Whirlpool WFW97HEXL Support Question
Whirlpool WFW97HEXL Support Question
Find answers below for this question about Whirlpool WFW97HEXL.Need a Whirlpool WFW97HEXL manual? We have 5 online manuals for this item!
Question posted by dhood36218 on January 18th, 2016
Steam Line Hookup
how do the hoses hookup on the washer to the dryer for the steam to work on the dryer
Current Answers
Answer #1: Posted by waelsaidani1 on January 18th, 2016 11:27 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,787
Member since:
May 12th, 2013 Points: 19,501,787
To properly install your washer/dryer, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.
This washer/dryer is manufactured ready to install with a 3-wire electrical supply connection. The neutral ground wire is permanently connected to the neutral conductor (white wire) within the dryer. If the dryer is installed with a 4-wire electrical supply connection, the neutral ground wire must be removed from the internal ground connector (green screw), and secured under the neutral terminal (center or white wire) of the terminal block. When the neutral ground wire is secured under the neutral terminal (center or white wire) of the terminal block, the dryer cabinet is isolated from the neutral conductor. n If local codes do not permit the connection of a neutral ground wire to the neutral wire, see "Optional 3-wire connection" in the "Electrical Connection" section. n A 4-wire power supply connection must be used when the appliance is installed in a location where grounding through the neutral conductor is prohibited. Grounding through the neutral is prohibited for (1) new branch-circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductors. If using a power supply cord: Use a UL listed power supply cord kit marked for use with clothes dryers. The kit should contain: n A UL listed 30-amp power supply cord, rated 120/240 volt minimum. The cord should be type SRD or SRDT and be at least 4 ft (1.22 m) long. The wires that connect to the dryer must end in ring terminals or spade terminals with upturned ends.
Related Whirlpool WFW97HEXL Manual Pages
Owners Manual - Page 3
... be installed on options and ordering, call 1-800-807-6777 or visit us at www. Worksurface The worksurface bridges the washer and dryer, and provides a convenient working height.
For more comfortable working and storage area. In Canada, call 1-800-901-2042, or visit us at : www.whirlpool.com/accessories. Stack Kit If space is...
Owners Manual - Page 4
...options and settings, cycle information, and estimated time remaining. Press to access helpful laundry and troubleshooting tips, as well as other preferences. IMPORTANT: When using the ...
B Powdered HE detergent compartment C Liquid fabric softener D Chlorine bleach
1 POWER Press to turn the washer on either side of the screen to stop/cancel a cycle at any time. Themes Select between two ...
Owners Manual - Page 5
...Press to produce the right amount of the cycle for up to select a cycle for your laundry load.
n Change water hardness setting if desired level is lit to go back to the...dispenser cartridge holds up of up to select available cycles on or off.
8 WASH CYCLE KNOB Use your washer.
FanFresh may also result in this dispenser. The cartridge fits into compartment B of normal. B Powdered ...
Owners Manual - Page 6
... steam to the way garments are hand-washed in clothes.
Similar to assist in bold are available with 3-4 items, not more than 1/4 full. Small load: Fill the washer drum with each cycle. For best...combines low-speed tumbling and low-speed spin for that cycle.
Medium load: Fill the washer drum up to wash:
Cycle: Wash/Rinse
Spin
Soil Available
Temperature: Speed: Level: Options...
Owners Manual - Page 7
...denims.
Blankets/Comforters
Specialty Varies by at an extra-high speed. No clothes in washer Clean Washer
Make sure no carryover of bacteria between loads after the cycle is complete. Medium
...Hot/Cold
High
Normal
allergens. The certification verified that these cycles reduce 99.9% of the washer.
See the My Cycle and Specialty Cycle section of this guide. See the My Cycle...
Owners Manual - Page 8
... the dispenser drawer. Choose the QUICK WASH cycle and run it firmly until the latch clicks. It may require a service call. Close the washer door by pushing it without laundry
Before washing clothes for loading suggestions. IMPORTANT: n Empty pockets. See "Cycle Guide" for the first time, fill the HE liquid dispenser cartridge...
Owners Manual - Page 9
...Efficiency liquid detergents. Close fill door. The washer will not be used in the dispensers from ...loads requires use of loads will click into position.
3.
Add laundry products as shown. It will vary, depending on detergent concentration...: 1.
Powdered detergent: Add directly to the "MAX" line with HE liquid detergent. Insert the dispenser cartridge completely in...
Owners Manual - Page 10
...not fill past the MAX line. n Do not use more than 1/4 cup (60 mL) of fabric softener.
n Do not add color-safe bleach or oxi-product to this
washer. See "Cycle Guide" ... desired)
Oxi-type boosters or color-safe bleach can be added to the drum prior to adding laundry.
7.
They will appear in this dispenser. Overfilling could cause garment damage. do not guess.
Always...
Owners Manual - Page 11
...additional options
If you will delay the start of the dispenser cartridge is selected, the washer will show the default settings for available settings.
10.
Use the and arrow keys ...12. Press and hold START/PAUSE
to set a delayed Start:
1. The washer door will unlock once the washer movement has stopped. Press START/PAUSE once; Press and hold again to start time...
Owners Manual - Page 13
... PRECISION DISPENSE ULTRA CARTRIDGE
It is complete, it will proceed to avoid damaging product over time.
3. To keep washer interior odor-free, follow this recommended cleaning procedure at least once a month:
1. Make sure laundry drum is not dishwasher safe.
13 If START/ PAUSE or POWER is pressed before the cycle is recommended...
Owners Manual - Page 14
WASHER MAINTENANCE
CLEANING THE DISPENSER
You may find laundry product residue leftover in warm, soapy water, using a mild detergent.
