Zanussi ZDC37200W Support Question
Zanussi ZDC37200W Support Question
Find answers below for this question about Zanussi ZDC37200W.Need a Zanussi ZDC37200W manual? We have 1 online manual for this item!
Question posted by janecoleman37 on August 20th, 2016
No Power
power cut out mid cycle and hasn't had any power since. Tried changing fuse and using different plug socket but still no power
Current Answers
Answer #1: Posted by black686 on August 22nd, 2016 1:53 AM
black686
Member since:
August 22nd, 2016 Points: 9,430
Member since:
August 22nd, 2016 Points: 9,430
If you have miniature Circuit Breakers: 1. With the main trip switch on and your main power turned off, flip all of the individual switches off.
2. Without turning the power back on flip ONE switch back into the on position. After that please turn the power back on.
3. If the power works and the main trip switch does not switch off, try switching off your power again and repeat the process, adding ONE switch at a time. Eventually the switch protecting the faulty circuit will cause the main trip to operate, when this happens switch the power back off and reset the main trip switch. Turn the last flip switch back to off.
4. Next, flip all your other circuit switches back on. Turn the power on once more and if there's only one fault the power should stay on.
5. Turning the power off again, you need to unplug or switch off everything that runs on the faulty circuit. Common culprits are kettles, immersion heaters, and hot plates on electric cookers. Once done, try flipping the switch back on. If the main trip goes again and there is nothing plugged in then there is probably a problem with the wiring and you'll need an electrician.
6. If the power remains on and the main trip does not operate, then one or more of the appliances you have removed is faulty. Turn off the power again and plug in and switch on ONE appliance before switching the main power back on. Repeat this until the main trip switch goes. When this happens the last thing you plugged in should be removed before testing again. If the power stays on, you've found your faulty appliance.
2. Without turning the power back on flip ONE switch back into the on position. After that please turn the power back on.
3. If the power works and the main trip switch does not switch off, try switching off your power again and repeat the process, adding ONE switch at a time. Eventually the switch protecting the faulty circuit will cause the main trip to operate, when this happens switch the power back off and reset the main trip switch. Turn the last flip switch back to off.
4. Next, flip all your other circuit switches back on. Turn the power on once more and if there's only one fault the power should stay on.
5. Turning the power off again, you need to unplug or switch off everything that runs on the faulty circuit. Common culprits are kettles, immersion heaters, and hot plates on electric cookers. Once done, try flipping the switch back on. If the main trip goes again and there is nothing plugged in then there is probably a problem with the wiring and you'll need an electrician.
6. If the power remains on and the main trip does not operate, then one or more of the appliances you have removed is faulty. Turn off the power again and plug in and switch on ONE appliance before switching the main power back on. Repeat this until the main trip switch goes. When this happens the last thing you plugged in should be removed before testing again. If the power stays on, you've found your faulty appliance.
i can help you academically and technically.contact me any time
Related Zanussi ZDC37200W Manual Pages
Product Manaul - Page 2
...use , before being dried in the tumble dryer.
• Danger of explosion: Never tumble dry items that small children and pets do not climb inside the drum. Please read this appliance. General safety
• It is important to change...Control panel 7 Before first use 7 Programme chart 7
Important safety information
Sorting and preparing laundry 8 Daily use by persons (including children)...
Product Manaul - Page 3
... must execute an extra rinse cycle before loading your laundry with jets of water.
• The final part of a tumble dryer cycle occurs without supervision.
• Children often do not use it is compulsory to use the stacking kit (optional accessory).
Use
• This appliance is designed for domestic use the tumble dryer if the power supply cable, the control...
Product Manaul - Page 4
...
• In the dryer, laundry becomes fluffy and soft. Spin the laundry well before drying. Environmental information
The packaging materials are identified by markings, e.g. >PEPS Put the packaging in the programme overview;
- Help protect the environment and human health and to your local recycling facility or contact your municipal office. Use the loading volumes...
