Whirlpool WFW9600TA Support Question
Whirlpool WFW9600TA Support Question
Find answers below for this question about Whirlpool WFW9600TA - Duet Steam - 27in Front-Load Washer.Need a Whirlpool WFW9600TA manual? We have 1 online manual for this item!
Question posted by herbif on June 5th, 2014
Whirlpool Wfw9600ta01 Front Load Washer Will Not Fill Enough Water In The Tub.
Where is the control for water inlet located and how can i adjust it so that the water level is higher? I have checked the lines and there is no clog in the water lines.
Current Answers
Answer #1: Posted by Odin on June 5th, 2014 8:02 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WFW9600TA Manual Pages
Use and Care Guide - Page 3
...tub or agitator is moving.
■ Do not install or store the washer where it will follow instructions.
These substances give off vapors that you understand and have been previously cleaned in, washed in, soaked in, or spotted with controls... have the skills to reduce the chance of others . If the hot water system has not been used near children. machine, turn on all safety ...
Use and Care Guide - Page 4
.... If You Have
You Will Need to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system ...Water faucets
2 longer water fill hoses:
beyond reach of different heights separately for installation Open end wrenches 17 mm and 13 mm
Level...water inlet hoses
Pliers (that open to 19⁄16" [39.5 mm])
Flashlight (optional)
Tools needed for this washer. If you purchased your washer...
Use and Care Guide - Page 5
...)
Installation clearances ■ The location must be large enough to allow the washer door
to the washer.
39" min. (99.0 cm)
■ A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
■ If you live in a basement, laundry room, closet, or recessed...
Use and Care Guide - Page 6
....8 cm)
30" min. (76.2 cm)
A
B
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. Standpipe drain...laundry tub must be at least 30" (76.2 cm) high and no less than 96" (2.4 m) from the bottom of 2" (5 cm). Recommended installation spacing for recessed or closet installation, with stacked washer... washer can be a minimum of 28" (71 cm) from...
Use and Care Guide - Page 9
...
the beaded strap provided. (See illustrations A and B.)
Laundry tub drain or standpipe drain Connect the drain hose form to the drain hose at the point where the corrugation begins. A
B
C
If the washer faucets and the drain standpipe are found. Tightly wrap the beaded strap around the water inlet hoses and the drain hose. Route the...
Use and Care Guide - Page 11
... front onto the center of all the laundry products before they touch any garments. Two sensors determine load size, load composition, and suds level, then the sensors adjust the water level to assure thorough rinse-out and mixture of the load, providing even distribution and optimum cleaning performance.
This eliminates guesswork. This washer allows a 4-8 minute period in and mixed...
Use and Care Guide - Page 12
...laundry according to use less detergent based on the handle. Place a load of fabric. Washer door should close easily. When unloading garments, occasionally check...Washer
WARNING
First Wash Cycle Without Laundry
Before washing clothes for small items.
2. This initial cycle serves to produce the right amount of the tub...a medium-size load. This wash system, along with less water, will use...
Use and Care Guide - Page 13
... on load size. The display shows the estimated time remaining. See "Cycles."
5. Select and hold START for the selected cycle. The washer powers down the washer manually ...laundry products directly into the wash tub. Chlorine bleach compartment
F. The oxygen based stain fighter / color-safe bleach will be removed from the washer as soon as Water Temp, Spin Speed, and Soil Level...
Use and Care Guide - Page 14
... has started
1. Select the desired Options or modifiers such as Water Temp,
Spin Speed, and Soil Level. The washer powers down, the door unlocks, and clothes can be changed ... To cancel a cycle and select a new cycle
1. Select desired cycle. 4. Press START (for load size. The detergent type selector (A) must always be removed. Detergent type selector
Chlorine bleach compartment (Letter ...
Use and Care Guide - Page 15
... in the cycle and adjust the Estimated Time Remaining display. This will automatically sense the progress in which portion of bacteria between loads after the cycle is complete, and then the washer shuts off .
15 Controls Lock/Unlock
The Controls Lock avoids unintended use of your water pressure, water temperature, detergent, and clothes load. You can be reset...
Use and Care Guide - Page 16
...the Normal/Casual Cycle. See chart.
Cycle
Clean Washer
Soil Level (cycle time)
N/A (0:67)
Water Temp N/A
Spin Speed N/A
Soak
Normal (0:30)...The preset settings will warm the water to thoroughly saturate your laundry.
This cycle combines fast-speed ... water temperature is followed by turning the Cycle Control knob to maintain load balance. Cycle
Soil Level (cycle time)
Water ...
Use and Care Guide - Page 17
...laundry, and a soaking time without drum movement improve the removal of your wash load. For example, Deep Clean cannot be momentary pauses.
Use mesh garment bags to wash sheer fabrics and lingerie. This cycle uses a higher water level... to clean washable silk garments. (Check label instructions to help remove small spots of normal washer operation. Drain without spinning to some...
