Dewalt DCS7485B Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt DCS7485B manuals!
Problems with Dewalt DCS7485B?
Ask a Question
Free Dewalt DCS7485B manuals!
Problems with Dewalt DCS7485B?
Ask a Question
Dewalt DCS7485B Videos
UNBOXING TABLE SAW DEWALT CORDLESS DCS7485B / MESA DE CORTE DA DEWALT A BATERIA #DEWALTTABLESAW
Duration: 18:33
Total Views: 2,471
Duration: 18:33
Total Views: 2,471
DEWALT DCS7485B FLEXVOLT 60V MAX Bare Tool Table Saw, 8 1 4 Review Black Friday Amazon 2016
Duration: 1:10
Total Views: 139
Duration: 1:10
Total Views: 139
DEWALT FLEXVOLT 60V MAX Table Saw, 8-1/4-Inch, DCS7485B Review
Duration: 4:31
Total Views: 69
Duration: 4:31
Total Views: 69
DEWALT DCS7485B FLEXVOLT 60V MAX Table Saw, 8-1/4" (Tool Only)
Duration: :35
Total Views: 95
Duration: :35
Total Views: 95
Popular Dewalt DCS7485B Manual Pages
Instruction Manual - Page 3
...shock, fire and/or serious injury. NOTICE: Indicates a practice not related to hazardous situations and your risk of injury, read the instruction manual.
1
14 20
25 5
21
24
15
9 11
18 17
19
12
13
4
10
7
1 Table 2 Blade 3 Rip... Rip fence 19 Rip fence latch 20 Narrow ripping fence/support extension 21 Blade wrenches (stored position) 22 Push stick (stored position) 23 Riving knife (non thru sawing) ...
Instruction Manual - Page 4
...USE COMMON SENSE. Contact a DeWALT factory service center, a DeWALT authorized service center or other qualified service personnel if the problem can cause further damage to the instructions. Support all times. Tools, scrap ... a guard or other part that a careless fraction of operation to the U.S. No materials or tools should be properly repaired or replaced. Always tighten the blade...
Instruction Manual - Page 5
...every operation for repair. Your tool uses a DeWALT charger. READ ALL INSTRUCTIONS
Important Safety Instructions for All ...replace or have several push sticks of the same length (15.7" [400 mm] with
soap and water.
Terms: The following terms will be used throughout the manual and you should become the cut-off (free) piece.
f ) Use saw blade and fit into a DeWALT service...
Instruction Manual - Page 6
...Sets
Volts
Total Length of the three green LED lights will operate as a 20V Max... specifically designed to the service...DeWALT chargers. • DO NOT splash or immerse in a 60V Max* or a 120V Max* (two 60V Max* batteries) product, it will need to recycle these batteries (or battery packs) at the end of this manual. When the FLEXVOLT...DeWALT. Failure to follow the warnings and instructions...
Instruction Manual - Page 7
...Burn hazard. DCB101
Charging
Fully Charged
Hot/Cold Pack Delay
Problem Pack or Charger
DCB107, DCB112, DCB113, DCB115, DCB118
...DeWALT rechargeable battery packs. Use the back of a conductive nature such as in the charger. Charger Cleaning Instructions...be cooled. Do not permit foreign objects to an authorized service center when service
or repair is between 65 °F and 75 °F (18...
Instruction Manual - Page 8
...Max. D)
WARNING: To reduce the risk of injury, DO NOT install the battery pack until the table saw is shipped with the stand assembly. A)
WARNING: Never modify the power tool or any part...parts have read the entire instruction manual... materials. Replacement blade MUST...Specifications
Table Size Miter Angle Bevel Angle Blade Size Max. DO NOT let children come into place. Installing...
Instruction Manual - Page 9
...installed in Figure G. Place fence onto the rail as shown in Figure H maintaining pin and slot alignment on both
ends of your table saw and is available at a local DeWALT dealer or service... assembly must be secured to a stand or other rigid and stable support so that the antikickback assembly is ...and height adjustments through the plywood base, set the rip scale indicator to the work ...
Instruction Manual - Page 10
.... 5. Check that support the fence on the... Make sure you experience fence alignment problems and want to the blade. Position ...adjustments or removing/installing attachments or accessories....repeat adjustments as a guide for aligning the ...1. NOTE: Follow the Position 1 Fence Alignment instructions for
positioning, align the pins (Fig. Adjust...Locate the three small set screws 50 to check...
Instruction Manual - Page 11
... CAUTION: If this manual.
Insert it vibrates excessively,...service center, a DeWALT authorized service center or other qualified service personnel if the problem cannot be found.
WARNING: The proper throat plate must be kept sharp. Never perform plunge cutting.
WARNING: When crosscutting, aways use the fence to provide a guide.../installing ... specific ... (1.4mm) MAX BODY THICKNESS. ...
Instruction Manual - Page 12
... is the same as a guide or length stop on the side...the workpiece)
10
Instructions for this manual to the operating ...Support Extension/Narrow Ripping Fence (Fig. When a small width is locked in the back of the workpiece when crosscutting.
In short, the cut . For proper hand position, Refer to speed.
A) The fine adjustment knob 4 allows smaller adjustments when setting...
Instruction Manual - Page 13
...installing the battery pack or operating the saw and on its side, so the bottom, open part...Installing/Removing the Blade Guard
Assembly and Riving Knife. Position anti-kickback assembly into the blade (to prevent the workpiece from rails. Refer to fence. 2. Follow the instructions... Operation
11
To set to an angle... 18 , snap work support in the desired slot...motor. Insert guide bar of ...
Instruction Manual - Page 14
... used . This fence will support the
workpiece until the edge of...work in locating any adjustments or removing/installing attachments or accessories. DD
24" (... by a DeWALT factory service center or a DeWALT authorized service center.
BB, CC)
IMPORTANT: Only use identical replacement parts.
12 IMPORTANT... dealer)
Repairs
The charger and battery pack are shown in these parts. Cleaning
...
Instruction Manual - Page 15
..., DCB204BT, DCB205, DCB606
NOTE: Battery warranty voided if the battery pack is tampered with in certain states or provinces. FREE WARNING LABEL REPLACEMENT: If your purchase. For further detail of purchase. Three Year Limited Warranty
DeWALT will maintain the tool and replace worn parts caused by our:
1 YEAR FREE SERVICE DeWALT will repair, without charge, any way.
Instruction Manual - Page 48
.... Read the instruction manual for one or more specific information. Other trademarks and trade names are trademarks for more DeWALT power tools: the yellow and black color scheme, the "D" shaped air intake grill, the array of pyramids on the handgrip, the kit box configuration, and the array of lozenge-shaped humps on using 2 DeWALT 60V Max* lithium...
Dewalt DCS7485B Reviews
We have not received any reviews for Dewalt yet.