Yamaha MG20 Support Question
Yamaha MG20 Support Question
Find answers below for this question about Yamaha MG20.Need a Yamaha MG20 manual? We have 2 online manuals for this item!
Question posted by Rassinister on October 18th, 2021
Pfl Malfunction On Mg20xu
I have a MG20XU with malfunction PFL. Renders my mixer useless. Had it over a year but only just started using it. Apparently Yamaha are aware of this problem but offer no help. It seems its a flaw from Yamaha
Current Answers
Answer #1: Posted by Technoprince123 on October 18th, 2021 9:36 AM
Technoprince123
Member since:
February 8th, 2021 Points: 1,205,190
Member since:
February 8th, 2021 Points: 1,205,190
https://www.ifixit.com/Answers/View/555623/The+PFL+light+is+flashing+intermediately+(no+pfl+button's+pressed)
https://www.manualslib.com/manual/609956/Yamaha-Mg20xu.html?page=25
Please response if this answer is acceptable and solw your problem thanks
Related Yamaha MG20 Manual Pages
Owner's Manual - Page 5
... may damage your Yamaha dealer.
• Check the electric plug periodically and remove any openings. PA_en_2 1/2
If you are not limited to, the following problems occur, immediately turn off the power switch and disconnect the electric plug from the outlet. The power cord or plug becomes frayed or damaged. - MG20XU/MG20/MG16XU/MG16/MG12XU...
Owner's Manual - Page 6
...use the device in your audio system, always turn on the power until the condensation has completely dried out. • Avoid setting all equalizer controls and faders to their respective
companies. • This manual covers the MG20XU/MG20, MG16XU/MG16, and MG12XU/MG12 mixing consoles. Doing so may cause problems... for damage caused by qualified Yamaha service personnel. If you experience...
Owner's Manual - Page 8
... Convenience with USB Audio Class 2.0 compliant tablets and other devices, without the need to record the mixer output. The XU models support USB Audio Class 2.0 so ...MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual Combined with your computer, or use them with Built-in high-end audio devices. This power supply supports input voltages of instruments. With the audio interface you can use...
Owner's Manual - Page 9
...
Be sure to use the mixer. Connect the microphones, instruments, and/or
speakers you use .
Plug the power cord into a power outlet. Step 2 Making Connections
1.
NOTICE
If you are using .
• Power switch (rear panel) • [AC IN] jack (rear panel)
[GAIN] knobs
MG20XU
MG16XU
Faders
MG12XU
Step 1 Preparing the Power Supply
1. MG20XU/MG20/MG16XU/MG16/MG12XU...
Owner's Manual - Page 10
... the level meter flashes.
2.
Turn on the [PFL] switch for a channel, you are using.
While playing your instrument or speaking into
a microphone, adjust the input signal with the [GAIN] knob until it goes past the "0" ( nel you can monitor the signal for each chan- Quick Start Guide
Step 4 Getting Sound to the [Phones...
Owner's Manual - Page 12
Foot switch (YAMAHA FC5) (The [FOOT SW] jack is on XU models only.)
NOTE
On the MG20XU/MG20, the [SEND] jack, [GROUP OUT] jack, [MONITOR OUT], jack, and [STEREO OUT] jack are located on XU models only.)
Portable audio player
Headphones
12 MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual
Rear Panel
Computer (for musician monitoring)
Microphones...
Owner's Manual - Page 13
...'s Manual 13 2.
For Events and Parties
Front Panel
Microphones
DVD player (voice)
DJ mixer
Setup
Powered speakers
Headphones
Rear Panel
Computer (for music playback and/or recording)
(The [USB 2.0] jack is on XU models only.)
NOTE
On the MG20XU/MG20, the [SEND] jack, [GROUP OUT] jack, [MONITOR OUT], jack, and [STEREO OUT] jack...
Owner's Manual - Page 16
... for connecting line-level instruments, such
as electric keyboards and audio equipment. Connect the microphones and or instruments you may use . w Mono/stereo input jacks
MG20XU/MG20: 13/14 - 19/20
MG16XU/MG16: 9/10 - 11/12
MG12XU/MG12: 5/6 - 7/8
y
y
MG20XU/MG20
MG20XU
u
i
MG16XU/MG16 MG12XU/MG12
MG20
t
o
• [MIC]: Balanced XLR microphone input jacks
(1: ground, 2: hot, 3: cold...
Owner's Manual - Page 17
... switch (XU models)
Switches the audio source input on ( ) if you change the range of this switch on when using one or more phantom-powered condenser microphones...gain: 0 dB to prevent damage or noise in the signal by Attenuator Function. MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 17 i [PHANTOM +48V] switch and indicator
MG20XU/MG20: 1 - 12 MG16XU/MG16: 1 - 8 MG12XU/MG12: 1 - 4...
Owner's Manual - Page 18
...
MG20XU/MG16XU: [AUX1], [AUX2 - 3], [AUX4/FX]
MG20/MG16: [AUX1], [AUX2 - 4] MG12XU: [AUX1], [AUX2/FX] MG12: [AUX1 - 2]
The levels of each signal sent to the AUX 1 - 4 buses from each channel can be used to... - 7/8
CH 9/10 - 11/12
The equalizer shapes the high, mid, and low audio frequencies.
This knob adjusts the volume balance of the prefader signal (before fader adjustment).
•...
Owner's Manual - Page 19
...all the way down. In this switch is off for monitoring. Use these controls to the STE- When this condition, the audio from the STEREO L/R buses or GROUP buses that could be ... minimize noise, set to the buses.
