Black & Decker LST540 Support and Manuals
Get Help and Manuals for this Black & Decker item
View All Support Options Below
Free Black & Decker LST540 manuals!
Problems with Black & Decker LST540?
Ask a Question
Free Black & Decker LST540 manuals!
Problems with Black & Decker LST540?
Ask a Question
Popular Black & Decker LST540 Manual Pages
Instruction Manual - Page 1
...experience a problem with your...battery pack voltage (measured without a workload) is 36. if not, the
motor will overheat (page 7). • When replacing the line, use only with an agent.
KEY INFORMATION YOU SHOULD KNOW: • The guard must be installed before returning this manual for choosing Black+Decker!
40v Max* Lithium Trimmer/Edger
INSTRUCTION MANUAL
Catalog Number
LST540...
Instruction Manual - Page 2
... and PREVENTING PROBLEMS. The symbols below are available for which it is attempted. Motors in damp or... hub or spool. • REMOVE BATTERY - Do not use , when replacing line, or prior to read and understand this Instruction Manual for which ...battery is installed. Follow all times when battery is installed. • USE THE RIGHT appliance - Follow instructions in moving parts. ...
Instruction Manual - Page 3
...part that can not be properly repaired or replaced by this manual.
• DO NOT immerse appliance in
wet locations
WARNING: Do not use appliance if
the switch trigger does not turn the appliance on or off button
4.
Spool... Edge guide
11. Guard
12. Spool housing... protection
Read instruction manual before use ...8226; CHECK DAMAGED PARTS - Battery
5. Some examples of...
Instruction Manual - Page 4
...specifically designed to an authorized service center.
• Do not disassemble charger; iiCMNhSPAtORRRGutECARtNiStONSSAFFEOtRYBAttERY
SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for any uses other than charging designated Black+Decker rechargeable batteries... wire size (AWG or American Wire Gauge) for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25 26...
Instruction Manual - Page 5
... to service center for possible special disposal instructions.
• Do not open the battery pack for Li-ion batteries is being charged. 4. WARNING: Burn hazard. Battery liquid may ignite the dust or fumes.
• If battery contents come in a fire. Insert the battery pack into an appropriate outlet before inserting the battery pack. 2. Provide fresh air. BLACK+DECKER Battery...
Instruction Manual - Page 6
...battery while in the trimmer and during use: • Press the state of charge indicator. Always unplug the charger from charger cavities. Unplug charger before attempting to a service... Problems are indicated by plugging in the cavity. The charger and battery pack may also charge a partially used to open the battery pack for recycling. Move charger and battery pack to a service ...
Instruction Manual - Page 7
... guard. B
• Keeping the guard square to the trimmer head slide it clockwise. SAVE THESE INSTRUCTIONS assembly and adjustment
WARNING: Before assembly,
make sure that the guide rails (D1) on the guard (11) are correctly aligned with the screw (E1) (figure E). Installing and Removing the Battery Pack
WARNING: Make sure the
switch is switched off...
Instruction Manual - Page 8
...position shown in figure K. H
Setting trimming or edging mode (figure I
I1
7
H1
J
Releasing the cutting line
In transit, the cutting line is not: • Remove the battery from the trimmer. • Press and hold the...line.
NOTE: The Auto Feed System may not operate correctly if edge guide is all the way down, an audible click will only rotate in the rotating line or spool...
Instruction Manual - Page 9
... cutting tips • Use the tip of the line. WARNING: Never attempt to create edges
or trenches. • Guide the trimmer as fences, houses and flower beds for any other...line. do not exceed 12 inches (304.8 mm) high. • Keep trimmer tilted toward the area being cut from hard surfaces
use , the tips of the nylon lines will become frayed and worn and the special self feeding spool...
Instruction Manual - Page 10
...the proper length. NOTE: Other replacement parts (guards, spool caps, etc.) are correctly located.
REPLACING THE SPOOL (figures O, P, Q, R)
WARNING: Remove the battery
from the spool housing on the line spool
cap, as shown in figure P1.
• Insert the line end through Black+Decker service centers. P
becoming trapped under the spool. • Align the spool cap tabs with sap or...
Instruction Manual - Page 11
... a file.
11
Keep the air intake slots clean to malfunction. Using line other than Black+Decker factory wound spools. For best results, factory wound spools are likely to wind the line on as described in layers. To keep the line from the appliance before making any maintenance. 1. Plastic parts may be cleaned by depressing lugs and pressing into...
Instruction Manual - Page 12
... with the tip of trigger depression affects speed. • Remove battery from the spool.
Use the edge guide if needed to ensure proper space is fed when the line shortens to park the lines in figure T. The level of the line (7 inches (177.8mm) from the spool). Troubleshooting
PROBLEM
Trimmer runs slowly. Solution
• Fully depress the variable speed trigger...
Instruction Manual - Page 13
... recycle the battery (or battery pack) at no guarantee that interference will not occur in a particular installation. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black+Decker location nearest you have already been paid by Black & Decker (U.S.) Inc.,
701 E. Towson, MD 21286 U.S.A.
13 RBRC™ in cooperation with the instructions, may not...
Black & Decker LST540 Reviews
We have not received any reviews for Black & Decker yet.