Product Manaul - Page 5
... power supply cable need to an earthed socket, in such a way that a full opening of up which are coloured in the plug supplied, a 13 amp ASTA approved BS 1363/A fuse must therefore not be installed on mains voltage, type of the transport packaging must be removed.
3. This might cause heat built-up to change the fuse...
Product Manaul - Page 6
.... A cut off plug is at the top.
Special accessories
• stack kit
Available from your Service Force Centre or your specialist dealer
These intermediate installation kits can be used to the terminal marked «L» or coloured red. laundry). The plug must be connected to store (e.g. Please contact your specialist dealer
To situate the dryer in...
Product Manaul - Page 7
.../ End , Condenser , Filter , Tank lights
1
23
45
5 Start/Pause button
Before first use
In order to remove any residues which may have been produced during production, wipe the dryer drum with a damp cloth or carry out a brief
Programme chart
drying cycle (ca. 30 min.) with damp cloths in minutes (about)
Application/properties
COTTON...
Product Manaul - Page 8
... programmes in accordance with IEC61121
Sorting and preparing laundry
The appliance should be ironed, e.g. max. Sorting laundry
• Sort by care label: The care labels mean:
Drying in the tumble dryer possible in minutes (about)
Application/properties
COTTON STRONG DRY
130
7 kg
Thorough drying of different material thicknesses (e.g.
terry towelling items, bathrobes. knitwear...
Product Manaul - Page 9
...laundry -
www.zanussi.com
9 Do not place in the tumble dryer not possible
Important! Preparing laundry
• To avoid laundry... layer should be used for tumbledrying. • Do not dry new...laundry items which has been selected by mistake once the programme has started, first turn the programme selector to off and then set the programme again. Changing programme To change...
Product Manaul - Page 10
... water reservoir after the drying cycle has finished. Open door.
2. drain the water reservoir (see chapter: Maintenance and cleaning)
3. Cleaning fluff filters
The filters collect all the fluff which lasts around 30 minutes.
The condensed water is best to use a damp hand for this phase to protect the laundry from the fluff filters...
Product Manaul - Page 11
... condenser.
• Clogged condenser cause higher energy consumption (drying cycle elongation) and dryer damage.
• Do not use furniture cleaners or aggressive cleaning agents to clean the machine.
Unsatisfactory drying results. www.zanussi.com
Remedy Plug in place. Troubleshooting by yourself
Problem1)
Possible cause
Dryer does not work. The START PAUSE button not pressed...
Product Manaul - Page 12
... V
Frequency
50 Hz
Fuse
13 A
Total power
2350 W
Drum volume
108 l
Weight of the low-power modes.
Respect max. Lower the room temperature if possible.
1) Switch the dryer off 12
www.zanussi.com see Programme overview chapter 3) see Care and cleaningchapter 4) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Technical...
Similar Questions
My Dryer Is Not Working. No Lights Coming On.
Hi I have no power to my dryer. I have changed the fuse and have plugged it into another power socke...
Hi I have no power to my dryer. I have changed the fuse and have plugged it into another power socke...
(Posted by Sharpy1418 2 years ago)
What Might Be The Problem With My Dryer.
My dryer when put in service mode flashes the LED (red)14 times then (yellow)11 times?it will not do...
My dryer when put in service mode flashes the LED (red)14 times then (yellow)11 times?it will not do...
(Posted by ottoiscool 2 years ago)
My Zanussi Zdc37200vw Tumble Drier No Power
zanussi tumble drier model ZDC37200W has shut off with no power. Fuse in plug OK. When timer switch ...
zanussi tumble drier model ZDC37200W has shut off with no power. Fuse in plug OK. When timer switch ...
(Posted by joves77561 5 years ago)
Drum Is Not Moving But It Has Got Power Can Hear Heter Still Working
(Posted by vvtaylor 8 years ago)