Use and Care Guide - Page 18
... then select START. If a modifier is unavailable with Steam is automatically set your model. To change the water temperature, select the WATER TEMP button until the desired setting glows green. When ...the CLEAN WASHER RESET button. In cold climates, a warm rinse makes the load more comfortable to select Loud, Soft, or Off.
Use the warmest wash water safe for heavily soiled loads that you...
Use and Care Guide - Page 19
... to wash small loads of exercise wear or other rinse temperatures are the options available to each of these washer cycles. 6TH SENSE™ Technology
The 6TH SENSE™ Technology control electronically senses and maintains a uniform water temperature. 6TH SENSE™ Technology control regulates incoming hot and cold water. 6TH SENSE™ Technology control is automatically turned...
Use and Care Guide - Page 20
...in the washer basket ...check under the gray colored seal at the front of detergent to use. LAUNDRY TIPS
Preparing clothes for washing Follow these recommendations to help you are made to avoid scratching the washer... balanced load it is...washer after the...water...load evenly. ... washer ...Loading
Loading suggestions
Heavy Work Clothes
4 jeans 4 ... towels
14 washcloths
Mixed Load
3 sheets (1 king,...
Use and Care Guide - Page 21
... procedure that uses higher water volumes and steam, in the wash drum. Close the washer door and dispenser ...washer, "rL" (remove load) will be displayed, and the WASH and CONTROLS LOCKED lights will not immediately stop the cycle. NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle will proceed to allow for other items are detected in some inlet water...
Use and Care Guide - Page 22
... the Dispenser." Replace the inserts and return the dispenser to locate, level, and connect the washer. 2. Water Inlet Hoses
Replace inlet hoses after 5 years of use or vacation care: Operate your washer during freezing weather, put in washer or reconnect power. 3. Turn off both water faucets. 5. Shut off both water faucets. Do not remove ground prong. Disconnect the drain...
Use and Care Guide - Page 23
... into a grounded 3 prong outlet? Do not remove ground prong.
Washer won 't start
WARNING
Electrical Shock Hazard Plug into a grounded 3 prong outlet? Are the hot and cold water faucets turned on ? Are the water inlet valve screens clogged? Turn off the water and remove inlet hoses from shutting completely. Check electrical source or call for service. Are you that...
Use and Care Guide - Page 24
...evenly distribute your water colder than 96" (2.4 m) above the floor?
Are the inlet hose connections tight?
Dispensers clogged or leaking
Are the laundry products in the...laundry in the upper position when using AFFRESH™ washer cleaner on load
Did you washing items with liquid detergent. For inlet hose connections, see "Connect the Inlet Hoses." Select a cycle with a higher...
Use and Care Guide - Page 25
... loads. Did you properly sort the load?
In this cycle, wash time will not operate correctly with Steam option? Stains on load
Did you add detergent to reduce wrinkling. Did you wash a large load ...do you use Quick Wash for the load being washed? Is the hot water inlet set to the washer drum. Did you have hard water? Use more detergent for the load. Is "SUD" shown in a ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer continues to fill - Front-load washer
...the drainpipe (standpipe) or laundry tub. Guides: /shared.whirlpoolcorp.com/service/modelnumber.jsp','modelnumber',500,480);return false;" href="#"> Lookup Model # Washer continues to fill - Front-load washer Anti-flood hoses and controls Washer continues to drain - Front-load washer Leaking water - Top-load washer Washer not draining, not spinning out water; Is the drain hose... -
Washer continues to drain - Front-load washer
... the appropriate length of water can siphon back into the drainpipe? Front-load washer Washer continues to flow through. Top-load washer with tape. Front-load washer Is the drain hose extending more than 8"(20.3 cm) into the washer if the drain hose extends too far down inside the drainpipe (standpipe) or laundry tub. Is the drain hose... -
Washer continues to fill - Front-load washer
... hose form (as it fills. the water will continue to drain - Front-load washer Washer continues to fill or continues to drain out of water can siphon back into the drainpipe or laundry tub. Washer continues to fill - Is top of 30" (76.2 cm)? Top-load washer Washer not draining, not spinning out water; Check that the drain hose does not...
Similar Questions
Capacity Of Whirlpool Duet Washer Model Wfw9609ta01?
what is the capacity of the Whirlpool Duet Washing Machine model WFW9600TA01
what is the capacity of the Whirlpool Duet Washing Machine model WFW9600TA01
(Posted by fayspanos 3 years ago)
Whirlpool Duet Washer Model # Wfw9600ta00
WhatIs error code f20? How can I fix this myself?
WhatIs error code f20? How can I fix this myself?
(Posted by gelhadad 7 years ago)
How To Install Steam Hose On Whirlpool Duet Steam Washer
(Posted by davichi 10 years ago)
What Does F35 Mean? That Light Keeps Coming Up On My Whirlpool Duet Steam
(Posted by LynetteDiane 13 years ago)