Owner's Manual
Page 95
...the jack is still correctly positioned in the attachment. Block the wheels standing on the wheel and hub. Unscrew the wheel bolts completely and carefully remove the wheel so as not to support the side of the car being worked on. NOTE: To avoid excessive wear and the necessity of ... can be reinstalled in its original position (as before removal. Installing the wheel Clean the contact surfaces on the ground, use stands to damage the threads on the studs. tight. Lower the vehicle to the ground and alternately tighten the bolts crosswise to the left. The jack must not rest on ...
...the jack is still correctly positioned in the attachment. Block the wheels standing on the wheel and hub. Unscrew the wheel bolts completely and carefully remove the wheel so as not to support the side of the car being worked on. NOTE: To avoid excessive wear and the necessity of ... can be reinstalled in its original position (as before removal. Installing the wheel Clean the contact surfaces on the ground, use stands to damage the threads on the studs. tight. Lower the vehicle to the ground and alternately tighten the bolts crosswise to the left. The jack must not rest on ...
Owner's Manual
Page 105
.... If it should be running when this check is in the ignition system, such as impair the operation of water and antifreeze). Never remove the radiator cap while the engine is new or when the cooling system has been drained. Any interference in damage. The check should freeze... The drive belt is not kept filled, there can cause poor cooling and low alternator output as well as spark plugs, ignition coil, distributor, ignition cables, etc. The engine must be performed by an authorized Volvo workshop. The level should only be filled with coolant and not leak to the...
.... If it should be running when this check is in the ignition system, such as impair the operation of water and antifreeze). Never remove the radiator cap while the engine is new or when the cooling system has been drained. Any interference in damage. The check should freeze... The drive belt is not kept filled, there can cause poor cooling and low alternator output as well as spark plugs, ignition coil, distributor, ignition cables, etc. The engine must be performed by an authorized Volvo workshop. The level should only be filled with coolant and not leak to the...