Apple M9594G - Memory - 1 GB Support and Manuals
Get Help and Manuals for this Apple item
View All Support Options Below
Free Apple M9594G manuals!
Problems with Apple M9594G?
Ask a Question
Free Apple M9594G manuals!
Problems with Apple M9594G?
Ask a Question
Popular Apple M9594G Manual Pages
Replacement Guide - Page 1
... pairs of 512 MB fully buffered, dual inline memory modules (FBDIMMs) in a different colored pair.
073-1062 Rev. On each . Mac Pro
Memory (FB-DIMM)
Replacement Instructions
Follow the instructions in this document carefully. Note: The Mac Pro computer has two memory riser cards with a minimum of 1 GB of memory, installed as a pair of equal size from the...
Replacement Guide - Page 2
... it while it to install items inside the computer. Warning: Always shut down before opening it is not compatible with Mac Pro. You must fit these specifications: • 667 MHz, FB-DIMMs • 72-bit wide, 240-pin modules • 36 devices maximum per DIMM • Error-correcting code (ECC) Memory from the computer except...
Replacement Guide - Page 3
Be very careful when handling them. 7. Remove the access panel and place it on the back of the access panel and the enclosure can be sharp.
Warning: The edges of the computer. Hold the side access panel and lift the latch on a flat surface covered by a soft, clean cloth. Unplug the power cord. 6. Mac Pro Memory (FB-DIMM) 5.
Replacement Guide - Page 4
Mac Pro Memory (FB-DIMM)
Locate the FB-DIMMs.
3. Carefully lay the computer on its side so that the open side faces up on a soft, clean cloth. Holding the memory riser card by the two finger holes, pull it out of the memory cage and place the card DIMM-side-up . 2. Removing the Installed FB-DIMM
1.
Replacement Guide - Page 5
Mac Pro Memory (FB-DIMM)
Never attempt to the sides, and remove the FB-DIMM from the DIMMs. Doing so could damage the DIMM. Open the ejectors on either side of the DIMM. 4. Warning: FB-DIMMs carry heatsinks on the DIMM slot by pushing them out to remove the heatsinks from the riser card.
Replacement Guide - Page 6
... until the ejectors snap back up position before replacing the access panel. Mac Pro Memory (FB-DIMM) Insert the replacement riser card into position in the enclosure.
2. Installing the Replacement FB-DIMM
1. Closing the Computer
1. Replace the access panel. Operating the computer when it is open or missing parts can damage it is down to close and...
Replacement Guide - Page 7
... has been made to ensure that the information in the U.S. Mac Pro Memory (FB-DIMM) All rights reserved. and other countries. Apple Computer, Inc. © 2006 Apple Computer, Inc. Apple 1 Infinite Loop Cupertino, CA 95014-2084 USA + 1 408 996 1010 http://www.apple.com Apple, the Apple logo, Mac, Macintosh, and Mac Pro are trademarks of...
Apple M9594G Reviews
We have not received any reviews for Apple yet.