Cisco NMH405 Support and Manuals
Get Help and Manuals for this Cisco item
This item is in your list!
View All Support Options Below
Free Cisco NMH405 manuals!
Problems with Cisco NMH405?
Ask a Question
Free Cisco NMH405 manuals!
Problems with Cisco NMH405?
Ask a Question
Popular Cisco NMH405 Manual Pages
User Guide - Page 1
...)ZJ
1 This feature was introduced on the Cisco 2600 series, Cisco 3600 series, and Cisco 3700 series routers. Enhancements were added in Cisco IOS Release 12.2(2)XT and Cisco IOS Release 12.2(8)T and above.
This document includes the following sections: • Feature Overview, page 2 • Supported Platforms, page 45 • Supported Standards, MIBs, and RFCs, page 45...
User Guide - Page 5
...support routing protocol and bridging configurations.
it does not have to the routing or bridging function in a number of problems, such as one SVI can configure is created for a VLAN only when you wish to route between VLANs, fallback-bridge nonroutable protocols between this command to permit remote...by software; ...specifications,...Cisco 2600 Series, Cisco 3600 Series, and Cisco...
User Guide - Page 7
... run the same VTP version.
• You must have the same speed duplex and mode. Consistency checks are not supported in VLAN database mode.
• The VLAN database stored on the VTP version 2-capable switch. (VTP version 2 is supported in the NM-16ESW software, VTP version 2 forwards VTP messages in version 1:
Unrecognized Type-Length...
User Guide - Page 8
... is transferred to avoid configuration problems:
...in your configuration. Setting different STP port path...speed and duplex mode.
• Enable all modules support...services offered by itself, make interfaces incompatible for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Use the option that restricts unauthorized devices from gaining access to a LAN through publicly accessible...
User Guide - Page 9
... specification.)
Note To resolve Windows XP network connectivity and 802.1x authentication issues, read the Microsoft Knowledge Base article at this release, the Remote Authentication Dial-In User Service...authentication server must be running software that offered in the Microsoft Windows XP operating system. (The client is the supplicant in Cisco Secure Access Control Server version 3.0. 16...
User Guide - Page 24
...all interfaces in any traffic except that support Subnetwork Access Protocol (SNAP). You can configure one SPAN session with separate or overlapping sets of the switch. Only switched interfaces..., incoming traffic is an association of a destination interface with user-specified traffic types (ingress, egress, or both to discover Cisco devices that runs over Layer 2 (the data link layer)...
User Guide - Page 45
...• Cisco 3700 series
Finding Support Information for Platforms and Cisco IOS Software Images Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image support. Access Cisco Feature Navigator at the login dialog box and follow the instructions that appear. 16- You must have forgotten your username or password, click Cancel at http://www.cisco.com/go...
User Guide - Page 78
...describe access lists and the steps for Cisco IOS Release 12.2. The switch tests packets against the conditions in the Cisco IP Configuration Guide for finer granularity of Cisco IOS features not supported on...be applied to the "Configuring IP Services" chapter in an access list one by specifying an access list number or name and access conditions. Cisco IOS Release 12.2(2)XT, 12.2(8)T, ...
User Guide - Page 81
...
1. It also does not support filtering based on the specific keywords relative to each protocol type.
For more details on the minimize-monetary-cost type of service (TOS) bit.
You cannot reorder the list or selectively add or remove ACEs from a numbered list. No support for Cisco IOS Release 12.2. Cisco IOS Release 12.2(2)XT, 12...
User Guide - Page 93
...| host destination | any} [operator port]
class-map class-map-name
Step 4 match access-group acl-index-or-name
Step 5 Step 6 Step 7
end show class-map [class...supported for more information, see the "Classifying Traffic by Using Class Maps
You use to match against a specific traffic flow to name it .
and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco...
User Guide - Page 108
...
Router(config)# switchport voice vlan vlan-id
Purpose Configures the port as "access" and assigns a data VLAN. Layer 3 classification is already handled because the phone sets the Type of Service (ToS) bits in all media streams to an IP Precedence value of 5. (With Cisco CallManager Release 3.0(5), this is Layer 2 classification for Voice and Data
For...
User Guide - Page 159
...- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
aaa authentication dot1x
aaa authentication dot1x
To specify one of these keywords:
• enable-Uses the enable password for authentication.
• group radius-Uses the list of all Remote Authentication Dial-In User Service (RADIUS) servers for authentication.
• line...
User Guide - Page 176
...setting, use the dot1x port-control command in an EtherChannel, an error appears, and 802.1x is not changed.
• EtherChannel port-Before enabling 802.1x on Layer 2 static-access ports.
Defaults
The authorization state is no global configuration command for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
dot1x port-control
To enable manual... services to...is supported on...
User Guide - Page 242
... access control.
Set of actions taken by each DSCP specifies a particular per-hop behavior that are managed as a general means to take advantage of the cluster. Fields can be addresses, ports, DSCP value, and so on. CBWFQ-class-based weighted fair queuing.
DSCP-differentiated services code point. and 36-Port Ethernet Switch Module for Cisco...
User Guide - Page 244
...specification provides numerous monitoring, problem detection, and reporting capabilities. Protocol that supports the reservation of service...Remote Access Dial-In User Service. MIB agent specification described in voice packets. RSVP-Resource Reservation Protocol. Applications running on ) of switch ports as one network to signal the setup...transported using management software) so that uses...
Cisco NMH405 Reviews
Do you have an experience with the Cisco NMH405 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Cisco yet.
Earn 750 points for your review!