Get support for Whirlpool WTW7340XW

Whirlpool WTW7340XW Support Question

Whirlpool WTW7340XW Support Question

Find answers below for this question about Whirlpool WTW7340XW.
Need a Whirlpool WTW7340XW manual? We have 6 online manuals for this item!
Question posted by sbrdds on March 2nd, 2016

Specs For Wtw7340xwo.

We need the specs on our washer. The foot print measurement is what we need. We have limited depth and need a replacement

Current Answers

Answer #1: Posted by Odin on March 2nd, 2016 5:52 PM
This answer was accepted by the poster of the original question.
Odin

Member since:
April 10th, 2010

Points: 41,236,670
1,110
points
This is probably a discontinued model, and using several sources I couldn't find it referenced anywhere. Your best bet is to inquire of Whirlpool corporate--see the contact information here: http://www.corporateofficeowl.com/whirlpool/Corporate%20Office.


Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Whirlpool WTW7340XW Manual Pages

Dimension Guide - Page 1

... at least 39" (990 mm) above the floor and no less than 96" (2.4 m) from the bottom of the washer. Ref. It is required. The top of 2" (51 mm). Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. W10240438B 05/2010 Specifications subject to change without notice. A time-delay fuse...
Installation Instructions - Page 2

Tools needed: Parts supplied (located in the washer basket): Pliers that open to 1 9/16" (39.5 mm) Flashlight (optional) 4" min (102 mm) Adjustable or open end wrench 9/16" (14 mm) Wood block Drain hose form Water inlet hoses (2) Flat inlet hose washers (4) Removable Tie Strap Tape measure or ruler Level 2 INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather...
Installation Instructions - Page 3

... spacing of 0" (0 mm) clearance on sides. ■■ Additional spacing should be considered on all sides of the washer to water, weather, or at temperatures below 32° F (0° C). If you have: You will need : Laundry tub or standpipe taller than 96" (2.4 m) Sump pump system (if not already available) 1" (25 mm) diameter standpipe...
Installation Instructions - Page 4

...-away capacity can be a minimum of 28" (710 mm) from the bottom of the washer. 39" (990 mm) 28" (710 mm) Laundry Tub Floor The laundry tub drain system needs a minimum 20 gal. (76 L) capacity laundry tub. The top of the laundry tub must be at least 39" (990 mm) above the floor and no less...
Installation Instructions - Page 5

... supports. REMOVE SHIPPING BASE AND PACKING RING 1. Remove shipping base and packing ring INSTALLATION INSTRUCTIONS Before you need to your washer and is secured with tape. NOTE: To avoid floor damage during installation, set washer back upright, and remove the tape from the lid so that you can open the lid and remove...
Installation Instructions - Page 6

...Parts" to determine what you may need . Bend hose and feed through hoses into standpipe. Place drain hose in the couplings. 2. Washer Insert new flat washers into each end of hose. Coupling... the bottom of the laundry tub. Check the temperature of laundry tub. Connect drain hose form Connect Inlet Hoses 1. Insert new flat washers For a laundry tub or standpipe drain,...
Installation Instructions - Page 7

... reduce the chance of hose failure, replace the hoses every 5 years. It will be needed to tighten couplings an additional two-thirds turn. Adjust front leveling foot For washers with cold water inlet valve. Secure drain hose Laundry Tub Standpipe Wall Attach hot water hose to final location 5. Move washer to hot water inlet valve. Screw...
Installation Instructions - Page 8

...if necessary, then using the wrench again, turn the locknuts counterclockwise on the foot to tighten to level the washer. Then place the level on the lid near the console. You may vibrate....the washer with a 9/16" or 14 mm open-end wrench, then twisting the foot up or down as needed.After the washer is not level, move the washer out to lock the back feet before moving the washer back ...
Owners Manual - Page 3

...needed. Choosing the Right Detergent Use only High Efficiency detergents. Use only High Efficiency (HE) detergent. For example, you may hear nothing at the beginning of the cycle, as the washplate moves the load. There will not see a washer...dirty laundry, fill it evenly around the basket wall. As the washer dampens and moves the load, the level of suds for your previous washer. HE...
Owners Manual - Page 4

...preset speeds can be added to the washer to complete. See "Cycle Guide" for detailed descriptions of cycle. If you need to select less wash time, if needed . SOIL LEVEL Soil level (wash... pressing twice will light until the lid is opened . This may affect the time shown in your laundry load. Select a wash temperature based on the type of the signal that cycle. 5 START/PAUSE ...
Owners Manual - Page 7

... Washer with Affresh™ No Spin EcoBoost For models with separate cycle knob positions for Rinse & Spin and Drain & Spin: Swimsuits, items that need rinsing only Rinse & Spin Warm/Cold ... Softener Cycle Details: This cycle adds liquid chlorine bleach to spin excess water out of the washer fresh and clean. Not all cycles and options are default settings for improved whitening of a ...
Owners Manual - Page 8

... • When washing water-proof or water-resistant items, load evenly. IMPORTANT: Items need to move freely for tips and more information on using the Bulky Items cycle. •... lint-takers from towels, rugs, and chenille fabrics. USING YOUR WASHER 1. See "Cycle Guide" for best cleaning and to your laundry 2. Load laundry into fabric. • Treat stains promptly. • Close zippers...
Owners Manual - Page 9

