Hoover S3639 - Company Vac Wind Tunnel Canister Support and Manuals
Get Help and Manuals for this Hoover item
This item is in your list!
View All Support Options Below
Free Hoover S3639 manuals!
Problems with Hoover S3639?
Ask a Question
Free Hoover S3639 manuals!
Problems with Hoover S3639?
Ask a Question
Popular Hoover S3639 Manual Pages
Manual - Page 1
Hoover®
WindTunnelTM Canister Cleaner with Powered Hand Tool
Owner's Manual
English § pp. 1-14 Español § pàg.15-22 Français § p. 23-30
www.hoover.com
Review this manual before operating cleaner.
Manual - Page 2
... agitator and other moving parts. others may be present. • The hose contains electrical wires. Save these instructions!
2
© 2000 The Hoover Company, www.hoover.com Index
Assembling Cleaner 3-4 Cleaner Description 4 How To Use
Canister Cleaner 5-6 Check Bag Indicator 5 Cleaning Tools 6-7 Powered Nozzle 5-6 To Clean Stairs 7 If You Have a Problem 13 Clearing Blockages 13...
Manual - Page 3
... wand.
Remove and dispose of cleaner, push hose connector into receptacle. Canister cleaner B.WindTunnel™ powered nozzle C. A
Insert plug as possible. Latch (A) will reach to the power nozzle. To release, press down on hose connector and pull up. When hose is installed in Fig.1-2 by fitting button projection (B) on the "Service" button). only) OR
1-330-499...
Manual - Page 4
... red when paper bag should be checked for hard surface floor cleaning.
8. Receptacle: connect power nozzle cord to use . Note: For some models. Always disconnect cleaner from electrical outlet before attaching or removing power nozzle plug.
2. ON/OFF pedal: conveniently located on pedal to rewind cord for convenient cleaner operation.
10.Remote variable speed control*: allows user to...
Manual - Page 5
... the indicator to show red as powder) have been picked up, clogging the bag pores; Note: Pedal opposite ON-OFF pedal is Cord Rewind Pedal (B).
2 - 3
C
On some models two switches are three conditions that the cleaner can then be controlled at the bag opening;
Deluxe power nozzle
Handle positions
The handle has two positions when used...
Manual - Page 6
...slots at rear of cleaner;
Select the tool ...BARE" (E). Variable speed control
(some models)
The variable speed control (F) is...set the floor surface selector button on the hand grip. This setting provides suction and no agitator action. You will help p r event damage to open the suction regulator. Guide... area rugs to set the power nozzle ...cleaner underneath the tool lid. The cleaning tools have many ...
Manual - Page 7
... models)
To save storage space, stand the cleaner on end and hook wand storage clip on the center of cleaner....cord rewind pedal (M) before pushing the brush in place.
2 - 1 5
2 - 1 6
Powered hand tool storage
The powered hand tool stores in the cleaner...replace the wall/floor brush, be attached directly to the hand grip.
To remove the tool (or wand), push the latch to store cleaner...
Manual - Page 8
...
How to replace
Check the bag when the "CHECK BAG" indicator shows red. 3. Rotate hose to maintain the original cleaning effectiveness and superior filtration qualities of your cleaner, use and care of bag into a box-like shape. Regular HOOVER® Type S disposable bags also fit your HOOVER cleaner operates at peak performance, it will not operate efficiently. HOOVER bags can be...
Manual - Page 9
...HOOVER Belt part no. 40201180 when a belt replacement is important for effective operation.
To check, remove the hood (see following section).
Note: Do not remove the 3 screws in the triangle formation as these hold the motor...back into cleaner. Replace the belt if it is in good condition.
Wash filter in warm water or replace it is stretched, cut , pull it off the motor pulley ...
Manual - Page 10
.... 3. If this happens, turn cleaner OFF and disconnect cleaner from agitator pulley (E) and replace with new belt. Hold opposite end of the bag.
To maintain cleaning effectiveness, replace brush roll if brushes do not touch card.
3 - 1 9
2. How to 3 - 1 4 . 2. Replace new brush roll and belt as shown in place. tional time for HOOVER part no . 27317-307, which is...
Manual - Page 11
... and remaining end tab. 4. Press the latches on either side of the bottom plate. What to replace
Disconnect cleaner from electrical outlet. 1. Ask for HOOVER part no. 48414-088.
3 - 2 1
A
How to buy
When purchasing edge groomers, ask for Hoover part no longer extend past the surface of tool and remove bottom plate (A).
3 - 2 2
3 - 2 3
B
3 - 2 4
2. Unscrew the two Philips...
Manual - Page 12
... not send your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.) c o m
Please do not add lubricant to The Hoover Company in delay. If further assistance is not normally replaced.
The addition of The Hoover Company online at w w w. only) O R -
• checking the Service section of lubricant...
Manual - Page 13
... turbine channel (B). Problem: Cleaner suction low
Possible cause Possible solution • Bag full. • Replace paper bag. • Blockage in . • Plug firmly into receptacle on , and check hose end for blockage in Figs. 3-21, 3-22 and 3-29. Problem: Cleaner won 't turn on
cleaner base. • Broken or worn belt. • Replace belt. • Floor surface set too low/suction...
Manual - Page 14
... the appliance is used in the U.S.A., phone 1-800-944-9200 OR
visit The Hoover Company online at no cost to you, all labor and parts to place this warranty gives you specific legal rights, you mail your appliance to a Hoover Factory Service Center for a period of purchase. Phone 1330-499-9499. This warranty provides, at...
Hoover S3639 Reviews
Do you have an experience with the Hoover S3639 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Hoover yet.
Earn 750 points for your review!