Acer VW237Q Support and Manuals
Get Help and Manuals for this Acer Computers item
Popular Acer VW237Q Manual Pages
User Manual - Page 2
...specifically disclaims the implied warranties of Acer Incorporated. No part of Acer Incorporated. Acer LCD Monitor User Guide
Model number Serial number Date of purchase Place of purchase
Acer and the Acer ..., in this manual or supplementary documents and publications.
English
Copyright © 2018. The serial number and model number are used herein for a particular purpose...
User Manual - Page 5
... operating instructions Do not insert the plug into the extension cord does not exceed the extension cord ampere rating. The grounding pin is properly grounded before inserting the power cord plug. If you to replace the power cord set . Refer all products plugged into the product • the product was exposed to service this...
User Manual - Page 9
.... Via Lepetit, 40, 20020 Lainate (MI) Italy Tel: +39-02-939-921 ,Fax: +39-02 9399-2913 www.acer.it
Product: Trade Name: Model Number: SKU Number:
LCD Monitor Acer VW237Q VW237Q XXXXXX; ("x" = 0~9, a ~ z, A ~ Z, or blank)
We, Acer Incorporated, hereby declare under our sole responsibility that the product described above is in
conformity with the relevant Union...
User Manual - Page 10
... 1500 CA 95110, U. A. Tel : 254-298-4000 Fax : 254-298-4147
www.acer.com
Federal Communications Commission Declaration of Conformity
This device complies with Part 15 of Responsible Party:
Contact Person: Phone No.: Fax No.:
LCD Monitor
VW237Q
VW237Q xxxxxx ("x" = 0~9, a ~ z, or A ~ Z)
Acer America Corporation
333 West San Carlos St. The following two conditions: (1) this device...
User Manual - Page 11
...(for selected models)
2
Screen position adjustment
3
Connecting the adapter and AC Power cord
3
Power saving
Display Data Channel (DDC)
Connector pin assignment
4
19-pin color display signal cable
4
20-pin color display signal cable
5
Standard timing table
6
Installation
7
Users controls
8
Panel controls
8
Using the Shortcut Menu
9
The Function page
10
Troubleshooting
15...
User Manual - Page 12
... Cable (Optional)
DP Cable (Optional)
LCD Monitor V7 series-VW237Q
USER GUIDE
HDMI cable (Optional)
AC Power cord
Audio Cable (Optional)
"This specification is for universal use and real spec may vary by regions and countries"
English
Unpacking
Please check that the following items are present when you unpack the box, and save the...
User Manual - Page 14
... For units using 120 V AC: Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.
• For units using 220/240 V AC: Use a cord set should have the appropriate safety approvals for your area.
• ... ON state is around 3 seconds. Power saving
The monitor will be installed.
No user-adjustment is required.
• Plug one end of H05VV-F cord and plug rated 10 A/250 V....
User Manual - Page 18
ptional: Connect the audio input socket (AUDIO IN) of the graphics card on the computer. Please check user manual for audio output model. Connect the signal cable to a properly grounded AC outlet. Insert the monitor power cable into the power port at... monitor and the line-out port on the signal cable connector. 3. Note: Audio output is only for more instruction. English
Installation
1.
User Manual - Page 19
... Power
Input Switch Hot Key Main Menu Hot Key Power on/off the monitor
VESA Adaptive SYNC (HDMI/DP):
It can allow a VESA Adaptive SYNC supported graphics source to dynamically adjust display refresh rate based on typical content frame rates for power efficient, virtually stutter free and low-latency display...
User Manual - Page 20
... only. Hot Key3
Input Switch Hot Key
4. Press the MENU key to adjust the settings of your preferred brightness setting . You can be used to open the OSD.
Hot Key1
Modes, Brightness, Volume,... Brightness, Contrast, Volume,
Gamma, Blue Light, Over Drive
3. Actual product specifications may vary.
Brightness
100
When you are done, press the back button to adjust the picture quality,...
User Manual - Page 22
..."Low Blue Light Content" standard.
9. Black Boost: Adjust the black level from 0 to 100 Note: Sets the degree of the original source to 100 Note: Adjusts the balance between light and dark areas.
7. ...the best state and has been tested by increasing the brightness without changing lighter shades.
8. Note: Set to "On", will be based on or off. Blue Light: Filters out blue light to protect...
User Manual - Page 24
...6. Transparency: The transparency can see the V Frequency to enter it .
3. Note: OSD Locked:
• Set the OSD Lock to "On" by the OSD option and press "Enter" to execute the All Key lock function...of the screen.
• LED lights will be restored to prompt "OSD Locked" message. Language: Set the OSD menu language.
5. OSD timeout: Adjust the delay before turning off . OSD Unlocked:
&#...
User Manual - Page 25
...VGA IN, HDMI, DP.
5. Input: Select the source from the OSD. Note: Surround application must set through the software on to be sent via software.
9. Turn on the PC Note: DDC/CI, ...HDMI Black Level Quick Start Mode
HDMI On Full
On Normal Off
1. Wide mode: You can support auto search for Display Data Channel/Command Interface, which screen aspect you are Aspect and Full.
7. ...
User Manual - Page 26
... you turn on User mode . Press up or down button to select "Save Setting to recall the settings in the future when you , save them and system will be able to ..." Save Setting to open the OSD.
2. User
Mode: sRGB Mode: Reading Mode: Darkroom
1. Press the MENU key to User mode: There are...
User Manual - Page 27
... OSD menu, adjust brightness and contrast to maximum or reset to see if you can self-diagnose the problem.
Troubleshooting
Before sending your LCD monitor for servicing, please check the troubleshooting list below to their default setting.
Check the power switch. Amber
Check if the AC power cord is properly connected at the back of...
Acer VW237Q Reviews
We have not received any reviews for Acer yet.