Zanussi ZWT71401WA Support Question
Zanussi ZWT71401WA Support Question
Find answers below for this question about Zanussi ZWT71401WA.Need a Zanussi ZWT71401WA manual? We have 1 online manual for this item!
Question posted by derekhenson on September 5th, 2016
Zanussi Zwt 71401 Wa Washer/dryer
starting problem. when turning the dial to select a program nothing is showing in led display. sometimes faint numbers are seen in display but no green light showing on start button.sometimes after program is selected the display will light up as it should,and I can do a wash.I have checked wall socket/water supply/looked for kinked pipes/cleaned filter/ the machine is 14 months old.
Current Answers
Related Zanussi ZWT71401WA Manual Pages
Product Manaul - Page 2
....
• Keep all packaging away from children.
• Keep all detergents away from children.
• Keep children and pets away from the mains socket.
2
www.zanussi.com Before the installation and use 13 Personalisation 13 Daily Use 14
Safety information
Use -
General Safety
• Before maintenance, deactivate the appliance and disconnect...
Product Manaul - Page 4
...8226; Make sure that have been left in the tumble dryer.
If you stop the appliance before you use detergent, ...of injury or suffocation.
• Disconnect the appliance from the laundry. • The final part of the drying cycle, immediately ... • Make sure that
are wet with a stain remover start the appliance. • Plastic items are applicable to dry in...zanussi.com
Product Manaul - Page 6
... IRON button 7 START/PAUSE button 8 DELAY START button 9 DOOR LOCKED pilot light 10 Display
www.zanussi.com the door, rotate the
wise until the groove is
sary use a coin.
To disable this de- until the groove button anti-clockwise
is a picture of closing
inside the door clock-
vertical. It shows the programme selector dial as well as the buttons, pilot lights and the display.
Product Manaul - Page 7
... spin speed is opening the door it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option if you want appears on the display according to the fabrics (cottons or synthetics) you can select a drying time from creasing. Delay Start
The programme can be delayed from 10 minutes to...
Product Manaul - Page 9
...SUPER QUICK EXTRA RINSE
EASY IRON
RINSE HOLD SUPER QUICK EXTRA RINSE
SPIN RINSE HOLD EASY IRON
Delicates
Detergent Compartment
3)
www.zanussi.com
9
Options
SPIN RINSE HOLD
ECO2) SUPER QUICK EXTRA RINSE
EASY IRON
SPIN RINSE HOLD
ECO SUPER QUICK EXTRA RINSE... Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry
1-2-3-4-5 90°-
Product Manaul - Page 10
...Laundry
Options
Detergent Compartment
Dry
17-18-19 Handwash 40°- Cold Main wash - Rinses Short spin at maximum speed Max. You can choose the spin speed by pressing the relevant button... and after programmes with the Rinse Hold option selected. The machine performs 3 rinses, followed by pressing button 3, we recommend that you select the Super Quick option by a final long ...
Product Manaul - Page 11
...fast coloureds only). treat several times. Sort the laundry as above, then treat stains with methylated spirits. ...lightly and treat with special care. Rust: oxalic acid dissolved in the soap and water.
1) do not use acetone on artificial silk
www.zanussi...stains with bleach, rinse well (whites and fast coloureds only). Button up in a bag or net. For dried stains, soak overnight...
Product Manaul - Page 12
...laundry or a fabric conditioner specifically for tumble dryers.
...dryer, the appliance works on the choice of detergent and use of the water in the appropriate compartments of the dispenser drawer before starting the drying programme, reduce the loads of soiling.
they represent a fire hazard.
12
www.zanussi...starting...the laundry when...; the laundry is lightly soiled
&#...of washed laundry, in ...
Product Manaul - Page 13
... at high temperature
• = Drying at the end of the drying programme, select a short drying cycle again. www.zanussi.com
13 Follow the product manufacturer's recommendations on : • speed of the ... laundry • weight of the load size . Take note of the duration drying time of detergent into the main wash compartment and start the machine. By pressing the 4 and 5 buttons ...
Product Manaul - Page 14
... water leakage or damage to flash. Close the drawer gently. Turn the selector dial to position to reset the programme/to switch the machine off. The machine will be turned either clockwise or anticlockwise. 2. Measure out the amount of button 7 starts to the laundry. The green pilot light of detergent required, pour it into the compartment marked (the...
