Yamaha AW4416 Support Question
Yamaha AW4416 Support Question
Find answers below for this question about Yamaha AW4416.Need a Yamaha AW4416 manual? We have 6 online manuals for this item!
Question posted by woodyjames on January 4th, 2021
Think We Blew A Channel On Aw4416 By Mistakingly Plugging Power Amp Out Into Cha
The person who posted this question about this Yamaha product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by INIMITABLE on January 4th, 2021 8:51 AM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,082,030
Member since:
April 3rd, 2020 Points: 2,082,030
Turn the amp off and reverse the speaker wires at the back of the amplifier by moving the right channel wires to the left outputs, and the left to the right. Turn it back on. If the problem stays on the same speaker, the speaker or wire on the bad side is defective. If it reverses, it's the amp.
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Yamaha AW4416 Manual Pages
Owner's Manual - Page 4
... iv
- Important
Important
Read the following before operating the AW4416
❒ Warnings
• Do not allow water to enter this unit's power cord only to an AC outlet of the power cord. Fire or electrical shock may cause a fi... Blocked ventilation holes are a fire hazard.
• Hold the power cord plug when disconnecting it off , remove the power plug from the AC outlet.
Owner's Manual - Page 18
...disk may vibrate and fail to operate correctly.
• Do not turn on the power of the AW4416 until all options have been installed. • When you removed in until it in ...slot. Operation Guide Place the hard disk on the power of the AW4416 after installing a new hard disk,
formatting of the flat the four locations shown.
Plug the connector of the hard disk will begin
4. ...
Owner's Manual - Page 32
... of the level meter/counter is lit, since this may not be subject to vibration or shock during operation, and do not move the AW4416 while its power is packed as described at the above, any damage or malfunctions that occur during transport may not be covered under warranty. Do not allow...
Owner's Manual - Page 33
... using these via the OPTION I/O slot, in the range of each channel Every input as well as the stereo output channel provides the same powerful fourband full-parametric EQ and dynamics processor as distortion and amp simulator. It is an audio workstation that rivals large consoles, the AW4416 can be inserted into a channel or the stereo bus.
Owner's Manual - Page 54
...AW4416, such as sixteen previous operations. When the TRACK [CUE] key is used to be recorded. G [ALL SAFE] key This key cancels all record-ready settings of the level meters.
RECORDER section
RECORDER
TRACK
EDIT
12
PROFESSIONAL AUDIO WORKSTATION
RECORDER...area displays various information necessary when operating the recorder section of the currently selected scene memory....
Owner's Manual - Page 82
... such as a digital MTR or DAT recorder is digitally connected to the AW4416, the clock that controls the timing at which the AW4416 will synchronize.
The SETUP UP screen D.in...channels 1/2-7/8 of the AW4416. In the WORD CLOCK SOURCE area of this screen you turn on the power in the input signal of external SCSI device ¡ AW4416. Be aware that they will occur.
1.
If the power...
Owner's Manual - Page 89
...the number of quantization bits for the audio data recorded on an audio CD.
4. A song with a sampling frequency of 48 kHz cannot be simultaneously played or recorded will appear. The new song will ...audio CD of your selection.
• It is not possible to either the OK button or the CANCEL button, and press the [ENTER] key. The MIXER DATA IMPORT popup window will depend on the AW4416...
Owner's Manual - Page 104
...the band that you record it on the AW4416
Using EQ and the dynamics processor
By using the four-band EQ and dynamics processor that are provided for each input channel, you can process...for a time in the upper right of the currently selected channel.
3. As with EQ, you wish to adjust the panning of the display. PAN F G Q
PROFESSIONAL AUDIO WORKSTATION
PAN
Q
F
G
• [Q Adjust the ...
Owner's Manual - Page 149
... wish to page 140.)
137 - The following types of the stereo output channel
Tip! RDR16 ST L/ST R BUS 1 - DIR16
Type of signal AUX buses 1-8 Recorder direct out 1-16 L/R channels of signal Stereo output channel Buses 1/2-7/8 Input channel direct out 1/2-15/16 AUX buses 1/2-7/8 Recorder direct out 1/2-15/16
❍ Digital I/O card (slot 1) OUTPUT 1-8 ❍ Digital I /O patching...
Owner's Manual - Page 163
...recorded on tracks 1-16 of the AW4416, such as a part.
❍ Region A continuous piece of audio that contain no audio data cannot be selected. Region
Track 1 Track 2 Track 3
Track
Part
= Continuous audio ...tracks and virtual tracks
A variety of editing operations can be performed on the audio data recorded on a track in three editing units.
❍ Track The entire currently selected...
Owner's Manual - Page 185
...AW4416 (the "current song") can be handled at any time. Be aware that if you must perform the shut-down procedure (¡ P.17).
175 - By loading a song into internal memory, you create (i.e., mixer settings, recorder settings, audio...off the power of the AW4416, you turn off the power of the AW4416 without saving the current song, any given time. • When the power of the AW4416 is ...
