Haier HWD100-FD756DD Support and Manuals
Get Help and Manuals for this Haier item
View All Support Options Below
Free Haier HWD100-FD756DD manuals!
Problems with Haier HWD100-FD756DD?
Ask a Question
Free Haier HWD100-FD756DD manuals!
Problems with Haier HWD100-FD756DD?
Ask a Question
Popular Haier HWD100-FD756DD Manual Pages
UM - Page 2
... proper installation, use of the appliance.
Help to it . Please read these instructions carefully before using this symbol with the appliance and safety warnings. Keep this manual so ...that the new owner can always refer to recycle waste of it for purchasing a Haier Product...
UM - Page 9
...Dosing
Delay Speed Temp. During pro gramme selection and during operation its default settings will be set bypressingthe function button sequentialy.
GB
3-Control panel
3.1 Display
The display (Fig.3.11) shows following information: Washing time End time delay Error codes and service information
During operation display will shut down automatically.
3.5 Function buttons
The function butt...
UM - Page 10
...Smart Dosing" function touch the button sequentialy until the
Note: Factory settings
there is no indicator is displayed, manual dosing is selected. Note: "Smart Dosing"
The "SmartDosin●g"...default settings are flashing refer to section TROUBLESHOOTING. Otherwise operation will light up to 15 programme cycles. 3-Control panel
GB
To delete the setting or to cancel the setting process,...
UM - Page 12
... the selected programme and settings, the op ti●mum quantity of detergent and/or fabric softener is suitablefor the variouswashingtemperatures, please refer to the manual of detergents is dosed ...is not running.
3.6 Function indicators
The indicators (Fig.3.6) light up or display the set data
t
value when corresponding function is activated.
3.7 Detergent drawer
Th●e appliance ...
UM - Page 18
...tc.), empty the dispenser completely and clean it. Manual dosing Put the required powder detergent into the "Smart...instruction on the detergent package.
●
Concentrated liquid detergent should be deactivated when you use powder detergent.
2b. If detergent is default setting for a long period of the "Smart Dosing"compartments(Fig.2.6-2). Fill in ml Compartment
5.6-1 5.6-2
HWD100-FD756DD...
UM - Page 21
...●sed manualy, do not dose any additional detergent into the "Smart
●
over dosage and foaming.
21 Raise default settings only due to heavy staining. If detergent is used. For manual detergent dosing appl y exact dosages of energy, water, detergent andtime you shoulduse the recom mended maximum load size. For slightly...
UM - Page 23
... either use a special machine cleaner.
7.5 Long periods of disuse
If the appliance is properly installed and without "Smart Dosing" function and add a small amount of detergent in washingagent compartment (2)... recommend to run programme Drum Clean with no load, without leakage. doesn´t spin. Open service ap. Pull out the electrical plug (Fig. 7.5-1).
7 3. Empty, clean and dry the ...
UM - Page 24
... the pump filter (Fig.7.6-3).
8. After complete drainage close drainhose and push it back into the machine.
7. Remove contaminants and dirt .
(Fig. 7.6-4).
10.
(Fig. 7.6-5).
11.Close service ap. Provide a at container to catch leach water. GB
7-Care and cleaning
3.
UM - Page 25
... the appliance and disconnect the mains plug from the mains socket.
A damaged power cable should only be replaced by the manufacturer, its service
8.1 Information codes Following codes are displayed only for information referring to the washing cycle.
8-Troubleshooting
GB
of a problem please check all shown possibilities and follow below instructions before you contact an after sales...
UM - Page 27
... tiv●ated by fats suchasoils, creams or ointments. Caused by using the manually dosing
Washing programme duration will be adjusted. Detergent residues are on the laundry. ... compartment i●s empty. Reduce loading. 8-Troubleshooting
GB
Operation stops before completing wash cycle.
Appliance displays error code. Problem due to brushthe points from the dry laundry...
UM - Page 28
Fix all parts and close the service ap.
28 GB
8-Troubleshooting
Note: Foamformation
If too much foam is restored operation will be visiblein...9679;
In case of power failure
The current progra●mme and its setting will be re- Danger of chapter CARE AN CLEANING (PUMP FILTER).
Pull lever (A) beneath service ap (Fig.8-4) until door is mechanicaly blocked.
If the laundry is to...
UM - Page 30
...achievea complete level position. GB
9-Installation
9.4 Aligning the appliance
Adjust all feet (Fig.9.4) to cold water supply. Loose the locknut (1) by turning thefoot (2). 3. Tighten locknut (1) against the housing.
●
9.5 Drain Water Connection Fixthe water drainho●seproperly to use a spirit levelfor adjustment. Use only the supplied hose set for the connection.
Before...
UM - Page 31
...9.5.3 Drain hoseto sinkconnection The junction must be removed to prevent any disfunction (Fig. 9.5-3). If necessary contact after sales service.
●
31
9-Installation
GB
Followingconnections are possible: 9.5.1 Drain hoseto sink
Hang the drain hose with the U-support over the edge of a sink with a clamp. ping.
9.5.2 Drain hoseto waste water connection The internal diameter of...
UM - Page 32
... into the socket (Fig. 9.7). Take care these●parts are used.
tenance run programme SELF CLEAN withno load,without...!
●
dry and leakrfee! Tighten the screw joint by the service agent (seewarranty card) in washingagent compartment (2)or with a 3/4" thread...replaced by hand.
2. the power plug and socket are inserted.
1. GB
9-Installation
9.6 Fresh Water Connection
...
UM - Page 33
GB
10-Technical data
10.1 Additional technical data
HWD100-FD756DD
Dimension in mm 850
Height
Width
595
D
●
Voltage in V
600 220-240V/50Hz
Current in A
10
Max power in W
Water Pressure in MPa Max.water inlettemperature
Netto weight inkg
Drying Capacity in kg
2000
cold 81 10
●
33
Haier HWD100-FD756DD Reviews
We have not received any reviews for Haier yet.