Bosch HGS5053UC Support and Manuals
Get Help and Manuals for this Bosch item
View All Support Options Below
Free Bosch HGS5053UC manuals!
Problems with Bosch HGS5053UC?
Ask a Question
Free Bosch HGS5053UC manuals!
Problems with Bosch HGS5053UC?
Ask a Question
Most Recent Bosch HGS5053UC Questions
Self-cleaning Does Not Allow You To Simultaneously Press Bake And Broil!
self-cleaning does not allow you to simultaneously press bake and broil! Unit just beeps 3 times whe...
self-cleaning does not allow you to simultaneously press bake and broil! Unit just beeps 3 times whe...
(Posted by perrea 9 years ago)
Bosch HGS5053UC Videos
Bosch HGS5053UC Freestanding Range
Duration: :58
Total Views: 95
Duration: :58
Total Views: 95
Popular Bosch HGS5053UC Manual Pages
Installation Instructions - Page 1
... are shown must be installed. WHAT TO DO IF YOU SMELL GAS:
• Do not try to your dealer. Contact surface must be performed by a qualified
installer, service agency or the gas supplier. Location-Check location where the range will be solid and level. Do not store or use any electrical switch; 30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with the LP...
Installation Instructions - Page 2
30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
Important Notes to the "off" position after using a
programmable timing operation. As children grow, teach them • Remove broiler pan, food and other utensils before
in the Use & Care Guide, read it
• Before installing the range in serious injuries and
4. range.
ANSI Z223.1-latest edition when ...
Installation Instructions - Page 3
... that screws do not penetrate electrical wiring or plumbing.
3 30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
Before Starting
Tools You Will Need
For leveling legs and Anti-Tip Bracket:
• Adjustable wrench or channel lock pliers
• 5/16" Nutdriver or Flat Head Screw Driver • Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry Drill...
Installation Instructions - Page 4
... is pre-set for LP/Propane gas 10 inch manifold pressure, inlet pressure must be at least 1 inch greater than 14 inches of the range and carefully ...valve. Examples: If regulator is installed.
Note: A minimum clearance of 1/8" is connected to 7 inches clearance from the floor.
30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with the gas supply line. A convertible pressure...
Installation Instructions - Page 5
... using NO MORE THAN 15ft./lbs.
of torque NOTE: Be sure to stabilize the left side of the range. 30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
the 1/2" flare union adapter with adjustable wrench before tightening the gas supply fitting and/or appliance conduit (Refer to Fig. 4e). The appliance must be necessary to check...
Installation Instructions - Page 7
30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with the turn of electric igniters should be adjusted a.
Each burner should ignite. Push in normal operation after air has been purged from the oven: a) Set oven to cycle once. d. Flame size can quickly turn knob to decrease flame size.
Electric Ignition Burners
Operation of the screw.
d) Within 60 seconds the...
Installation Instructions - Page 8
... call or write if you the rating of the burners, the type of the oven.
To adjust, loosen lock screw (see "3" illustration below .) If the flame is proper, set the oven to the warranty in illustration below ), reposition air shutter, and tighten lock screw. 30" GAS RANGE INSTALLATION INSTRUCTIONS
(For Models with Sealed Top Burners)
10. Care, Cleaning...
Instructions for Use - Page 5
... CAN/CGA B149.2, and National Electrical Code ANSI/NFPA No.70 - See the Statement of an error, the display flashes and beeps continuously. Connect only to the Installation Instructions for , your appliance is
English 2 Do not repair or replace any part of the appliance unless specifically recommended in this appliance. Read all servicing to be used and cared for...
Instructions for Use - Page 6
... a range, shall not be performed by a qualified service technician. Turn off valve is not a "do-it-yourself" procedure.
Aluminum foil linings may result in carbon monoxide poisoning and overheating the appliance. Follow the gas supplier's instructions. • If you where the gas shut-off the appliance and disconnect the circuit at the circuit breaker box.
Installing...
Instructions for Use - Page 10
... removing oven racks from damage and spills.
To replace, fit the rack onto the guides on the oven bottom. Cooktops
300 Series
500 Series
Accessories
Rack
Flat Oven Rack
This rack can be...are installed exactly per installation instructions and not backwards or upside down. Removing and Replacing Oven Racks
To remove, pull the rack forward until it stops. REMOVE ALL OVEN RACKS and parts ...
Instructions for Use - Page 13
...Installing these liners may result in risk of degrees offset between the original factory temperature setting and the current temperature setting... For accurate information, write the Extension Service, Colorado State University, Fort Collins,... of cooking time.
• Do not set any part of cooking times.
Aluminum Foil
Do not ...high altitude food preparation guide you have made the...
Instructions for Use - Page 28
... ignites and then turn control knob to make range appear not level.
Service
Before Calling Service
Troubleshooting Chart
Oven Problem Oven door is locked and will be operable. Poor installation. Surface control knob was not completely turned to your house.
Range power cord is used. Electrical power outage (electric ignition models only).
Make sure there is sagging or...
Instructions for Use - Page 29
...example this manual or read the instructions "Entire appliance does not operate" in Setting Oven Controls. If flames or excessive smoke are set .
...models, the convection fan runs while the oven is not working properly. Excessive spillovers in oven door. Oven light does not turn off " the smell more quickly. Service wiring is not set properly for broiling.
Use the flat part...
Instructions for Use - Page 30
... the time of the manual.
Try the bake or broil feature again. If the F code error repeats, remove power from appliance, wait 5 minutes and then repower appliance and set clock for service. Possible Causes and Suggested Solutions
Oven control has detected a fault or error condition. Press CANCEL to Obtain Service or Parts
To reach a service representative, see the contact...
Instructions for Use - Page 32
... comply with any applicable state, local, city, or county electrical, plumbing and/or building codes, regulations, or laws, including failure to install the product in strict conformity with the Product; correction of installation problems (you should contact the nearest Bosch authorized service center. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL...
Bosch HGS5053UC Reviews
We have not received any reviews for Bosch yet.