Hamilton Beach HBB800 - Commercial Blender Support and Manuals
Get Help and Manuals for this Hamilton Beach item
View All Support Options Below
Free Hamilton Beach HBB800 manuals!
Problems with Hamilton Beach HBB800?
Ask a Question
Free Hamilton Beach HBB800 manuals!
Problems with Hamilton Beach HBB800?
Ask a Question
Popular Hamilton Beach HBB800 Manual Pages
Operation Manual - Page 2
... or replacement parts, call our Technical Service number:
866-285-1087 or 910-693-4277
8 a.m. - 5:00 p.m. Friday www.commercial.hamiltonbeach.com
2 Not intended for instructions on or taking off parts.
8. Avoid contacting moving an appliance containing hot oil or other than intended use by Hamilton Beach may cause injuries.
14. Do not use a thin rubber spatula to blender...
Operation Manual - Page 3
... the container on the model of your blender. Parts and Features
The parts and features for the HBB800 blender are shown on a dry, level surface.
3. Become familiar with ingredients and container lid in place.
5. Your HBB800 blender is not designed to make daiquiris or similar drinks.
Read Important Safety Instructions and Warnings before using your blender, the plug will look...
Operation Manual - Page 4
... remove ground prong.
Operation
Operating the Blender-HBB800
wWARNING
wWARNING
Electrical Shock Hazard Plug into a grounded 3-prong outlet. Make sure that the OFF/LOW/HIGH switch on for continuous operation at LOW or HIGH speed or off.
• The High/Low settings allow you to follow these instructions can result in broken bones, cuts...
Operation Manual - Page 5
...be added to milk or fruit juice to follow these instructions can be observed: • Do not exceed one quart... container when operating the blender where steam may prevent the blender from processing the product properly. Process dense foods or thick mixtures in small...at HIGH and process until desired consistency is running.
5
Set speed at once.
• Do NOT overfill the container ...
Operation Manual - Page 6
...35° C).
6. General cleaning
Do not allow food residue to clean the base. Empty container.
3. Wipe...Blender
Cleaning Instructions
wWARNING
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet. Replace cover and filler cap and run the blender...part of hot water (less than that recommended, the sanitizing solution concentration should be used again within one hour, as instructed...
Operation Manual - Page 7
...
The cutter unit assembly should be checked daily for the Blender
Gasket Cutter Unit Assembly Collar Rubber Clutch Disc
7 If the cutter unit assembly becomes worn or damaged, replace it clockwise. Securely tighten the collar onto the bottom of the container. 2. To install the new clutch disc, thread it onto the motor shaft...
Operation Manual - Page 8
...• Check to see if cutter assembly is too full.
See "Replacement Parts" below . Replacement Parts for the Blender
Troubleshooting Guide
Problem . . . Part Description 44 oz. Mixture should not exceed 1″ (25mm)cubes.
• Container is installed properly.
• Select speed to the ingredients. Replace cutter assembly at least every 90 days or sooner if cutter assembly...
Operation Manual - Page 9
... from abuse, misuse, neglect, unauthorized repair, or use this product, at 1-866-285-1087 or 910-693-4277. (For faster service please have other Product Warranties LIMITED WARRANTY
This product is warranted to be free from defects in accordance with the printed directions. This warranty gives you specific legal rights and you may...
Hamilton Beach HBB800 Reviews
We have not received any reviews for Hamilton Beach yet.