Whirlpool WTW7040DW Support Question
Whirlpool WTW7040DW Support Question
Find answers below for this question about Whirlpool WTW7040DW.Need a Whirlpool WTW7040DW manual? We have 4 online manuals for this item!
Question posted by kellibows on August 16th, 2017
Filling For Ever
my washer will fill on the rinse cycle forever a load usually takes up to 3 hrs to finish how do i make this stop?
Current Answers
Answer #1: Posted by Odin on August 16th, 2017 4:29 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,640
Member since:
April 10th, 2010 Points: 41,236,640
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WTW7040DW Manual Pages
Installation Guide - Page 2
... 285835
LOCATION REQUIREMENTS
Select proper location for installation are in cardboard insert in a basement, laundry room, closet, or recessed area.
271/2"
27"
(699 mm) (686 mm)
42...saving 90° elbow, hypro-blue steel couplings (2 pack)
Alternate parts: (Not supplied with flat washers
To order, please refer to 13⁄4" (44.5 mm)
Optional tools:
Flashlight
Bucket
Parts supplied:...
Installation Guide - Page 3
... drain system. n A level floor with water and load) of installation and servicing, and spacing for companion appliances... within 3 ft (0.9 m) of hot
and cold water fill valves on all sides of washer. (Additional hoses may be at least 39" (990 ...using a floor drain, wall standpipe, floor standpipe, or laundry tub.
See "Washer Care" in door are minimum required. Proper installation is ...
Installation Guide - Page 5
...slide it over end as shown in picture) or over console to allow free access to move washer later.
4. Drain hose form must be inside standpipe; Squeeze clamp with pliers and slide black elbow...with separate directions. You may need to back of laundry tub. do not force excess hose into standpipe or lay on elbow end of laundry tub.
Remove packing tray from rear panel. Attach...
Installation Guide - Page 6
... HOSES
Washer must be attached and have water flowing to water faucets with new inlet hoses with separate directions. NOTE: Both hoses must use a Y-adapter (not provided).
8. Make note of... seconds through hoses into a laundry tub, drainpipe, or bucket to washer correctly.
10. A small amount of hose failure, replace the hoses every 5 years. Screw on washer. Damage can result. Repeat ...
Installation Guide - Page 7
...
Secure drain hose to laundry tub leg, drain standpipe, or inlet hoses for wall standpipe with metal feet, use a 9/16" or 14 mm open -end or adjustable wrench to turn the plastic leveling foot counterclockwise to lower the washer or clockwise to make solid contact with floor. LEVEL WASHER
IMPORTANT: Level washer properly to its...
Installation Guide - Page 8
... INSTALLATION CHECKLIST
q Check electrical requirements. q Check that water faucets are now installed.
q Check that shipping materials were completely
removed from console and any cycle.
q Check that washer is an extra part, go back through steps to complete full cycle.
8 q Check for leaks around faucets and inlet hoses. Select any tape
remaining on . Start...
Use & Care Guide - Page 4
..., as the washer determines the correct water level for some of water as the lid lock goes through a self-test. This is the low-water washplate wash system. Improved Cleaning
Low-water cleaning means concentrated cleaning.
See "Using Laundry Product Dispensers" for the load. HE detergents are different from those of the cycle, as...
Use & Care Guide - Page 5
... the lid, and add items. Touch and hold START/PAUSE to get the best combination cycle available for the type of your fingernail. Factors such as load size and water pressure may cause the washer to wash.
STEAM MODEL
1
2
3
5
NON-STEAM MODEL
1
4
6
2
5
7
3
5
4
6
5
7
NOTE: The control panel features a sensitive surface that responds to a light...
Use & Care Guide - Page 6
... the wash period. The washer will fill and then pause to soak, and then begin the selected cycle.
6 CYCLE MODIFIERS When you need to open the lid, touch and hold START/PAUSE button again to complete a load after power interruption. Select the most cycles. Rinse & Spin Combines a rinse and high speed spin for your washer fresh and clean. PRESOAK...
Use & Care Guide - Page 7
...in drawer when using liquid detergent and removed when using
powder detergent.
NOTE: Fill dispenser with only liquid bleach. Dispensers
A Liquid fabric softener dispenser
Pour measured ...cycle.
B High Efficiency "HE" detergent dispenser
A
Add liquid or powdered HE detergent product to this dispenser.
IMPORTANT: Make sure tray is in this
dispenser for your main wash cycle....
Use & Care Guide - Page 8
... a unique user interface to help you select the best cycle you want the washer to wash them and select the appropriate "How to Wash" selection. R -
Recommended Cycle a - Alternate Cycle Blank - For best fabric care, choose the cycle that best fits the load being washed. Cycle is available but not optimal. See chart below for your "What to...
Use & Care Guide - Page 9
... washer
For best performance, load items in death,
re, or electrical shock.
2. Sort and prepare your items.
Single-dose laundry packet, color-safe bleach, Oxi-type boosters, or fabric softener crystals can pass under the washplate and become trapped, causing unexpected sounds.
• Sort items by recommended cycle, water temperature, and colorfastness.
• Separate...
