Frigidaire FFRE4120SW Support and Manuals
Get Help and Manuals for this Frigidaire item
This item is in your list!
View All Support Options Below
Free Frigidaire FFRE4120SW manuals!
Problems with Frigidaire FFRE4120SW?
Ask a Question
Free Frigidaire FFRE4120SW manuals!
Problems with Frigidaire FFRE4120SW?
Ask a Question
Popular Frigidaire FFRE4120SW Manual Pages
Installation Guide - Page 2
...'s instructions and local codes. • The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National
Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian electrical code C22.1 part 1. • The gas service to prevent property damage, personal injury or loss of life. An individual manual shut-off valve must be installed...
Installation Guide - Page 3
... NEMA 10-30R or 14-30R service cord with a WARNING or CAUTION based on Dryer plugged in
Final Checks Installation Instructions and Use and Care Guide read all instructions before initial operation
Door Reversal Follow detailed instructions in this guide Test hinge and latch for LP system Gas supply turned on No leaks...
Installation Guide - Page 4
..., 4-wire power supply cord (NEMA 14-30R). Electrical requirements for washer and dryer. GROUNDING CONNECTION - INSTALLATION REQUIREMENTS
Electrical system requirements
NOTE
Because of potentially inconsistent voltage capabilities, the use of this dryer with clothes dryers. Use separately fused circuits for gas dryer
CIRCUIT -
NEMA 14-30R receptacle to be used when the appliance...
Installation Guide - Page 5
... install a booster fan in dryer exhaust duct.
● Install all clothes dryers in accordance with the installation instructions in excess of 1/2 psig (3.45 kPa).
7 The dryer MUST be used to
connect your present system is free of local codes, with flexible plastic or metal foil venting materials. WARNING
FIRE HAZARD Do not install a clothes dryer with the National Fuel Gas Code...
Installation Guide - Page 7
... not described in death, explosion, fire or burns. Install male fittings in correct direction:
CORRECT
INCORRECT
In installations where the exhaust system is acceptable:
1 Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer.
2 Set the dryer timer and temperature to do so can result in...
Installation Guide - Page 8
...) 1"
(2.5 cm)
REAR
6" (15.2 cm)
6" (15.2 cm)
TOP
24" (61 cm)
24" (61 cm)
FRONT
n/a
2" (5.1 cm)
1" (2.5 cm)
1" (2.5 cm)
2" (5.1 cm)
6" (15.2 cm)
Installation in a Recess or Closet
1 A dryer installed in the same closet as the gas dryer.
3 Your dryer needs the space around it will come in a closet with equivalent air openings for proper ventilation. Openings should be...
Installation Guide - Page 9
... longer drying times than dryers operating on gas dryer approximately 67 inches (170 cm).
30.8" (78.2 cm) to front of closed door
Electrical installation
The following are not designed to withstand the amounts of electrical current this manual for the proper power cord to be properly grounded.
Follow the instructions in this dryer utilizes and can melt...
Installation Guide - Page 10
.... If it will not fit the outlet, have a proper outlet installed by a path of the dryer may cause serious injury or death. Check with a licensed electrician if you... dryer is equipped with all local codes and ordinances. Electric dryer (Canada)
WARNING
Improper grounding of electrical shock by a qualified electrician. Power cord with all local codes and ordinances. Gas dryer ...
Installation Guide - Page 11
...dryer from a 4-wire system and installing it in a 3-wire system, move the internal ground from the center terminal back to the GREEN screw next to the
power cord/strain relief manufacturer's instructions...INSTALLATION INSTRUCTIONS
Electrical connection (non-Canada) - 3 wire cord
3-wire receptacle (NEMA type 10-30R)
WARNING
ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing...
Installation Guide - Page 12
... terminals on the back of the dryer.
3 Install a UL-approved strain relief according to the power cord/strain relief manufacturer's instructions in the power cord entry hole ...wire system. INSTALLATION INSTRUCTIONS
Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle (NEMA type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result ...
Installation Guide - Page 13
... the back of the National Fuel Gas Code ANSI Z223.1/NEPA 54 or in the gas supply line to allow gas to the corrosive action of Dryer
All connections must be wrench-tightened
IMPORTANT
The supply line must be in a location that is not available, test all pipe connections. INSTALLATION INSTRUCTIONS
Gas connection
1 Remove the shipping cap from...
Installation Guide - Page 14
...operation, please review the "Avoid Service Checklist" in a location near the dryer for
c
future reference.
INSTALLATION INSTRUCTIONS
General installation
1 Connect ...Guide provided with 3-prong grounded plug
6 Turn on the power at the circuit breaker/fuse box. A
IMPORTANT
Be sure the power is off at a minimum for
the slightest movement. Adjust the appropriate leg(s)
so the dryer...
Installation Guide - Page 15
... and door strike to disconnect power source before reversing door.
2 You will need a screw driver with a Phillips bit.
3 Protect flat any time without additional parts.
FRONT PANEL HINGE SCREWS (x 4)
4 Reinsert inner door to outer door and re-install hinges and all screws removed earlier.
2 Place door on all screws on a towel (front...
Installation Guide - Page 16
... the front panel door opening. Attach the upper hinge to the top hole in the opposite position with one screw. Once both screws are tightened, install the remaining two screws. Once the first screw is started, attach the second screw to the lower hinge.
Installation Guide - Page 17
Wiring errors can cause improper and dangerous operation. Replacement parts:
If replacements parts are needed for your dryer, contact the source where you purchased your Use and Care Guide for more information. UNIVERSAL APPLIANCE WRENCH P/N 137019200
A UNIVERSAL APPLIANCE WRENCH is available to disconnection when servicing controls. P/N 5304468812 *Other colors may be available.
...
Frigidaire FFRE4120SW Reviews
Do you have an experience with the Frigidaire FFRE4120SW that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Frigidaire yet.
Earn 750 points for your review!