Husqvarna ST 424T Support and Manuals
Get Help and Manuals for this Husqvarna item
This item is in your list!
View All Support Options Below
Free Husqvarna ST 424T manuals!
Problems with Husqvarna ST 424T?
Ask a Question
Free Husqvarna ST 424T manuals!
Problems with Husqvarna ST 424T?
Ask a Question
Husqvarna ST 424T Videos
Popular Husqvarna ST 424T Manual Pages
Owner Manual - Page 3
...manual.
876 - 011 - 11.05.2020
3 Wheel (for the auger bucket 2. Auger bucket 22. ON/OFF switch for the discharge chute
deflector 12. Ignition slot 8. Drive speed lever 10. Remote control lever for the heated grip 3.
Warning. Primer (for ST 424/427/430 only) 15. Hook cover (ST 424T, ST 427T, ST... to replace them.
Dipstick (for ST 424/427/430 only) 20. Tool for ST 424/427/...
Owner Manual - Page 10
...to the release lever (E).
5. Install the cable barrel fitting (F) to...install the discharge chute lever and the release cable
1. J I ) with the holes in the groove (B) on the bracket (F).
Put the release cable in the discharge chute bracket.
4. Put the bolt (B) through the hook cable slot.
• For ST 424, ST 427, ST 430 use hook cable slot (C).
• For ST 424T, ST 427T, ST...
Owner Manual - Page 15
...discharge chute.
4. Lower the drift cutters after use
Note: Controls and moving parts to the controls. To adjust the height of the product. 1.
Note:... ice and water. Do not apply much force to stop.
2.
To set to lock the auger bucket in position.
To get a good result
•... operate for ST 424T/427T/430T only)
1. Tighten the nuts. 3. Release the lever (A) to an...
Owner Manual - Page 16
... incorrect tolerance clearance, increased oil consumption, or misalignment of and adjust the track tension (only ST 424T/ 427T/430T )
Make sure that there are worn.
• Do not dispatch the chute...cable attachments2
Do a check of the tire pressure (only ST 424/427/430 )3
Daily X X
X X
At 15 hour inter- When it is in -
Replace the scraper bar if it . Do regular maintenance on the...
Owner Manual - Page 22
...speed control lever. To remove the auger belt (for ST 424T/
427T/430T only)
1. Remove the top 5/16... forward at the same time. The front section tilts forward at the same time. To install the auger belt
1.
Remove the auger belt (B) from the 2 sides of the frame...the drive belt to set the product in the groove of the frame.
4. A
B
To remove the auger belt (for ST 424/427/430 only)...
Owner Manual - Page 26
... Charge the starting procedures carefully in this manual.
Troubleshooting
Problem
The product does not start
Possible cause...Replace the starting battery needs to carburetor.
Replace the spark plug.
The fuel pump does not receive power. (For Contact an authorized service... does not trigger. (For ST 424T/427T/430T only)
Contact an authorized service center. The product is OFF...
Owner Manual - Page 27
... tank with ice or snow.
Replace the damaged parts.
If the engine does not ...fuel injector does not trigger. The augers are locked into position. Problem
Possible cause
Solution
Decreased power
The spark plug cable is blocked....is blocked. Clear the blockage. If vibration remains, contact an authorized service center.
The fuel tank cap is blocked.
Make sure that the ...
Owner Manual - Page 29
... / 0.686
876 - 011 - 11.05.2020
29 Technical data
Technical data
ST 424
ST 427
ST 430
ST 424T ST 427T ST 430T
Dimensions
Weight, with empty tanks, 140
145
150
160
165
170
kg
Max.
operating tire pressure, PSI
18
18
20
N/A
N/A
N/A
Engine
Brand
Husqvarna Husqvarna Husqvarna Husqvarna Husqvarna Husqvarna
Displacement, cc
291
369
414
306
369
420
Fuel type
Unleaded...
Parts Manual - Page 3
...Original Equipment Manufacturer (O.E.M.) replacement parts. ST 424T (96193013201), PRODUCT NO. 961 93 01-32
1
35X 2 4 5X
05.09.033-A
KEY NO.
1 2 3 4
PART NO.
588 61 ...SUPPORT AUGER BEARING BEARING IDLER 6203 RING RETAINING #5100-52 SCREW 1/4-20 X .65 W/DOG POINT
1
2
4
55
3
5
5
05.09.047-A
KEY NO.
1 2 3 4 5
PART...MODEL NO. REPAIR PARTS
AUGER HOUSING / IMPELLER ASSEMBLY
SNOW THROWER -
Parts Manual - Page 4
...Manufacturer (O.E.M.) replacement parts. NO. BLK
3
1
05.12.003-A
NOTE: All component dimensions given in U.S. REPAIR PARTS
AUGER HOUSING / IMPELLER ASSEMBLY
SNOW THROWER - BLK
1
3
585 69 13-01 NUT FLANGE NYLOCK 5/16-18
-
ST 424T (96193013201...SUPPORT GEARBOX LS NUT HEX FLG NYLOCK BLK 5/16-18 BOLT CARRIAGE BLK 5/16-18 X 5/8 BLK BOLT CARRIAGE 5/16-18 X 1-1/4
3
KEY PART NO. MODEL...
Parts Manual - Page 7
...: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. LEFT SIDE PANEL BRACKET ROTATOR REAR ... LHS GREY CHUTE DEFLECTOR SUPPORT BRACE
NOTE: All component dimensions given in U.S. REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE
SNOW THROWER - Failure to do so could be hazardous, damage your snow thrower and void your warranty.
7 MODEL NO. ST 424T (96193013201), PRODUCT NO....
Parts Manual - Page 8
...62 PIN, GROOVED
7
812 00 00-14 E-RING
77
6
1
05.08.018-A
KEY PART
3
3
2
NO. NO. DESCRIPTION
1
593 85 34-01 CABLE INTERLOCK
2
1
2
...replacement parts. ST 424T (96193013201), PRODUCT NO. 961 93 01-32
1
2
3
4
05.11.009-B
2
4
KEY PART
NO. BLK
3
KEY PART
NO. MODEL NO. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
8 REPAIR PARTS...
Parts Manual - Page 9
REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE
SNOW THROWER - M6X1
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
9 MODEL NO. RUBBER BATTERY STRAP SCREW M6X1 X 16L LOCK WASHER - 1/4 BATTERY AGM 12V 230CCA SQUARE NUT - ST 424T (96193013201), PRODUCT NO. 961 93 01-32
2
2
1
1
05...
Parts Manual - Page 10
... damage your snow thrower and void your warranty.
10 REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE
SNOW THROWER - ST 424T (96193013201), PRODUCT NO. 961 93 01-32
1
05.19.006-A
3 2
KEY NO.
1 2 3
PART NO.
590 07 13-01 590 73 98-01 532... component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO.
Parts Manual - Page 11
... only Original Equipment Manufacturer (O.E.M.) replacement parts. CABLE CABLE - HYDRO SPEED PIN - REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE
SNOW THROWER - CLEVIS
KEY NO.
8 9 10 11 12
PART NO.
532 42 79-42...dimensions given in U.S. MODEL NO. ST 424T (96193013201), PRODUCT NO. 961 93 01-32
27 6
3
5 11
11
10
9
1
11 4 8
05.08.017-C
2 7
12
KEY NO.
1 2 3 4 5 6 7
PART NO.
532 19 ...
Husqvarna ST 424T Reviews
Do you have an experience with the Husqvarna ST 424T that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Husqvarna yet.
Earn 750 points for your review!