MG20XU/MG20 MG16XU/MG16
MG12XU/MG12
MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 19 The switch lights when on , the [PFL] indicator below the level meter flashes.
...
Owner's Manual - Page 20
...
COMP
3-Stage EQ
PEAK
ON (CH Fader) PAN
MG12XU/MG12 PRE
1-2 3-4 (*) ST AUX1
MG20XU/MG20 : CH9-12
AUX1PRE
MG20XU/MG20/MG16XU/MG16
MG12XU/MG12
AUX2/FX, AUX2
PRE
AUX2
MG20XU/MG20/MG16XU/MG16 AUX3 (*) AUX4/FX, AUX4 (*)
PFL
Mono/stereo input channels
MG20XU/MG20 : CH13/14-19/20 MG16XU/MG16 : CH9/10,11/12 MG12XU/MG12 : CH5/6,7/8
MIC...
Owner's Manual - Page 22
...This is the list of audio playback from a computer....
r
y
i
o
o
MG16XU
MG20XU
22 MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual NOTE
• You can be used to adjust the volume of built-in... RTN
MG20XU LEVEL
PFL
1-2 3-4(*) ST AUX1PRE AUX2PRE (*) AUX3PRE (*)
FX ON
!0
q
w
e
r
t
STEREO L STEREO R GROUP 1 GROUP 2 GROUP 3 (*) GROUP 4 (*) AUX1 AUX2 (*) AUX3 (*) PFL L PFL R PFL CTRL
...
Owner's Manual - Page 23
... type, the mixer automatically restores the value that was previously used to this switch...PFL] switch is on ( ), the switch lights. NOTE
If this phone type input jack. Controls and Connectors
r [PARAMETER] knob
For adjusting the parameter (depth, speed, etc.) for monitoring.
Turn the switch on .
The switch lights in effect unit to the STEREO L/R bus. MG16XU
MG12XU
MG20XU/MG20...
Owner's Manual - Page 24
...] jacks
y
These impedance-balanced TRS phone jacks output the [GROUP 1-2 and 3-4] (MG20XU/MG20/MG16XU/MG16) signals.
Controls and Connectors
Master Block
q
e
r
q [SEND] jacks
MG20XU/MG20/MG16XU/MG16: [AUX1 - 4] MG12XU/MG12: [AUX1 - 2]
w u
t You use these output jacks are less affected by induced noise.
When the [PFL] indicator is off, the signal for example, to connect to the...
Owner's Manual - Page 25
... [PFL] switches. You can use this TRS phone jack. t [PHONES] jack
Controls and Connectors
• [POWER] indicator This indicator lights up when the mixer's power... )
• MG20XU/MG20/MG16XU/MG16 STEREO L/R buses: [STEREO] ( ) GROUP 1-2 buses: [GROUP] ( ), [1-2] ( ) GROUP 3-4 buses: [GROUP] ( ), [3-4] ( )
MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 25 You can use these jacks, for...
Owner's Manual - Page 27
... off, wait for a while, be sure to malfunction.
NOTICE
Rapidly turning the unit on again.
• [AC IN] jack
Connect the included power cord here. If you do not plan to use the mixer for at least 6 seconds before turning it on and...( ) to enable the [STEREO] master fader. First, connect the power cord to this switch on or off. MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 27
Owner's Manual - Page 28
...the display.
28 MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual If the mixer or computer does hang up, restart the application and/or computer and turn the power to the mixer off , or ...MG20XU/MG16XU/MG12XU
USB-REC-L USB-REC-R
USB Audio Controller
USB-Att.
• [USB 2.0] jack
(USB-Att.)
USB-PLAY-L USB-PLAY-R
NOTICE
• Use an A/B type USB cable. The cable should be used...
Owner's Manual - Page 31
...PFL] switches off.
The sound is output.
Are external instruments (including microphones) and speakers connected correctly? Are your Yamaha dealer. Use...input
jack and an RCA pin jack, are dif-
MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 31 ers adjusted... mixer monitor signal is the source of the signal.
Are you are using the same type of audio ...
Owner's Manual - Page 35
... of rack space. nated 'R' on the mixer. To take into account the cable connections, we recommend to 40 degrees Celsius. Refer to use the screws removed in Step 1.
Mount the... a significant amount of heat, leave more than 1 U of rack
mount brackets
MG20XU/ MG20
Accessories
- Use the screws removed in inefficient performance. CAUTION
This unit is rated for the MG12XU/MG12...
Similar Questions
When I Push The Pfl On In Channel 1, It Picks Up Channel 8?
(Posted by clintonfox 2 years ago)
Mid To Usb
i need to canct 01v mixer in my laptop and mobile phone so can you help me
i need to canct 01v mixer in my laptop and mobile phone so can you help me
(Posted by Salindaruwan23 3 years ago)
Number In Spx-display Is Dotted, Pfl-led Is Always Blinking.
There is a problem on my MG12XU. The PFL-LED is always blinking, even if no PFL-button is pressed an...
There is a problem on my MG12XU. The PFL-LED is always blinking, even if no PFL-button is pressed an...
(Posted by guenterauer4 5 years ago)
Regarding Training Videos For Mpg24/32 Audio Mixers
Where can I obtain training videos for Yamaha 24/32 audio mixers?
Where can I obtain training videos for Yamaha 24/32 audio mixers?
(Posted by jimmycjr87 7 years ago)