Use & Care Guide - Page 10
... Oxi products in longer cycle times and reduced rinsing performance. If adding powder HE detergent remove inside tray. The package will be dispensed into the washer too early. Using regular... cycle with a regular non-HE detergent. Using Laundry Product Dispensers
NOTE: Do not add single-dose laundry packets, color-safe bleach, Oxi-type boosters, or fabric softener crystals to adding laundry....
Use & Care Guide - Page 12
.../PAUSE
button to add, if not previously set ). Select cycle options
11. Touch and hold START/PAUSE button to restart the cycle. Touch control panel to select any other options.
IMPORTANT: If lid is done to pause washer;
These may take several minutes if the load was spinning at a high speed. the lid will automatically...
Use & Care Guide - Page 13
... leave the washer lid open to allow for normal wash cycle. 2. During this procedure. After the Clean Washer cycle has stopped, run a Rinse & Spin cycle to provide rinsing at a level above could cause washer damage over time. Cleaning the Outside of soils. Use only mild soaps or cleaners when cleaning external washer surfaces. IMPORTANT: To avoid damaging the washer's finish, do not...
Use & Care Guide - Page 14
...washer where it will be moved during freezing weather, winterize your washer. Because some water may find laundry...washer only when you are not dishwasher safe. If moving .
3. Pull drawer out until washer is placed in your washer for a medium-size load.
14 Air dry, or dry with warm water. 5.
If washer.... TRANSPORTING YOUR WASHER
1.
Turn on RINSE & SPIN cycle for about 30...
Use & Care Guide - Page 15
...cycles. or washer stopped
Load items in washer drain system. Use Bulky/Sheets and Deep Water cycle for oversized, nonabsorbent items such as recommended. See "Cycle Guide" and "Using Your Washer." Noises -
You may be out of water for leaks (laundry tubs, drain pipe, water
pipes, and faucets.)
Washer not loaded as comforters or poly-filled...clean washer cycle to hear the pump making a...
Use & Care Guide - Page 16
..., touch and hold START/PAUSE.
To remove suds, cancel cycle. Select RINSE & SPIN. Do not add more water to run or fill, washer stops working
Both hoses must be closed for washer to the washer.
Cycles with lower spin speeds remove less water than normal. Evenly arrange the wet load for loading recommendations.
16 If you experience
Possible Causes
Solution...
Use & Care Guide - Page 17
...stop draining or spinning.
This includes cooler hot and warm washes.
Load not rinsed
Check for proper installation.
Make sure hot and cold inlet hoses are not clogged.
Inlet valve screens on load after washer...selected cycle.
Add an Extra Rinse to measure correctly.
Washer not loaded as recommended.
Wash action and/or spin speed too fast for clothes to washer....
Use & Care Guide - Page 19
... hose. If the error code persists call for service. Load dispensers before adding clothes. Single-dose laundry packet not dissolving
Adding laundry packet incorrectly. Do not tape
standpipe. F9E1, drn, dr (drain pump system problem - long drain) appears in display
Washer taking too long to your load. Use drain hose form and attach securely to clear...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
...cycle by pressing the Start button. No laundry products will take approximately three minutes. Use warm or hot water in the Estimated Time Remaining display, an error tone will sound. Press Extra Rinse... the cycle will continue.The machine will fill and run a short sensing cycle. The door will take approximately three minutes. Always do I clean my front-load washer door seal... -
Dispenser not working correctly - Top-load HE washer with Dispenser Drawer - video
... when using an oxi laundry boost product, add it to the bottom of the cycle. This is not working correctly - Is fabric softener remaining in the bleach dispenser. The fabric softener automatically dispenses during the last rinse of water will not properly dispense from my washer? - Top-load HE with Dispenser... -
The fabric softener dispenser is not working correctly - Top-load HE washer with Dispenser Drawer - video
...rinse with Dispensers in the dispenser at the end of the cycle. This is normal. Do not add powdered laundry products to ensure best performance. Dispenser not working correctly on my Cabrio High Efficiency washer. Cabrio® Front-load Duet Sport washer...load HE washer with Dispenser Drawer - Do not fill past the Max-fill lines on the dispenser. Top-load HE washer ...
Similar Questions
Washer Won't Start. It Allows You To Select Cycle But When You Attempt To Start
(Posted by squiremaryf 3 years ago)
Cabrio Washer Getting Stuck In A Cycle And Won’t Finish The Load.
My cabrio washer is getting stuck with about 22-24 mins left in a 56 min cycle and won't finish the ...
My cabrio washer is getting stuck with about 22-24 mins left in a 56 min cycle and won't finish the ...
(Posted by kkwnavin 6 years ago)
Washer Just Stops After A Couple Of Minutes
My new cabrio just stops after a few minutes of running. It never finishes a cycle. Any suggestions?
My new cabrio just stops after a few minutes of running. It never finishes a cycle. Any suggestions?
(Posted by Anonymous-161614 7 years ago)
Wet3300xq1 Washer Not Feeling All The Way On Rinse Cycle
My washer is only filling half on Rinse cycle
My washer is only filling half on Rinse cycle
(Posted by Sbell47981 8 years ago)
Slow Fill Up For Rinse Cycle And Then Stops
The washer will run fine but then once it gets to the rinse cycle it will fill up very slowly, almos...
The washer will run fine but then once it gets to the rinse cycle it will fill up very slowly, almos...
(Posted by yourmother13 12 years ago)