selection
Several types of memory channel keys, [MR-CH 1] to your system set up. To select a desired operating channel, do one of the following. • Rotate [ROTARY SELECTOR]. • Push one of channel selecting methods are available.
Instruction Manual - Page 25
..., or [Upper]
9
push [Lower] to decrease the [Lower] microphone gain.
10
• The adjustable range is set on 1 or 4, an
13
error beep sounds after push-
14
ing.
Therefore, you can determine the current level setting by the type 15
of beep that sounds.
Ask your dealer for details.
19
• When using...
Instruction Manual - Page 26
...] to increase the [Lower]
squelch level (tight squelch), or
push [Lower] to decrease the
squelch level (loose squelch).
• The adjustable range is set on 0 or 9, an error beep sounds after pushing [Upper] or [Lower].
If the level is 0 (loose
squelch) to
[VOL]
any channel other than Chan- Ask your dealer for...
Instruction Manual - Page 28
... is automatically transmitted until the transceiver receives an acknowledgement signal, or you want to provide the certain emergency call . A repeat emergency signal is recommended to set an emergency channel individually to cancel the emergency call, push and hold [Emergency] again before transmitting the call operation.
D NOTES
Depending on the presetting, the...
Instruction Manual - Page 32
Only Icom battery packs are tested and approved for the BP-265 li-ion battery)
Misuse of Li-ion batteries ...the surface of battery performance. Using third-party or counterfeit battery packs or chargers may rupture. NEVER use with Icom radios or charged with Icom radios or Icom chargers.
R DANGER! Do not charge or use the battery if it dry before using. Use and charge only...
Instruction Manual - Page 33
... in a microwave oven, high- 13
pressure container, or in this instruction manual.
7
R DANGER! If any part of the body that is specified. NEVER solder the battery terminals or ...or catch fire.
5
R DANGER! Using the battery out of these
10
conditions occur, contact your Icom dealer or distributor.
11
R WARNING! ify the battery pack. This may cause heat generation, and...
Instruction Manual - Page 46
... OFF. 6 OPTIONS
D Turning the VOX function ON or OFF
The VOX function can be available, depending on the presetting.
Ask your dealer for details.
39
w Set [ROTARY SELECTOR] to turn the transceiver power ON to switch the VOX function ON or OFF. • 1 beep sounds when the VOX function is turned...
Instruction Manual - Page 47
...otate [VOL] to turn the trans-
5
ceiver power OFF.
6
e Set [ROTARY SELECTOR] to
Channel 16.
[PTT]
7
r While pushing and ...Set the microphone gain before setting the VOX gain. (p. 18) 20
40 6 OPTIONS
D Setting the VOX gain
1
The VOX sensitivity level can be available, depending on 1 or 10, an error beep sounds after pushing.
Therefore, you can determine the current level setting...
Icom F3001 / F4001 Reviews
We have not received any reviews for Icom yet.