Product Manaul - Page 15
... is locked. Turn the programme selector dial to and then to change , you wish to delay the start by resetting it. If an incorrect option is selected, the integrated red pilot light of the button 7 flashes 3 times and the message Err is displayed for a few seconds and the red pilot light of buttons 3, 4 and 6
Depending on the display for a few...
Product Manaul - Page 16
... locked to indicate that ends with water left in the tub has been selected, the pilot light 9 remains on .
16
www.zanussi.com
Before you want appears on the display (see the «Drying Programme » table). Turn the programme selector dial to to press button 7. Caution! Press button 7 to empty out the water:
1.
ton 7 and the pilot...
Product Manaul - Page 17
... the set drying cycle.
Select the required options by pressing button 7. Start the programme by pressing the relevant buttons. At the end of the spin speed is updated every minute on ) or any laundry items rolling up items, redistribute them evenly in your clothes, it , press any programme position (except ).
7. The display shows the blinking . If possible...
Product Manaul - Page 18
... switch the appliance off and remove the mains plug from any laundry washing, and according to collect any clothes in the drum. Place... remove any cleaning or maintenance work. blocking the pump; • a problem with soap and water only, and then dry thoroughly. out under a ...powder in the container and remove its cap.
18
www.zanussi.com Care and cleaning
Warning! Remove the drawer To aid ...
Product Manaul - Page 19
...;
45°
selected there can be hot water in its seat. To clean the water inlet filters:
• Turn off the water tap.... When refitting
the pump cover, ensure it . www.zanussi.com
19
tightened so as to stop leaks and young ...fill, takes long to fill with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to remove...
Product Manaul - Page 21
...button 7 has not been pressed. • Please turn the selector dial and press the button 7 again. An option or a programme that eliminates all the spinning phases has been selected. • Select the draining or spinning programme. The selector dial... power socket. Problem The machine does not start . The Child...www.zanussi.com
21 The delay start has been selected. • If the laundry are...
Product Manaul - Page 22
...until the pilot light 9 goes off. The transit bolts and packing have selected the correct ...select the spinning programme.
22
www.zanussi.com Maybe there is very little laundry in the drum.
• Redistribute the laundry. This may happen several times before the unbalance disappears and normal spinning can resume.
Excessive laundry load.
• Reduce the laundry load. Problem...
Product Manaul - Page 23
...
The drying time has not been selected. • Select the drying time. Machines based on . • Open the water tap.
No
Technical data
Dimensions
www.zanussi.com
Width Height Depth
60 cm 85 cm 55 cm
23
This new motor ensures a softer start and more even distribution of the laundry in the drum repeat the...
Product Manaul - Page 24
... edge of
49
the programmes,
please refer to the
display on this chart is the reference programme for the data... the machine ever has to be transported again.
24
www.zanussi.com Installation
Unpacking All transit bolts and packing must be removed...;Cotton Energy Saving programme » at 60°C with a load of laundry, on the inlet water temperature and on the quantity and type of 7 ...
Product Manaul - Page 31
The appliance is supplied with the symbol are recyclable. >PEPSPP Environment concerns
Caution!
Check that this product may not be treated as household waste. Caution!
The manufacturer does not accept any other appliances in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be easily accessible after installing the machine. Should the appliance power supply cable need ...
Similar Questions
Can't Start The Machine
Power is on to display, all symbols, but nothing works.
Power is on to display, all symbols, but nothing works.
(Posted by hughwolfson 10 months ago)
Zanussi Zwt71401wa Display Not Working
Power is reaching the washing machine but the display is not working. Can you help? Or will I need t...
Power is reaching the washing machine but the display is not working. Can you help? Or will I need t...
(Posted by sharon91178 2 years ago)
Washer/dryer Approx 5 Years Old
Ongoing problem with no lights showing in display. Washer works fine for a while but then when wanti...
Ongoing problem with no lights showing in display. Washer works fine for a while but then when wanti...
(Posted by derekhenson 4 years ago)
'water Fault'
Newmachine performed one 'full' cycle and now fails every wash cycle with water fault.Already checke...
Newmachine performed one 'full' cycle and now fails every wash cycle with water fault.Already checke...
(Posted by proclubmaker 9 years ago)
How Do I Programme Zanussi Zwt 71401 Wa For Drying
how do i programme drying. say for cotyon? the timer shows 13 minutes and i cannot change it. also i...
how do i programme drying. say for cotyon? the timer shows 13 minutes and i cannot change it. also i...
(Posted by helenewg 10 years ago)