Whirlpool WFW95HEXW Support Question
Whirlpool WFW95HEXW Support Question
Find answers below for this question about Whirlpool WFW95HEXW.Need a Whirlpool WFW95HEXW manual? We have 5 online manuals for this item!
Question posted by russbarnes on May 30th, 2014
Do I Need To Drain My Wfw95hexw Whirlpool Front Loader. If So How?
I own the WFW95HEXW front loading whirlpool. I have read the manuals but need to know if I need to drain it. We have had it for 3 years no issues to report. If so, how do i do this?
Current Answers
Related Whirlpool WFW95HEXW Manual Pages
Dimension Guide - Page 1
...needed.)
Laundry tub drain system
41/2" (113 mm)
min.
30" (762 mm)
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be purchased separately. install no higher than 96" (2.44 m) from bottom of washer. W10254447 08/2010 Drain System Options
Drain...; Ref. Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS
WFW94HEX, WFW95HEX, WFW97HEX
OVERALL DIMENSIONS
Washer dimensions
51" (...
Installation Instructions - Page 2
... clamp and form (may be required for installation are in the washer basket. INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting installation.
If you have:
You will need:
Overhead sewer
Standard 20 gal. (76 L) 39" (990 mm) tall drain tub or utility sink, sump pump and connectors (available from...
Installation Instructions - Page 3
...load) of installation and servicing, and spacing for companion appliances and clearances for closet door ventilation openings which are required. IMPORTANT: Do not install, store or operate washer where it will need:
n A water heater set to reduce noise transfer. See "Washer...walls, doors, and floor moldings.
Space must support washer's total weight (with maximum slope of 20-100 ...
Installation Instructions - Page 4
..." (710 mm) from bottom of washer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Minimum diameter for floor standpipe drain system.
4 Select method you have an overhead sewer and need . Always secure drain hose with beaded tie strap. Floor standpipe drain system
41/2" (113 mm)
Laundry tub drain system
41/2" (113 mm...
Installation Instructions - Page 6
...need additional parts with attached cap.
Connect Drain Hose
7. For a floor drain, remove the preinstalled drain hose form as shown. Attach drain hose to avoid suspension and structural damage, a certified technician must properly set up washer...your local service center to drain port
Ribs
Close bolt holes on elbow end of washer. For a laundry tub or standpipe drain, go to step 9.
...
Installation Instructions - Page 7
...attached and have water flowing to the washer.
10. You may need to remove the drain hose form from the end of drain hose should run until it is connected...washers. C onnect inlet hoses to washer correctly. do not force excess hose into a laundry tub, drainpipe, or bucket to faucets or washer.
Remove drain hose form
(floor drain installations only)
Connect Inlet Hoses
Washer...
Installation Instructions - Page 8
..., go to tighten couplings an additional two-thirds turn on top edges of hose failure, replace the hoses every 5 years. Secure drain hose to washer
Level Washer
Leveling your washer properly reduces excess noise and vibration.
15. Connect inlet hoses to laundry tub leg, drain standpipe, or inlet hoses for future reference.
IMPORTANT: To reduce risk of...
Installation Instructions - Page 9
....
Repeat as needed. HELPFUL TIP: You may want to prop washer with the floor, use a 9/16" or 14 mm open -end or adjustable wrench to prop up front of washer.
18.
If...load.
9 q Dispose of your tools. q To test and clean your Washer Use and Care
Guide. HELPFUL TIP: You may want to turn jam nuts clockwise on leveling feet tightly against washer cabinet.
q Read "Using Your Washer...
Energy Guide - Page 1
Clothes Washer Capacity: Standard
Whirlpool Corporation Model: WFW95HEX* Cat. H1YLAA0A(4C)
Estimated Yearly Operating Cost
(when used with an electric water heater)
$18 ▼
$10
$71
Cost Range of Similar Models
169 kWh
Estimated Yearly Electricity Use
$12
Estimated Yearly Operating Cost
(when used with a natural gas water heater)
Your cost will depend on your utility...
Use & Care Guide - Page 7
For small loads (3-4 items) needed quickly. The Clean Washer light will flash every 30 loads to remind you may wish to set to remove excess water from the load by choosing Rinse/Drain & Spin and turning off Extra Rinse. Medium load: Fill the washer drum up to a lower setting. Large load: Fill the washer drum up to run the Clean Washer cycle...
