Dell DSS 9630 Support and Manuals
Get Help and Manuals for this Dell item
View All Support Options Below
Free Dell DSS 9630 manuals!
Problems with Dell DSS 9630?
Ask a Question
Free Dell DSS 9630 manuals!
Problems with Dell DSS 9630?
Ask a Question
Popular Dell DSS 9630 Manual Pages
EMC Installation and Service Manual - Page 7
... of up to eight 2.5-inch HDDs (HDD0-HDD7). Server board (DSS 9600M) with DDR4 DIMM slots. 1
Overview
The DSS 9630 server contains a one third-width chassis supporting the Intel® Xeon® Scalable platform. Installation and Service Manual
7
Overview DSS 9630 features
No. Memory modules for CPU 2.
DSS 9630 server
Table 1. Memory modules for CPU 1. Node power distribution...
EMC Installation and Service Manual - Page 12
...Systems Management documents.
For information about updating drivers and firmware, see the Dell OpenManage Server Administrator User's Guide. To identify the version of the iDRAC Dell.com/idracmanuals documents. For information about setting up, using , and troubleshooting Dell OpenManage Essentials, see the operating system documentation.
Dell.com/openmanagemanuals
For information about...
EMC Installation and Service Manual - Page 13
... your system
Document
Location
agents that monitor system components, see the Server Troubleshooting Guide.
Dell.com/poweredgemanuals
Installation and Service Manual
13
Documentation resources Dell.com/poweredgemanuals
For information about updating the Fan Control Board firmware and setting the chassis type to accommodate either PowerEdge C6320 or PowerEdge C6320p sleds in...
EMC Installation and Service Manual - Page 15
... processor)
64 GB with the Manuals & Documents on the front panel The following table provides more information about environmental certifications, refer to the Product Environmental Datasheet located with dual processors (minimum one memory module per processor)
512 GB 1024 GB
NOTE: Maximum available RAM is processor dependent. Installation and Service Manual
15
Technical specifications
EMC Installation and Service Manual - Page 21
...
iDRAC Direct
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals
NOTE: To access iDRAC, ensure that has the shared LOM mode enabled.
NOTE: The Intel Quick Assist Technology (QAT) on your network infrastructure. If you must first configure the network settings based on the Dell EMC PowerEdge DSS 9630 is supported with chipset integration...
EMC Installation and Service Manual - Page 33
...system, the error message is displayed until the correct password is not locked through the Password Status option, you do not type the correct password in three attempts, the system displays the following message:
F2 = System Setup
Installation and Service Manual
33
Pre-operating system management applications
The following options are exceptions:
• If System Password is not set to...
EMC Installation and Service Manual - Page 46
... automatically changes as part of the iDRAC out-of the features on Self-test (POST). 3 On the System Setup Main Menu page, click iDRAC Settings. You can enable or disable various iDRAC parameters by default. NOTE: Accessing some of -band solution and Dell system embedded Unified Extensible Firmware Interface (UEFI) applications.
46 Installation and Service Manual Pre-operating...
EMC Installation and Service Manual - Page 57
.... Repeat Step 2 and Step 3 of the memory modules may not be installed properly.
Steps 1 Disconnect the cable from www.dell.com/support and follow the instructions
included in the compressed download file to start System Setup, and check the System Memory setting.
Installation and Service Manual
57
Installing and removing server components Allow the heat sink to cool for some...
EMC Installation and Service Manual - Page 59
... thermal grease to the top of the processor.
1 Ensure that you read the Safety instructions. 2 Before upgrading your system, download the latest system BIOS version from www.dell.com/support and follow the instructions
included in the compressed download file to install the update on all sides of the assembly and lift the heat sink out. 2 Remove...
EMC Installation and Service Manual - Page 60
... 30 seconds) for the heat sink to loosen
from www.dell.com/support and follow the instructions
included in After working inside your system. 60 Installation and Service Manual
Installing and removing server components Installing processor
Prerequisites 1 Ensure that you read the Safety instructions. 2 Before upgrading your system, download the latest system BIOS version from the processor...
EMC Installation and Service Manual - Page 61
...handy. 3 Before upgrading your system, download the latest system BIOS version from www.dell.com/support and follow the instructions
included in After working inside your system. NOTE: You can update the system BIOS using the Dell Lifecycle Controller. 3 Complete the procedure listed in Before working inside your system.
Installation and Service Manual
61
Installing and removing server...
EMC Installation and Service Manual - Page 69
...guidelines listed in the Safety instructions section. 2 Follow the procedure listed in the Before working inside your product documentation, or as directed by the online or telephone service and support team. Installation and Service Manual
69
Installing and removing server components See your warranty. You should only perform troubleshooting and simple repairs as authorized in Before...
EMC Installation and Service Manual - Page 71
... only perform troubleshooting and simple repairs as directed by the online or telephone service and support team. NOTE: Battery is operating properly. 4 Enter the correct time and date in the System Setup Time and Date fields. 5 Exit the System Setup. Only Dell certified service technicians must remove or install system battery.
1 Ensure that you read the Safety instructions. 2 Complete the...
EMC Installation and Service Manual - Page 108
4 Remove the securing screws from the mezzanine brackets. 5 Remove the support bracket and slot cover from the mezzanine card.
108 Installation and Service Manual Installing and removing server components
EMC Installation and Service Manual - Page 211
... inside your system section. Read and follow the safety instructions that is not authorized by Dell is not covered by your warranty. Installation and Service Manual
211
Installing and removing server components Next steps
1 Follow the procedure listed in the After working inside your system. 2 Install any device drivers needed for the card. NPIO card
Removing NPIO card...
Dell DSS 9630 Reviews
We have not received any reviews for Dell yet.