Hitachi CR10DL - 10.8 Volt Lithium Ion Micro Reciprocating Saw Support and Manuals
Get Help and Manuals for this Hitachi item
This item is in your list!
View All Support Options Below
Free Hitachi CR10DL manuals!
Problems with Hitachi CR10DL?
Ask a Question
Free Hitachi CR10DL manuals!
Problems with Hitachi CR10DL?
Ask a Question
Hitachi CR10DL Videos
Popular Hitachi CR10DL Manual Pages
Instruction Manual - Page 3
... this power tool. or moving parts.
the risk of electric shock....battery-operated (cordless) power tool.
1) Work area safety
c) Do not expose power tools to follow the warnings and instructions...specifically recommended by HITACHI.
Hazards that result from heat, oil, sharp edges
the dust of the safety precautions, warnings and operating instructions in the Instruction Manual...
Instruction Manual - Page 5
...SPECIFIC SAFETY RULES AND SYMBOLS
1. NEVER operate without all guards or safety features in place and in place. NEVER operate this type of work. Handle tool correctly. Check their condition periodically.
12. Cracks in the Instruction Manual.
10. Prevent potential injuries to the instructions...repairs by a Hitachi authorized service center.
15. Because the cordless reciprocating saw...
Instruction Manual - Page 6
... cord could result from receptacle before you can use of injury, charge HITACHI rechargeable battery type BCL1015. and c.
IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE BATTERY AND BATTERY CHARGER
You must be used make sure: a. This manual contains important safety and operating instructions for battery charger Model UC10SFL.
2. An extension cord should not be used unless absolutely...
Instruction Manual - Page 9
... read and understood all safety instructions contained in this Instruction Manual may show details or attachments that differ from those on the tool unless you in this manual. NAME OF PARTS
1. Cordless Reciprocating Saw (CR10DL)
Lever
Blade holder
Lock-off button Switch trigger
Blade Base
Rubber cap Housing
⅜ Battery (BCL1015)
Battery
Latch
Nameplate Fig. 1
9
NEVER...
Instruction Manual - Page 10
Cordless Reciprocating Saw (CR10DL)
Motor No-load speed Stroke Capacity
Battery Weight
Model
Type
Voltage
Charging & discharging frequency
DC motor
0 - 2,700 / min
1/2" (13 mm)
Mild Steel Pipe: O.D. 1" (25 mm)
Vinyl Chloride Pipe: O.D. 1-3/4" (45 mm)
Wood:
Depth 2" (50 mm)
Mild Steel Plate: 5/32" (4 mm)
BCL1015
Lithium - Battery Charger (UC10SFL)
Input power source
Single phase...
Instruction Manual - Page 11
... of the charging, stop the charging and contact your HITACHI AUTHORIZED SERVICE CENTER.
11 WARNING: Do not use the electrical cord if damaged. NOTE: The battery charging time becomes longer when a temperature is low or the voltage of battery charger into the receptacle. Have it repaired immediately.
2.
When the pilot lamp does not go out...
Instruction Manual - Page 12
...Supporting the battery charger with hand, pull out the battery from the battery charger.
How to the type of debris and clutter. Once the
Fig. 6
12
BEFORE USE
Check the work while the
battery...battery. When you continue to your authorized Service ...batteries that the power of saw blades without the use , its life will be cooled for a while before charging. ● If the battery...
Instruction Manual - Page 14
...HOW TO USE THE CORDLESS RECIPROCATING SAW
Rubber cap
Fig. 13
CAUTION: Do not use any saw blade after subtracting the stroke should be fitted on if it is installed can be
larger than the...blade holder and the rubber cap, and furthermore ensure that the battery is
not pressed firmly against the material
while cutting.
The rubber cap can result in some slack movement of the
saw blade...
Instruction Manual - Page 15
.... Therefore, if the tool is not the trouble but the result of the material to be ...saw blade will be adjusted from the minimum to maximum nameplate stroke rate by squeezing or releasing the trigger. Move the button to the left to stop . CAUTION: The service... life of the pipe, wood, etc., resulting in damage. (Fig. 18, Fig. 20) ⅜ To extend the lifetime, the lithium-ion battery...
Instruction Manual - Page 16
... cutting on lighting while the trigger switch is being pulled. Battery level warning lamp The battery level can carry out pocket cutting quite easily with the saw blade during the cutting operation and observe the following procedures.
(1) Press the lower part (or the upper part) of the saw blade apart from the material. (Fig. 25, Fig. 26)
(2) Raise...
Instruction Manual - Page 17
...List will eventually require servicing or replacement of parts because of this power tool with oil or water.
4. This does not mean that the battery power is extremely dangerous.
7. Be sure to the Hitachi Authorized Service Center when requesting repair or other maintenance.
CAUTION: Using this battery into the municipal waste stream. Service and repairs All quality power tools...
Instruction Manual - Page 18
... replacement part or accessory with this tool.
NOTE: Accessories are not intended for use with your tool. PROG. NEVER use of the HITACHI. STANDARD ACCESSORIES
CR10DL (LCSK)
CR10DL (2LCSK)
1 Blade (No. 5) (Code No. 958185 1 2 Blade (No. 107) (Code No. 318617 1 3 Allen wrench (Code No. 943277 1 4 Battery (BCL1015) ...1 5 Battery charger (UC10SFL 1 6 Plastic case (Code...
Instruction Manual - Page 56
... 1-800-59-TOOLS (llamada gratis), o con HITACHI AUTORIZED POWER TOOL SERVICE CENTER.
Unit B,
Mississauga ON L5T 2A4
803 Code No. at 1-800-59-TOOLS (toll free), or HITACHI AUTHORIZED POWER TOOL SERVICE CENTER recarding COLLECTION. LTD.
Sinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo 108-6020, Japan
Distributed by
Hitachi Koki Co., Ltd. C99171261 Printed in...
Parts List - Page 2
...-SPEED CONTROL SWITCH
1
40 329-986 CONTROLLER (B)
1
REMARKS
CR 10DL
- 2 -
*ALTERNATIVE PARTS
4 - 08 USED
1
2 313-687 TAPPING SCREW (W/FLANGE) D3X16 (BLACK) 8
3
NAME PLATE
1
4 329-994 HOUSING (A). (B) SET
1
5
HITACHI LABEL
1
6 321-130 CAP
1
7 321-134 HOLDER PIN (B)
1
8 318-483 SPRING (B)
1
9 321-132 BLADE HOLDER (A)
1
10 322-709 NUT M4 (BLACK)
1
11 318-832 SEAL LOCK...
Parts List - Page 3
... 958-186 SABER SAW BLADES NO. 6 (5 PCS.)
1
605 958-187 SABER SAW BLADES NO. 7 (5 PCS.)
1
606 959-800 SABER SAW BLADES NO. 96 (3 PCS.)
1
607 318-611 SABER SAW BLADES NO. 101 150L P. 10 (5 PCS.) 1
608 318-617 SABER SAW BLADES NO. 107 150L P. 24 (5 PCS.) 1
609 324-818 SABER SAW BLADES NO. 109 150L P. 18 (5 PCS.) 1
REMARKS
4 - 08
*ALTERNATIVE PARTS
- 3 -
CODE NO.
STANDARD...
Hitachi CR10DL Reviews
Do you have an experience with the Hitachi CR10DL that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Hitachi yet.
Earn 750 points for your review!