Use & Care Guide - Page 8
...read and follow fabric care labels and laundry product instructions. First wash cycle without clothes. Close the washer door by testing stain remover products on load type and cycle, the washer can set stains into washer...more than one bag and fill bags equally. Items need to move freely for colorfastness by pushing it without laundry
Before washing clothes for the best performance. n ...
Use & Care Guide - Page 13
...load periodically for better ventilation and drying of water may take approximately 3 minutes.
7. Use mild soap and water if needed. This is empty.
2. IMPORTANT: Do not add detergent to start the cycle again.
8. The cycle will light. The door will rotate while the washer...n This washer has a tight seal to liquid chlorine bleach dispenser. Make sure laundry drum is normal...
Use & Care Guide - Page 16
... hose. Remove any clogs from drum and restart Clean Washer with AFFRESH™ cycle. Washer is not kinked, pinched, or blocked.
F5E2 (door will not lock) Washer door not locking.
If code appears again, call for load size recommendations.
"rL" (remove load) appears in washer. Remove items from drain hose. TROUBLESHOOTING
First try the solutions suggested here...
Use & Care Guide - Page 17
...could be level to drainpipe or laundry tub.
Check floor for selected cycle. Door locking or unlocking. Avoid tightly packing the load. Item or load not suitable for flexing or sagging...at www.whirlpool.com/help for an HE front load washer. If you experience
Possible Causes
Solution
Vibration or Off-Balance
Vibration, rocking, or "walking"
Feet may be in washer drain system.
...
Use & Care Guide - Page 18
...detergent.
Do not interrupt cycle. Allow the cycle to continue.
Washer not loaded as expected (cont.)
Washer won't run .
Select RINSE/DRAIN & SPIN.
Check that inlet valve screens have water flowing ... on .
Washer may be attached and have not become clogged.
TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/help for...
Use & Care Guide - Page 19
... and check for your garment.
The hose needs an air gap.
Not all settings and options are available for small items.
Drain hose extends into standpipe farther than normal....washes.
The load may not allow the washer to remove any clogs from regular detergent or using too much detergent can slow or stop draining or spinning.
A tightly packed or unbalanced load may be...
Use & Care Guide - Page 20
... too much HE detergent. If you will be on washer may need to possibly avoid a service call. Make sure hot and cold inlet hoses are not reversed. Inlet valve screens on . Washer not loaded as recommended. Always measure detergent and follow manufacture's directions based on load size and soil level.
Use cycle designed for low...
Use & Care Guide - Page 22
...expected (cont.)
Solution
Incorrect dispenser operation
Clogged dispensers or laundry products dispensing too soon. If larger loads are detected, a special suds routine automatically starts to remove...Load may be wiped out by hand, if needed. The washer will attempt to remain in this cycle, wash time will add time to redistribute the load.
Cycle time changes or Normal washer...
Use & Care Guide - Page 23
... or workmanship and is reported to Whirlpool within 30 days from ...WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need to know your authorized Whirlpool...
Warranty Information - Page 1
...LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need to province.
You must be repaired in accordance with Whirlpool...reported to repair or replace... to know your ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer continues to fill or continues to drain - Top-load HE washer with Dispensers in Corners
... continues to fill or continues to drain - Load-sensing Energy Star top-load washer with tape. How the washer drains Is the drain hose extending more than 8" (20.3 cm) into the drainpipe with agitator Not draining, not spinning out water, wet loads - Find Manuals & Washer continues to fill or continues to drain - Top-load washer Washer continues to fill or continues to... -
Detergent is on the load - Top-load washer
... powdered detergents. Was a low- Clothing that is tightly packed in the washer may need to fully rinse it will be difficult to use less detergent. Did you use in the wash. Older laundry detergent does not dissolve well in my top-load washer. Keep detergent containers closed to completely dissolve. Make sure the water level... -
Washer continues to fill - Front-load washer
... Manuals & Front-load washer Leaking water - wet loads - Is the drainpipe (standpipe) less than 8" (20.3 cm) into the drainpipe with tape. The drain hose should be loose, yet secure. There must be too far down . Check that the top of water can siphon back into the drainpipe or laundry tub. Drained water...
Similar Questions
My Whirlpool Washer Is Making A Load Clicking Sound During The Spin Cycle.
(Posted by sylviariddle13 9 years ago)
Wtw5600 Top Loader He Washer. Will Only Agitate After Hitting Pause/resume 2x
I have whirlpool WTW5600 top loader. It will go through fill stage but won't actually agitate unless...
I have whirlpool WTW5600 top loader. It will go through fill stage but won't actually agitate unless...
(Posted by site3226 10 years ago)