... turn on your load size. It may also result in cycle. Using Laundry Product Dispensers 3. If Extra Rinse option is selected, fabric softener will be selected to dispenser Fabric softener dispenser Detergent dispenser Add a measured amount of fabric softener based on washer Liquid chlorine bleach dispenser Do not overfill, dilute, or use liquid...
Owners Manual - Page 11

... wish to CLEAN WASHER with all -purpose surface cleaner, if needed. You will sound (if set . Press START/PAUSE. Water will light and the end of bleach to ensure cleaner or bleach have been rinsed from washer. Use all cycles. 10. Select cycle options Select any spills. 2. Periodically inspect and replace inlet hoses if...
Owners Manual - Page 12

... YOUR DISPENSERS You may stay in hoses, freezing can damage washer. TRANSPORTING YOUR WASHER 1. Disconnect drain from original shipping materials back inside washer basket. 6. Because some water may find laundry product residue leftover in basket and run washer through BULKY ITEMS cycle to clean washer and remove antifreeze, if used. If storing or moving during freezing...
Owners Manual - Page 13

... system. Item or load not suitable for an HE low-water washer. The washer senses load sizes and adds correct amount of the sensing spins after you have started the washer. You may not be level to drainpipe or laundry tub. This is normal operation for selected cycle. If you experience Possible Causes Solution...
Owners Manual - Page 16

.... Monthly maintenance not done as recommended. See "Cleaning Your Washer" in water. Tie all strings and straps before starting wash... at www.whirlpool.com/help for tough cleaning. Always measure detergent and follow detergent directions based on some models), ... cycle with the best cycle. 16 Additional water lifts the laundry off the impeller, resulting in loose heaps evenly around the...
Owners Manual - Page 17

...is detected, the washer will damage fabrics. Excessive suds in display Load too large. Check plumbing for service. 17 Allow the washer to clear the code. Always measure detergent, and base... a suds reduction routine. Close lid and press START/PAUSE. The washer is normal for small amounts of laundry, from unlocking. Hot and cold inlet hoses have been added incorrectly....
Owners Manual - Page 18

... label located on how to instruct you ever need it is installed in an inaccessible location or is not available. 9. WHIRLPOOL CORPORATION LAUNDRY WARRANTY LIMITED WARRANTY For one year from the date of ...The removal and reinstallation of original purchase date is used in your major appliance, to replace or repair house fuses, or to better help can nd this book and your major...
Warranty - Page 1

...replace or repair house fuses, or to correct house wiring or plumbing. 3. You can be repaired in accordance with Whirlpool's published installation instructions. 10. WHIRLPOOL CORPORATION LAUNDRY WARRANTY LIMITED... after checking "Troubleshooting," additional help you obtain assistance or service if you need to know your authorized Whirlpool dealer to obtain service under this book and ...

Whirlpool Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

  • Maintaining your canopy-style range hood
    .../light lens: Place edge of your range hood often. What should I do when it needs replacing. Maintaining your canopy-style range hood (this information applies to some models). Lift tabs and remove...light lens from range hood. To remove filter/light lens: Pull firmly on filter tab to replace the aluminum filter/light lens, or charcoal filter pads on some models): For best results,...
  • How do I replace the cooking light in my microwave oven?
    ... bulb by squeezing the wire clip together, pulling to handle bulb. Slide the top of the vent grille into place. If you need replacement parts: If you need to reorder. FSP replacement parts will help us to better respond to build every new Whirlpool appliance. In the U.S.A., call our Customer eXperience Center telephone number...
  • Oven light is on when door is closed
    ... Washer or Dryer Refrigerator or Freezer Dishwasher Electric Range, Oven or Cooktop Gas Range, Oven or Cooktop Microwave Trash Compactor Window Air Conditioner Hot Water Dispenser Vent Hood Ice Machine Commercial Laundry ...door is on, the light in the lower oven will remain on. Do you will need replacing by a qualified service technician. On some models the light switch for the upper oven also...

Similar Questions

Washer Over Flowing
Washer over flowing on certain settings and flossing bathroom
(Posted by Aubreylillian21916 1 year ago)
Please Provide Me With Dimensions For A Whirpool Washer Model Wtw7340xw Thank Y
Please provide me with the dimensions for a Whirlpool washer model WTW73XWThank you
(Posted by amrph1974 6 years ago)
Wtw7340xw Assembled Depth?
what is the WTW7340XW Assembled Depth?
(Posted by jamalzgal 7 years ago)
Whirlpool Wfw9450wl Washer's Panel Doesn't Light Up.
the lights aren't on. i checked the circuit breaker. i made sure the door is closed. How can I get i...
(Posted by lynnerivera 8 years ago)
Ask a New Question
Use the box below to post a new question about this Whirlpool product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Whirlpool Manuals

Find free Whirlpool WTW7340XW manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Whirlpool Reviews

View thousands of Whirlpool user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Whirlpool customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Whirlpool customer service rankings, employee comments and much more from our sister site.

Whirlpool Recalls

Find comprehensive Whirlpool recall information updated hourly on RecallOwl.com.