5. To ... down area thoroughly with a dry cloth and let the washer interior air dry with the dilute solution, using the procedure that follows. Open the washer door and remove any clothing or items from the washer.
2. Pull dispenser drawer out until it stops. 2. ...
Owners Manual - Page 15
... load.
15 Because some water may stay in washer or reconnect power. 3. Unplug power cord. 5. Turn off water supply to washer to avoid flooding due
to locate, level, and
connect washer. 2. Place inlet hoses and drain hose inside washer basket. 6. Washer must be moved during freezing weather, winterize your washer only when you are home. Refer to Installation...
Owners Manual - Page 17
... solutions suggested here or visit our website at www.whirlpool.com/help for leaks (laundry tubs, drain pipe, water pipes, and faucets.)
Clean the door seal. Fill hoses not attached tightly. Fill hose washers missing. Refer to begin cycle. See "Washer Maintenance."
See the instructions above to possibly avoid a service call an electrician.
If the...
Dimension Guide - Page 1
...76 mm)
24 in.2 (155 cm2)
1" (25 mm)
1" (25 mm)
Recessed area or closet installation (stacked washer and dryer):
6" (152 mm)
3" (76 mm)
771/2"
(1969 mm)
48 in.2 (310 cm2)
Custom cabinet installation:... numbers on front page of washer. (Additional hoses might be purchased separately. or 20-amp, fused electrical supply is recommended that may be needed.)
Laundry tub drain system
41/2" (...
Installation Instructions - Page 2
... Part Number 285834 Connector Kit (x2) Part Number 285835 Extension Drain Hose Part Number 285863
Alternative Inlet Hoses:
(may require additional parts. Beaded tie strap
Inlet hoses (2) with washers
Drain hose with clamp and form (may be required for some installations, not supplied with washer) Your installation may be shipped unassembled)
Transport bolt hole plugs (4)
Flashlight...
Installation Instructions - Page 4
DRAIN SYSTEM
Drain system can be purchased separately. Top of washer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub.
Minimum siphon break height: 28" (710 mm) from bottom of laundry tub must be needed . install no higher than 96 inches, a sump pump and associated hardware are needed .)
See...
Installation Instructions - Page 6
...later date, call your local service center to center of drain hose onto drain port and secure with separate directions.
NOTE: If washer is not already in place on cabinet back with four transport bolt... Attach drain hose to step 9. Place power cord over end of drain hose, slide it between the ribs, as shown in rear panel and close hole with a 13 mm (1/2") wrench. For a laundry tub or ...
Installation Instructions - Page 7
... must be supplied to prevent clogs. Place drain hose in standpipe
Drain hose form
4.5" (113 mm)
Place hose into standpipe (shown in attaching hoses to inlet valves. do not force excess hose into a laundry tub, drainpipe, or bucket to the washer.
10. Use pliers to hot water faucet. Attach hose to tighten couplings an additional two-thirds turn...
Installation Instructions - Page 8
..., repeating as shown in firm contact with a red ring. A small amount of washer
place level here
Attach hot water hose to hot water inlet valve marked with floor, go to laundry tub leg, drain standpipe, or inlet hoses for leaks. If washer rocks, go to check for wall standpipe with cold water inlet valve. If...
Installation Instructions - Page 9
... to turn the leveling foot clockwise to lower the washer or counterclockwise to prop washer with the floor. q Check that both hot and cold hoses are attached and water faucets are now installed.
q Check that washer is plugged into a grounded 3 prong outlet
Jam nut
When washer is not level, use a 9/16" or 14 mm open...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dispensers not working correctly - Front-load Duet Sport washer
... dispense early: Do not fill past the Max fill lines on the dispenser. Are the additives dispensing too early?...;" href="#"> Lookup Model # Answers others found helpful Dispensers not working correctly - Is the dispenser drawer clogged? Manually remove the dispenser... the start of the cycle. Find Manuals & Steam washer Leaking water - Is water left in the dispenser compartment at... -
Dispensers not working correctly - Duet® Steam washer
...overfilled. Do not fill past the Max fill lines on the dispenser. Overfilling can cause the laundry products (detergent, fabric softener, liquid chlorine bleach... can leak onto the floor. Are the laundry products dispensing too late? Steam washer Dispensers not working correctly - Check that the laundry products (detergent, fabric softener, liquid chlorine bleach,... -
Washer continues to fill or continues to drain - Top-load HE washer with Dispensers in Corners
... to fill or continues to flow. How the washer drains Is the drain hose extending more than the minimum height of the washer. The drain hose may be loose, yet secure. Is top of drain hose in the drainpipe or laundry tub. Drain hose form Is the drain hose taped onto the drainpipe? There must be a gap...
Similar Questions
Find A Pedestal That Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
(Posted by tom63524 6 years ago)
Washer - Dryer Purchased At Lowes
I have a Whirlpool Cabrio Platinum Washer-Dryer set purchased there and am trying to verify approxim...
I have a Whirlpool Cabrio Platinum Washer-Dryer set purchased there and am trying to verify approxim...
(Posted by tmurphy223 7 years ago)
How To Operate Wfw97hex? How Do You Hook Up The Water Hose In The Back/
Water is comeing out the back of my washer where there is no hose.
Water is comeing out the back of my washer where there is no hose.
(Posted by gljohnson6612 10 years ago)
