Makita EY2650H25H Support and Manuals
Get Help and Manuals for this Makita item
View All Support Options Below
Free Makita EY2650H25H manuals!
Problems with Makita EY2650H25H?
Ask a Question
Free Makita EY2650H25H manuals!
Problems with Makita EY2650H25H?
Ask a Question
Popular Makita EY2650H25H Manual Pages
EY2650H25H Instruction Manual - Page 2
... an angle of parts 9
Assembly and adjustment 10
Before start First Aid ON/START OFF/STOP Emergency stop 15
Operation 17
Servicing instructions 17
Storage 23...instructions manual. Protective gloves must be worn!
Fuel (Gasoline) Engine-manual start of knowledge and experience.
English
(Original instructions)
Thank you to obtain the best possible result from your MAKITA...
EY2650H25H Instruction Manual - Page 3
...of falling objects. Operate the equipment only if you are part of the prescribed equipment and must always be experienced with... whilst under 18 years must be replaced at regular intervals for basic instructions to accept liability for the purpose ... the face from flying debris and stones. Persons over the instruction manual.
-- Perform all
work calmly and carefully. Never use the...
EY2650H25H Instruction Manual - Page 5
...; Refuelling • Maintenance • Tool replacement
3 meters Do not inhale fuel vapor.... any engine problems.
-- All protective installations and guards ...saw chain and guide bar clear of ... devices for the inspection and repair.
-- If there is ...or doubt, ask Makita authorized service center for malfunction. ...hold the cutter with the instructions. -- Change and clean protective...
EY2650H25H Instruction Manual - Page 7
... nervous system. Remove the spark plug cap. Maintenance instructions
-- Incorrect repair and poor maintenance can shorten the life of the equipment and increase the risk of injured persons -- Before doing any liability for such work is poor, ask Makita authorized service center to sharpen it or replace it may experience injury to those activities as...
EY2650H25H Instruction Manual - Page 13
...engine parts, which will have to P 18)
Recommended oil: SAE 10W-30 oil of oil pipe.
-- For reference, the oil refill time is oil in Replacement of sand or dust. If the oil changes in troubles.
...be refilled excessively. Remove dust or dirt near the oil refill port, and detach the oil cap.
-- Set the engine level, remove oil cap (Fig. 1), and check to remove the oil cap. Keep the ...
EY2650H25H Instruction Manual - Page 14
...a special container in the dusk or on the tank cap, replace it will cause excessive carbon accumulation or mechanical troubles. -- Point 2 in the open air. Fuel may cause skin ...of deteriorated oil will contaminate
the engine. EY2650HG:This model adapts for use an automobile gasoline (regular gasoline or premium gasoline).
Replace it is tilted leads to prevent foreign matter from the...
EY2650H25H Instruction Manual - Page 16
... and allow it , please contact Authorized Service Center. OPEN
STOP B
A
ADJUSTMENT OF LOW-SPEED ROTATION (IDLING)
When it is necessary to start . Set the low-speed rotation to the attachment ...is generally adjusted before the choke lever is increased to start engine.
• Once engine starts, set the I-O switch (A) to the OPEN position.
• Implement startup step 5) and complete warm...
EY2650H25H Instruction Manual - Page 18
... Makita authorized service center to sharpen it.
ATTENTION: In general, the engine main unit and engine oil still remain hot just after 20 operating hours, and subsequently every 50 operating hours
Recommended oil:
SAE10W-30 oil of operation.
Lubricating moving parts.
Interval of replacement: Initially, after the engine is worn, bent, cracked or deformed, replace the guide...
EY2650H25H Instruction Manual - Page 25
... electric system. Then, start the engine.
25 Attach securely. Clean it . Clean it . Replace the guide bar. For repairs, contact Authorized Service Agent or local dealership. State of starter rope.
Insufficient warm-up operation. The chain oil feed port is improperly set choke lever to CLOSE
Probable cause (malfunction) Failure to saw chain tension.
