Amana UXI0600DYS Support and Manuals
Get Help and Manuals for this Amana item
View All Support Options Below
Free Amana UXI0600DYS manuals!
Problems with Amana UXI0600DYS?
Ask a Question
Free Amana UXI0600DYS manuals!
Problems with Amana UXI0600DYS?
Ask a Question
Popular Amana UXI0600DYS Manual Pages
Warranty - Page 1
... and only in accordance with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need service, first see the "Troubleshooting" section of the Use & Care Guide.
Repairs when your major appliance is used in -warranty service. The cost of repair or replacement under this limited warranty. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO...
Dimension Guide - Page 1
...; elbow
= 5.0 ft (1.5 m)
1 - 600 CFM and 1200 CFM In-Line Blowers for planning purposes only.
Vent Piece
Equivalent Length
45° elbow
2.5 ft (0.8 m)
12 32.9 cm)
90° elbow
5.0 ft (1.5 m)
14 37.3 cm)
Bottom (inlet) view
26¹⁄₈" (66.4 cm)
The maximum equivalent vent lengths are for Range Hoods
PRODUCT MODEL NUMBERS
UXI0600DY
UXI1200DY
Electrical...
Installation Instruction - Page 1
... messages in this manual and on your appliance. INSTALLATION INSTRUCTIONS 600 CFM AND 1200 CFM IN-LINE BLOWERS
FOR RANGE HOODS
INSTRUCTIONS D'INSTALLATION VENTILATEURS EN LIGNE AVEC DÉBIT DE 600 PI³ ET
1200 PI³ POUR HOTTES D'ÉVACUATION
Table of Contents/Table des matières
IN-LINE BLOWER SAFETY 1
INSTALLATION REQUIREMENTS 3 Tools and Parts 3 Location Requirements...
Installation Instruction - Page 2
...settings. BE CAREFUL TO PREVENT BURNS. you have questions, contact the manufacturer.
■ Before servicing or cleaning the unit, switch power off the burner. READ AND SAVE THESE INSTRUCTIONS...know how to the service panel.
■ Installation work and electrical wiring ...Society for examination and/or repair.
■ Sufficient air ... with all applicable codes and standards, including...
Installation Instruction - Page 3
...supplied Remove parts from packages. strain relief connectors ■ 1 -
Check that all governing codes and ordinances. flat washers ■ 6-wire connector assembly for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with any tools listed here. Have a qualified technician install the in -line blower motor...
Installation Instruction - Page 4
... capable of supporting the weight of makeup air systems when using ventilation systems greater than 1 elbow is needed for specific requirements in -line blower system inlet and outlet openings are 10" (25.4 cm) round. The specified CFM varies from cross-members tied to locale. Mount from locale to trusses.
B. Typical In-line Blower System Installations
A 10...
Installation Instruction - Page 5
...; Wire sizes must conform with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes and ordinances.
5
The model/serial plate is required.
■ If the...piece used , it is recommended that a qualified electrician determine that the electrical installation is adequate.
Installation Instruction - Page 6
...framing may be strong enough to support the weight of the in-line blower system (50 lb [22.6 kg...blower system must be required. INSTALLATION INSTRUCTIONS
Prepare Location
■ Before making cutouts, make the blower motor housing easier to mount, the blower motor assembly can result in -line blower system to the structure. Motor electrical plug
The in -line blower motor housing and set...
Installation Instruction - Page 7
... connections.
8.
With the range hood mounted (see the range hood installation instructions), run the ¹⁄₂" (1.3 cm) wiring conduit between the in -line blower
housing and range hood (see the range hood installation instructions) to the connector on the in -line blower housing terminal box. Replace all necessary cuts for the vent system. Disconnect power.
2. Motor...
Installation Instruction - Page 8
... wire from the wiring conduit to the wires from the home power supply using UL listed wire connectors (see the range hood installation instructions).
4. Blue wires G. Reinstall the in -line blower housing and
secure it with 10 mounting screws. Connect the wires from the 6-wire connector assembly to the green (or bare) ground...
Installation Instruction - Page 9
If you need replacement parts If you need to order replacement parts, we recommend that you can write to Whirlpool Canada LP with : ■ Features and specifications on our full line of appliances.
■ Installation information.
■ Use and maintenance procedures.
■ Accessory and repair parts sales.
■ Specialized customer assistance (Spanish speaking, hearing impaired, ...
Installation Instruction - Page 10
... "Troubleshooting," you on how to instruct you may find this information on the model and serial number label located on the product. You will pay for in materials or workmanship. If outside the 50 United States and Canada, contact your major appliance. Service calls to correct the installation of your major appliance, to replace or repair house...
Amana UXI0600DYS Reviews
We have not received any reviews for Amana yet.