Owner's Manual - Page 266
... some CD players. Recording/Playback
CD-RW drives
Disc At Once (finalized automatically)
q No silence between
tracks
CD-R
Track At Once
Finalized Not finalized
q Two seconds of silence
between tracks
× (data can be played back on a CD-RW drive or on which audio data has been written by the AW4416's mastering...
Owner's Manual - Page 277
... 87
P
Page 56 Pair 80 PART menu 162 Parts 152 Patch library 138
Storing 138 Patch program
Recalling 139 Patching 133
input channels 133 insert I/O point 140 outputs 136 recorder inputs 135 Pointer 52 PORT SELECT parameter 234 Post-roll time 130 Pre-roll time 130 Program changes 235 Punch-in/out...
Reference Guide - Page 24
... to Operation Guide "Chapter 8. Display BUS 1-BUS 8 DIR 1-DIR16 AUX 1-AUX 8 RDR 1-RDR16
ST L/ST R
Signal type
Buses 1-8
Input channel direct out 1- 16
AUX buses 1-8
Recorder direct outputs 1- 16
L/R channels of the stereo output channel
Tip! Patching." Reference Guide D OPTION I/O SLOT OUT ASSIGN
This selects the signals that will be output from I/O cards installed...
Reference Guide - Page 98
... as bar graphs in this area indicates the current location. G Track view
The regions (continuous audio data recorded in a single operation) included in each track. The symbols displayed at the bottom of the .../off setting of the tracks does not affect the [ON] keys of the monitor channels.
• On the AW4416, the number of tracks that has been forcibly muted, you must first turn...
Reference Guide - Page 170
... from the external device being used for both the
AW4416 and the external device(s)? • An effect such... display is not output • Has audio data been recorded on , please contact
your amp or external equipment
raised? • Is...channel or monitor chan-
sCan't record • Is the internal hard disk connected? • Is there sufficient free space on • Is the power...
Reference Guide - Page 171
... AW4416 may be set to record the digital
input signal. • Make sure that CD/DAT DIGITAL REC in the UTILITY screen Prefer.2 page is set to ENABLE. sCan't save to a library • It is not possible to save to Operation Guide P.147 "Audio tracks". ber being transmitted?
reo page. • Are monitor channels...
Reference Guide - Page 173
... player
• An audio CD you created you use recorder editing to erase a
track etc., that the reading speed of the SCSI device set to the SCSI connector is not recognized
• The power...sound file will be set to REMAIN (remaining recording time).
• If the display mode is unnaturally large • Even after the AW4416.
• Is the SCSI cable connected correctly? •...
Tutorial - Page 6
...recording a band it's sometimes a good idea to have the singer lay down other loud stuff. Oowee! Don't worry about switchable directivity unless you really think...10061; Close-miking guitar amps, drums, and other ...recording, CHOOSE THEM WITH CARE!! Although most seasoned recording engineer cringe. And since the AW4416 provides switchable phantom power on the scratch vocal track to record...
Version2.0 Manual Supplement - Page 15
...AUDIO WORKSTATION
MIDI IN connector
MIDI OUT connector
• In the MIDI Setup 1 page, make sure that the MIDI OUT/THRU switch is set to record...received from a synthesizer to the AW4416, and assign it . Here ...recorded in this example.
1
2
3
A MIDI message assigned to the [ON] key B MIDI message assigned to the fader C Currently selected channel number
5 Press the [SEL] key for the channel...
Similar Questions
Yamaha Mt50 - 12 Volt Power Supply. How Many Milliamps?
I have many adapters and want to be sure I'm using the right oneI know it's 12 volt but how many mil...
I have many adapters and want to be sure I'm using the right oneI know it's 12 volt but how many mil...
(Posted by pauxfolker 5 years ago)
Aw4416 Yamaha Rec. Will Not Record On Secveral Channels.
why wont redirecting high Z guitar line sig. using channel 8 into bus 3? work? Instead i get a sig. ...
why wont redirecting high Z guitar line sig. using channel 8 into bus 3? work? Instead i get a sig. ...
(Posted by gitaudionix 7 years ago)
Best Outputs Aw4416 For Powered Monitor Speakers And A 6 Channel Headpnone Amp
right now I am using monitor left right outputs on aw4416 ,to powered speakers, for monitoring playb...
right now I am using monitor left right outputs on aw4416 ,to powered speakers, for monitoring playb...
(Posted by tlavallee63 8 years ago)
Problem With Playing Cd With My Yamaha Aw4416.
sir,i am writing to you from Cameroom-Africa.My aw4416 do not read nor play a cd any longer.I have d...
sir,i am writing to you from Cameroom-Africa.My aw4416 do not read nor play a cd any longer.I have d...
(Posted by taskwame 10 years ago)
Converting To Logic Pro, Using Apogee Quartet. Can I Midi Aw4416?
Converting from hard disc recording to mac Logic Pro 9, using Apogee Quartet. Looking to find the be...
Converting from hard disc recording to mac Logic Pro 9, using Apogee Quartet. Looking to find the be...
(Posted by buttonf56 11 years ago)