Hamilton Beach 04161P Support and Manuals
Get Help and Manuals for this Hamilton Beach item
View All Support Options Below
Free Hamilton Beach 04161P manuals!
Problems with Hamilton Beach 04161P?
Ask a Question
Free Hamilton Beach 04161P manuals!
Problems with Hamilton Beach 04161P?
Ask a Question
Popular Hamilton Beach 04161P Manual Pages
Use & Care - Page 2
...replacing parts...replace the obsolete outlet. Read all instructions before moving to prevent damage from the air.
8. Do not operate this air purifier.
If a longer cord is equipped with wet hands; Route the electrical or extension cord clear of the polarized plug by this product in any reason. Save these instructions carefully. Do not immerse this manual. Contact Hamilton Beach...
Use & Care - Page 3
... reduces odors.
2. See "Checking the Filters" on outlet grille. • Use only Hamilton Beach replacement UV bulb: Part No. 04810. • Read all instructions before cleaning, servicing or replacing the UV bulb. • Never look directly at high speed. ft.) Pre-Filter
200 ft2
04922
200 ft2
04922
350 ft2
04923
350 ft2
04923
HEPA Filter 04912 04912 04913 04913
UV...
Use & Care - Page 4
... - 840129900 ENv02.qxd 11/1/04 11:01 AM Page 4
Know Your Air Purifier
Parts and Features
1. Filter Check Gauge
8. Intake Grille
* Available on AirSmart™ models only. Control Panel 4. Carbon Pre-Filter
11. see page 12 for location)
7. AirSmart™ Sensor* 5. Manual control models do not include these features.
4 UV Starter
6. HEPA Filter
10. Air Sensor Cleaner*
9.
Use & Care - Page 5
....
• Turn off and unplug the air purifier before use. Make sure that the air purifier and the cord do not place on or near heat sources such as TVs, baby monitors, or cordless phones.
5 Make sure that the HEPA filter and carbon pre-filter are properly installed before moving or servicing it, or if it is out of...
Use & Care - Page 6
... the upper corners of the air purifier and lifting up.
2
Locate the black carbon pre-filter. NOTE: The air purifier has a safety switch that prevents operation if the intake grille is not properly installed. It will be replaced approximately every three
months.
DO NOT attempt to the four hook fasteners on the
HEPA filter.
4
Insert the two tabs on...
Use & Care - Page 7
... 7
Plugging in the Air Purifier
WARNING: To reduce the risk of the unit. Manual Control Models
1. Fan Speed Knob - If the plug still does not fit, contact a qualified electrician to the desired setting. Lights when the germicidal UV lamp is turned off.
2. There are wet. Use for quiet, nighttime operation or for quickly filtering dust, pollen...
Use & Care - Page 8
...with the end of the unit. AirSmart™ Models
1. Turns on if the fan is set to determine the current air quality. When the air purifier is on , the AirSmart™ sensor will...normal setting for constant low-speed filtration.
• Medium - 840129900 ENv02.qxd 11/1/04 11:01 AM Page 8
Setting the Controls - Germicidal UV Button - HEPA Filter Timer Reset Button
5. AIR
AUTO...
Use & Care - Page 9
...
On models equipped with the AirSmart™ sensor, it is recommended to clean the sensor monthly.
1. Push the air sensor cleaner in and out of your air purifier. If it is not, the sensor may not operate properly.
9 The following instructions will help you maximize the life and efficiency of the sensor opening .
3.
Replace the intake...
Use & Care - Page 10
... hole on the
top of outlet grille. It is stored in a compartment behind the front intake grille.
See item 7 on page 4 for location. The HEPA filter should float up the filter check gauge.
Replace
Filter(s)
10 NOTE: You must reinstall and snap the intake grille before checking the filters with your air purifier to allow you to be...
Use & Care - Page 11
...recommended that you first replace the carbon pre-filter and then use the filter check gauge to check the filter again.
Insert the unwrapped HEPA filter, hook
fastener side out, into the air purifier. 840129900 ENv02.qxd 11/1/04 11:02 AM Page 11
Replacing the HEPA Filter
The HEPA filter will result in poor air filtration.
11 NOTE: Improper filter installation will normally last about...
Use & Care - Page 12
...Replacing the UV Bulb
The UV bulb is designed to touch the glass part of continuous, effective operation. Pull the pins out the sides of
the socket, one end at a time.
3
Be careful not to provide approximately one end of the air purifier...-you could break the bulb.
12 Oil from Hamilton Beach.
1
Turn off and unplug the air purifier. Carefully unpack the bulb and discard
the packaging.
Use & Care - Page 13
... center tabs on the front of the outlet grille into place.
NOTE: The air purifier has a safety switch that prevents operation when the top outlet grille is not properly installed. 840129900 ENv02.qxd 11/1/04 11:03 AM Page 13
Replacing the UV Bulb (continued)
4
Once the ends of the bulb are completely inserted...
Use & Care - Page 14
... it unlocks, then pull it out. To install the
new starter, insert the starter and turn
clockwise. 840129900 ENv02.qxd 11/1/04 11:03 AM Page 14
Replacing the UV Starter
If the UV bulb does not light after installing a new bulb, the starter should be replaced.
See page 3 for replacement parts.
1
Turn off and unplug air purifier.
Use & Care - Page 15
... on ? Can't Find Replacement Filters
Call 1-800-455-7213 OR Visit TrueAirFilters.com
15 840129900 ENv02.qxd 11/1/04 11:03 AM Page 15
Troubleshooting Guide
The following section provides the solutions to many common problems and questions. If your air purifier is still not solved after reviewing this guide, call our toll-free customer service number, listed on...
Use & Care - Page 16
... not in that information below .
If you . This warranty gives you specific legal rights, and you may also have model, series, and type numbers ready for a period of original purchase, except...HEREBY EXCLUDED. or Canada. This information will repair or replace this product, at our option, at no warranty with respect to assist you.)
CUSTOMER SERVICE NUMBERS In the U.S. 1-800-851-8900 ...
Hamilton Beach 04161P Reviews
We have not received any reviews for Hamilton Beach yet.