High...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 3
... A09
Part No. Description
XTM0000001 GEAR CASE A
XTM0000002 BALL BEARING 608
XTM0000003 GEAR SHAFT
XTM0000028 BEVEL GEAR SET
XTM0000005 ...GUIDE BAR
165700-0
10" GUIDE...Makita Dolmar Makita Dolmar
No. SOCKET HEAD BOLT M5X10
XTM0000011 HB BOLT 6X8
XTM0000012 GEAR CASE B
XTM0000013 BALL BEARING 6001DDW
XTM0000014 SPROCKET
XTM0000015 SPEOCKET WASHER
XTM0000016 H.S. 1 EY2650H25H...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 6
...-5 455313-8 451592-6 638714-7 638713-9 452071-7 266326-2 188832-6 803K76-0 814E64-6 911233-1 168478-4 195143-2
Description MAKITA LOGO LABEL DOLMAR LOGO LABEL CONTROL LEVER ASSEMBLY CONTROL LEVER ASSEMBLY TAPPING SCREW BIND PT 3X16 SWITCH COVER SWITCH LEVER LEAF SPRING LEVER CASE SET CLAMP 24 H.S.H.BOLT M5X14 WITH WR LOCK LEVER TORSION SPRING 7 CONTROL CABLE TORSION...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 8
EY2650H25H ME246.4 Tech Bulletin
3 EY2650H25H...3 126 3 128 3 129 3 129 3 130 3 216 3 217 3 223 3 224 3 231 3 232 3 233 3 234
Part No. 126202-1 265791-2 443171-4 443169-1 266618-9 126198-6 162346-3 213540-1 424316-3 422099-9 325665-0 442153-3 266787-6 451825-9 451729-5 213547-7 ... 12 LEAD UNIT LEAD UNIT H.S.H.BOLT M5X14 WITH WR MAKITA CYLINDER COVER DOLMAR CYLINDER COVER H.S.H.BOLT M5X14 WITH WR...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 10
...SHOE TENSION SPRING 6 WASHER 6 CONED DISK SPRING HEXNUT M8-13 FLYWHEEL TUBE HEX. EY2650H25H ME246.4 Tech Bulletin
4 89 4 90 4 91 4 92 4 93 4 94... 132 4 133 4 134 4 135 4 136 4 183 4 184 4 185 4 187 4 188 4 189
Part No. 451735-0 922228-9 450569-8 961052-5 210111-5 962151-6 165747-4 168809-7
168609-5 266864-4 267817-6 126135-0
125518-1 ...BUFFER RUBBER RECOIL STARTER SET STARTER KNOB DAMPER TAPPING...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 11
... indented.
4 190 4 191 4 192 4 193 4 194 4 196 4 220 4 220 4 222
Part No. 451937-8 232258-5 444023-2 451733-4 922223-9 816565-0 803K90-6 803K91-4 819432-8
Description REEL SPIRAL SPRING STARTER ROPE STARTER CASE H.S.H.BOLT M5X16 WITH WR MAKITA LOGO LABEL EY2650H MODEL NO. LABEL ME-246.4 MODEL NO. Section Fig. No. LABEL CAUTION TAG
11 11 11 11...
Makita Parts Breakdown EY2650H25H and ME-246.4 - Page 16
...18/16
16
EY2650H25H ME246.4 Tech Bulletin
6 EY2650H25H
Fuel Tank, ...Carburetor
Products with multiple versions are listed in subsiding order with the newest version on top not indented.
6 173 6 175 6 176 6 177 6 178 6 179 6 180 6 181 6 182 6 197 6 198 6 199 6 200 6 201 6 202 6 203 6 204 6 205 6 206 6 207 6 208 6 209 6 210 6 211 6 212 6 213 6 214 6 215 6 320
Part...
Makita EY2650H25H Reviews
We have not received any reviews for Makita yet.