Garmin GT23M-TH Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GT23M-TH manuals!
Problems with Garmin GT23M-TH?
Ask a Question
Free Garmin GT23M-TH manuals!
Problems with Garmin GT23M-TH?
Ask a Question
Popular Garmin GT23M-TH Manual Pages
Installation Instructions - Page 1
... in a safe
place. Thru-Hull Transducer
Installation Instructions
Important Safety Information
WARNING See the Important Safety and Product Information guide in the product box for the safe and prudent operation of your vessel. The device must be mounted in
 front of the surface. CAUTION Failure to http://my.garmin.com. • Keep the original...
Installation Instructions - Page 2
...specific point on the shape of wood. NOTE: The maximum cutting angle of the fairing block is necessary to mount the transducer...Installation Instructions
Thru-Hull Transducer in a Cored Hull with a Fairing Block If the deadrise angle of your transducer parallel to the water line for the transducer stem (Drilling the Transducer... on the table so the cutting guide rests against the fence and the ...
Installation Instructions - Page 3
...around the holes. Installing the Transducer with a Fairing Block It is moving and could result in the device rotating while the boat is recommended that two installers complete these instructions if you can mount...
the hole. 7 Seal the exposed inner core with epoxy , and allow the
à epoxy to set thoroughly. 8 While holding a drill with a 9 mm (3/8 in.) bit plumb, drill the anti-rotation...
Installation Instructions - Page 4
... outside the hull to prevent damage to the fiberglass. 5 If you taped over the pilot hole, use a utility knife to mount the transducer on a boat that two installers complete these instructions, with a Fairing Block It is recommended that does not have a cored fiberglass hull. 1 Select a mounting location without a Fairing Block It is recommended...
Installation Instructions - Page 5
... the nuts to prevent damaging the hull. 1 Apply marine sealant to the base of the anti-rotation bolts and
transducer stem , and to the sides of the transducer plate Á
that two installers complete these instructions if you can mount the device without surface irregularities or
obstructions. 3 Using the template, mark the location of...
Installation Instructions - Page 6
... not over -tighten the hull nut.
5 From inside the boat.
1 Secure the bushings to the anti-rotation bolts and
À
Á
transducer stem .
Â
Metal Boat Hull Installation Instructions
Thru-Hull Transducer in a Metal Hull with a 13 mm (1/2 in.) bit plumb, drill the anti-rotation bolt holes through the hull from outside the hull...
Installation Instructions - Page 7
... location. 9 Sand and clean the area around the holes.
3 Apply marine sealant to the base of the transducer stem Ã
and anti-rotation bolts, and the side of the isolation plate that two installers complete these instructions if you must use the included isolation plate.
1 Secure the bushings to the water surface.
7 While...
Installation Instructions - Page 8
... the fouling is necessary to your transducer. These trademarks may not be in the water, check for an extended period of your vessel every six months. or its subsidiaries
www.garmin.com/support
Item
À Á Â Ã
Description Chartplotter Sounder Power Source Y-cable
Maintenance
Testing the Installation
NOTICE You should apply a water-based...
Garmin GT23M-TH Reviews
We have not received any reviews for Garmin yet.