?i Am Trying To Open One Of My Autocad 2008 Files

I get the following message and instantly booted out; "fatal error unhandled c000000dh exception at 7303fac3h" any suggestions on how to fix the problem? All other files are fine.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by sanyitivadar on May 7th, 2015 11:07 AM

This answer was accepted by the poster of the original question.

sanyitivadar

Member since:
May 7th, 2015

Points: 1,100

1,100
points

There are several methods how to try to open a corrupted AutoCAD drawing file.

Use the Recover command
Open the file and press ESC key just before Regeneration/Error message, save to DXF, load, save as DWG, Audit
Insert the complaining DWG as a block into an empty drawing
Open/save the DWG in an older version of AutoCAD or AutoCAD LT or Actrix
In case solution wasn't effective, apply software for recover corrupt .dwg files DWG Repair Toolbox

Answer #2: Posted by TechSupport101 on May 5th, 2015 7:09 PM

TechSupport101

Member since:
May 24th, 2013

Points: 12,171,325

100
points

Quite a number of fators can result in this. If it will not open, try opening the file by going to the application menu>Drawing Utilities>Recover... Otherwise, obtain further assistance on this here.

www.satechhelp.co.za

Answer #3: Posted by jarinikula on May 12th, 2015 7:04 AM

jarinikula

Member since:
May 12th, 2015

Points: 100

100
points

Perform the following steps if the file cannot be opened at all...

1.Open a blank DWG and run the RECOVER command. Select the problematic file. AutoCAD will attempt to recover the file and open it.

2.Open a blank DWG and run the RECOVERALL command. Select the problematic file. AutoCAD will attempt to recover the file and open it.

3.Open a blank DWG and run the INSERT command. Select the problematic file and see if it will insert. If it does, then run EXPLODE and select the inserted block. Run AUDIT and PURGE commands, and then use SAVEAS to create a new DWG.

4.Look in the same directory where the DWG resides and see if there is a BAK file of the same name. If so, rename the BAK extension to DWG and see if the file can then be opened.

5.Look in C:\Windows\Temp for files with an SV$ extension. If any exist with a similar name to the corrupted DWG file, then rename the extension to DWG and see if it can then be opened.

6.Go to your backup system and restore the file from a time before it became corrupted.

Answer #4: Posted by jacobylott on May 29th, 2015 2:04 AM

jacobylott

Member since:
May 29th, 2015

Points: 100

100
points

There are several methods how to try to open a corrupted AutoCAD drawing file.

Use the Recover command Open the file and press ESC key just before Regeneration/Error message, save to DXF, load, save as DWG, Audit Insert the complaining DWG as a block into an empty drawing

Open/save the DWG in an older version of AutoCAD or AutoCAD LT or Actrix

More wide information is accessed on: http://communities.bentley.com/products/microstation/w/microstation__wiki/2939.recovering-corrupt-dgn-and-dwg-files-cs